Panasonic Kx Tge210 Operating Instructions Manual

Troubleshooting
I f you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again. General use
Problem Cause/solution
The handset does not turn on
e
 ven after installing charged
batteries. R
Place the handset on the base unit or charger to turn on
the handset.
The unit does not work. RM
ake sure the batteries are...

Battery recharge
Problem Cause/solution
The handset beeps and/or  flashes.
R
Battery charge is low. Fully charge the batteries (page 11).
I fully charged the batteries, but
–  still flashes,
–  is displayed, or
–

the operating time seems to be shorter. R
C
lean the battery ends ( ,  ) and the charge contacts
w
ith a dry cloth and charge again.
R It is time to replace the batteries (page 10). Making/answering calls, intercom
Problem Cause/solution
 is displayed.
R
T
he handset is too far from the base...

Caller ID/Talking Caller ID
Problem Cause/solution
Caller information is not
d isplayed. R
You must subscribe to Caller ID service. Contact your
service provider/telephone company for details.
R If your unit is connected to any additional telephone
equipment such as a Caller ID box or cordless telephone
line jack, plug the unit directly into the wall jack.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL...

Problem Cause/solution
The 2nd caller’s information is
n ot displayed during an outside
call. R
In order to use Caller ID, call waiting, or Call Waiting
Caller ID (CWID), you must first contact your service
provider/telephone company and subscribe to the desired
service.
After subscribing, you may need to contact your service
provider/telephone company again to activate this specific
service, even if you already subscribed to both Caller ID
and Call Waiting with Caller ID services (CWID). Answering...

Liquid damage
Problem Cause/solution
Liquid or other form of moisture
h as entered the handset/base
unit. R
Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service center. Caution:
R
T

o avoid permanent...

FCC and other information
56
For assistance, please visit http://www.panasonic.com/helpUseful InformationTGE21x23x24x(en)_1122_ver031.pdf56   562013/11/22   14:22:30This equipment complies with Part 68 of the 
FCC rules and the requirements adopted by 
the ACTA. On the bottom of this equipment 
is a label that contains, among other 
information, a product identifier in the 
format US:ACJ----------.
If requested, this number must be provided 
to the telephone company.
L Registration No.............(found...

For assistance, please visit http://www.panasonic.com/help
57Useful InformationTGE21x23x24x(en)_1122_ver031.pdf57   572013/11/22   14:22:30manufacturer about the availability of 
Hearing Aids which provide adequate 
shielding to RF energy commonly emitted 
by digital devices.
WHEN PROGRAMMING EMERGENCY
NUMBERS AND(OR) MAKING TEST
CALLS TO EMERGENCY NUMBERS:
1) Remain on the line and briefly explain to 
the dispatcher the reason for the call.
2) Perform such activities in the off-peak
hours, such as early...

58
For assistance, please visit http://www.panasonic.com/helpUseful InformationTGE21x23x24x(en)_1122_ver031.pdf58   582013/11/22   14:22:30Compliance with TIA-1083 standard: 
Telephone handsets identified with this logo 
have reduced noise and interference when 
used with T-Coil equipped hearing aids and 
cochlear implants.
T
Compatible with
Hearing Aid T-Coil
TIA-1083  

Guía Rápida Española
Para obtener ayuda, visite http://www.panasonic.com/help (solo en inglés)
59Guía Rápida Española TGE21x23x24x(en)_1122_ver031.pdf59   592013/11/22   14:22:30Conexiones
Unidad base
1 Conecte el adaptador de corriente alterna a la unidad presionándolo firmemente.2 Enganche el cable para fijarlo.3 Conecte el adaptador de corriente alterna a la toma de corriente.4 Conecte el cable de la línea telefónica a la unidad, y después a la toma telefónica de una sola línea 
(RJ11C) hasta que...

60
Para obtener ayuda, visite http://www.panasonic.com/help (solo en inglés) Guía Rápida EspañolaTGE21x23x24x(en)_1122_ver031.pdf60   602013/11/22   14:22:30Instalación y carga de la batería
Cargue aproximadamente durante 7 horas.
Nota:LUTILICE SOLO baterías recargables de Ni-MH tamaño AAA (R03) ( ).LNO utilice baterías Alcalinas, de Manganeso o de Ni-Cd.LConfirme que las polaridades estén correctas (S, T).LCambie el idioma de la pantalla.LConfirme que aparezca “Cargando”      
Sugerencias de operación...