Panasonic Lcd Monitor Cy Vhd9401u Operating Instructions

20
CY-VHD9401U/L
CY-VHD9401U/L
21
Installation      WARNING: Have a professional technician wire and install the product.
Professional skill and experience is required to wire and install the product. Improper installation could 
result in failure of safety equipment resulting in accident and injury. 
For safety’s sake, always ask the store from which you purchased the product to install and wire it for 
you.
E
N
G
L
I
S
H
7
Introduction
Note:
≥ The fi gure below shows installation in a simplifi ed 
way....

22
CY-VHD9401U/L
CY-VHD9401U/L
23
Installation 
(continued)
E
N
G
L
I
S
H
9
E
N
G
L
I
S
H
10
Installation Procedures
Remove the headliner from the vehicle for installation.
1
  Remove the interior headliner from the car in which the unit is to be installed while taking care not 
to damage the interior or its fi ttings.
2
 Now remove the dome light but leave its wiring in place.
5
  Use the tool such as a power drill to drill holes 
in the ceiling reinforcement crosspieces to meet 
the mounting holes on...

24
CY-VHD9401U/L
CY-VHD9401U/L
25
Installation 
(continued)
E
N
G
L
I
S
H
11
E
N
G
L
I
S
H
12
2
  Put the headliner that was removed earlier back 
in its original place.
3
  In the re-attached headliner, locate the center 
position of the base plate which has been 
attached to the reinforcement crosspieces, 
and cut out the section that will expose the 
reference holes to view.
4
  Align the guide holes in the accessory paper 
template (1) with the reference holes which 
can be seen from the section that...

26
CY-VHD9401U/L
CY-VHD9401U/L
27
Installation 
(continued)
E
N
G
L
I
S
H
13
E
N
G
L
I
S
H
14
Note:
≥ Be careful not to scratch the surface of the 
front cover when removing it.
≥ The screws you remove now will be needed 
when you re-attach it to complete installation. 
Keep them in a place where they will not be 
lost.       Caution: 
≥  Before installing the unit, be absolutely 
sure to check that the screws do not 
make any contact with the ceiling panel.
If some space is required between the 
base...

28
CY-VHD9401U/L
CY-VHD9401U/L
29
Installation 
(continued)
E
N
G
L
I
S
H
15
E
N
G
L
I
S
H
16
3
  Insert the bosses of the main unit underside in 
the base plate guide holes.
4
  Use a screwdriver to tighten the screws 
(in 6 positions) that you previously tightened 
loosely to secure fi rmly the main unit.
5
  Insert the end of the panel, and push it 
back into place as shown in the fi gure.
Secure the screws.
Note:
≥ Be careful not to scratch the surface of 
the front cover when attaching it.
1
  Connect...

30
CY-VHD9401U/L
CY-VHD9401U/L
31
Electrical ConnectionsWiring Diagram (Simple System)Accessory used for wiringNo. Item Q’ty
;Power connector  1
E
N
G
L
I
S
H
17
E
N
G
L
I
S
H
18
ACC
BATTERY 3AVTR1-INVIDEO-CONT
3 A
3 A
REMOTE-OUTVIDEO-OUT
DOOR
NEGA 
SWITCHDOOR
POSI 
SWITCH
DOOR
SWITCH
VTR output cord
L (white)
R (red) Video (yellow)To the Door switch. 
(Positive Switched only)
To the dome light switch’s 
– lead wire.
To the dome light switch’s 
+ lead wire. (White)
(Black)
(Yellow)Video control lead
To...

32
CY-VHD9401U/L
CY-VHD9401U/L
33
VTR1-IN
+
-
+
-
+
-
+
-
REAR   SPFRONT  SP
AUX1-IN
REMOTE-OUTVIDEO-CONT
REMOTE-INVIDEO-CONT
Connections:
≥ Connect this unit’s (CY-VHD9401U/
CY-VHD9401L) remote-out cord to the 
REMOTE-IN connector on the DVD changer 
(CX-DH801U, option) using an RCA cord 
(option). 
≥ Connect this unit’s (CY-VHD9401U/
CY-VHD9401L) video control lead to the DVD 
changer’s (CX-DH801U, option) video control 
lead. 
≥ For wiring, carefully read the operating 
instructions for the devices...

34
CY-VHD9401U/L
CY-VHD9401U/L
35
Electrical Connections 
(continued)
E
N
G
L
I
S
H
21
E
N
G
L
I
S
H
22
FRONT   LFRONT   RREAR   LREAR   R
+
-
+
-
+
-
+
-
CENTER
MAIN-IN REARMAIN-IN FRONT
+ -
VTR1-IN
Wiring Diagram (Advanced System) 
Example combination:
≥ In-dash monitor/receiver (CQ-VA707WEUC, 
option)≥ Digital surround processor (CY-AC300, option)≥ Power ampli er (CY-M7052, option)≥ Subwoofer  (option)
≥ Center speaker (EAB-CF2, option)≥ Video game (option)
≥ VCR, etc. (option)
Front speaker
(option)...

36
CY-VHD9401U/L
CY-VHD9401U/L
37
Avant l’installation
Environ 150 mm {5
15/16 po}*
Environ 300 mm 
{11
13/16 po} Maximum 
120°
Environ 300 mm {11
13/16 po}
Ouvrez l’unité d’af chage1 Appuyez sur la touche d’ouverture de l’af cheur 
[PUSH OPEN] jusqu’à ce que ce dernier se 
déverrouille.
  (Appuyez sur la touche d’une main tout en tenant 
l’af cheur de l’autre.)
2 Utilisez les deux mains pour ouvrir l’unité d’af chage 
jusqu’à un angle qui permet un visionnement 
confortable.Fermez l’unité d’af...

38
CY-VHD9401U/L
CY-VHD9401U/L
39
No
Pièce Schéma Qté
=Rondelle entretoise (A)
[épaisseur du matériau=
1 mm {
1/25 po}]6
>Rondelle entretoise (B)
[épaisseur du matériau=
2 mm {
2/25 po}]6
?Rondelle entretoise (C)
[épaisseur du matériau=
3 mm {
3/25 po}]6
@Sous-couvercle 1
ARondelle entretoise (D)
[épaisseur du matériau=
80 mm {33/16 po}]6
BVis [N
o 10-32 UNF, 
L=100 mm {4 po}]6
CVis (pour résine)
[2,6 mm {
1/10 po} ‡k
8 mm {
8/25 po}]6
Guide d’installation      MISE EN GARDE : ≥  Utilisez l’appareil dans...