Panasonic Kx Tg6431 Operating Instructions Manual

Intercom/Locator
41For assistance, please visit http://www.panasonic.com/help
■To establish a conference call:
Base unit:
Press  {CONF }.
L To leave the conference, press 
{SP-PHONE }. Other parties 
can continue the conversation.
L To put the outside call on hold, 
press  {HOLD }. To resume the 
conference, press  {CONF }.
TG643x(e).book  Page 41  Monday, December 1, 2008  10:13 AM 

Useful Information
42For assistance, please visit http://www.panasonic.com/help
Belt clip
Wall mounting
Base unit
1
Lead the AC adaptor cord and 
telephone line cord through the hole 
in the wall mounting adaptor in the 
direction of the arrow.
2Tuck the telephone line cord inside 
the wall mounting adaptor (A). 
Connect the AC adaptor cord and 
telephone line cord ( B).
3Insert the hooks on the wall 
mounting adaptor into holes  1 and 
2  on the base unit.
4Adjust the adaptor to hold the base 
unit,...

Useful Information
43For assistance, please visit http://www.panasonic.com/help
5Connect the telephone line cord. 
Mount the unit by inserting the 
mounting pins into the round 
openings on the adaptor (for pin 2, 
use the round cut out at the bottom 
of the adaptor if you are using the 4 
inch phone plate), then slide the unit 
down to secure it. Connect the AC 
adaptor to power outlet (page 9).
L There are 2 common types of wall 
phone plates. The distance 
between  1 and 2  may vary 
depending on the...

Useful Information
44For assistance, please visit http://www.panasonic.com/help
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display messageCause/solution
Busy
or
System busy. Try again 
later. L
The called unit is in use.
L Other units are in use and the system is busy. 
Try again later.
L The handset you are using is too far from the 
base unit. Move closer and try again.
L The handset’s registration may have been 
canceled. Re-register the...

Useful Information
45For assistance, please visit http://www.panasonic.com/help
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect 
the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the 
batteries from the handset, and then insert the batteries into the handset again.
General use
Programmable settings
ProblemCause/solution
The unit does not work. LMake sure the batteries are installed correctly 
(page 9).
L Fully charge...

Useful Information
46For assistance, please visit http://www.panasonic.com/help
Battery recharge
Making/answering calls, intercomI cannot register a handset 
to a base unit.
L
The maximum number of handsets (6) is already 
registered to the base unit. Cancel unused 
handset registrations from the base unit (page 27).
L Place the handset and the base unit away from 
other electrical appliances.
ProblemCause/solution
The handset beeps and/or 
)  flashes. L
Battery charge is low. Fully charge the batteries...

Useful Information
47For assistance, please visit http://www.panasonic.com/help
Caller ID/Talking Caller IDThe handset and/or base 
unit does not ring.
L
The ringer volume is turned off. Adjust the ringer 
volume (page 15, 23).
L Silent mode is turned on. Turn it off (page 25).
I cannot make a call. LThe dialing mode may be set incorrectly. Change 
the setting (page 13).
L The handset is too far from the base unit. Move 
closer and try again.
I cannot make long 
distance calls. L
Make sure that you have...

Useful Information
48For assistance, please visit http://www.panasonic.com/help
*1 KX-TG6441 series: page 3
Answering systemCaller information is 
displayed or announced 
late.
L
Depending on your service provider/telephone 
company, the unit may display or announce the 
caller’s information at the 2nd ring or later.
L Move closer to the base unit.
The caller list/incoming 
phone numbers are not 
edited automatically. L
The Caller ID number auto edit feature is turned 
off. Turn it on and try again (page...

Useful Information
49For assistance, please visit http://www.panasonic.com/help
Liquid damage
Caution:
LTo avoid permanent damage, do not use a microwave oven to speed up the drying 
process.
I cannot operate the 
answering system.
L
Someone is using the unit. Wait for the other user 
to finish.
L A caller is leaving a message. Wait for the caller to 
finish.
L The handset is too far from the base unit. Move 
closer.
I cannot operate the 
answering system 
remotely. L
You are entering the wrong remote...

Useful Information
50For assistance, please visit http://www.panasonic.com/help
FCC and other information
This equipment complies with Part 68 of the 
FCC rules and the requirements adopted by 
the ACTA. On the bottom of this equipment 
is a label that contains, among other 
information, a product identifier in the 
format US:ACJ----------.
If requested, this number must be provided 
to the telephone company.
L Registration No.............(found on the bottom of the unit)
L Ringer Equivalence No....