Panasonic Kx Tg2335 Operating Instructions Manual

Useful Information
For assistance, please call: 1-800-211-PANA(7262)51
Wall Mounting
This unit can be mounted on a wall phone plate.
1Push the hook and turn it 
upward. Turn the hook until a 
click is heard.
2Press the tabs in the direction 
of the arrows (1), then remove 
the wall mounting adaptor (2). 
3Connect the AC adaptor. Tuck 
the telephone line cord inside 
the wall mounting adaptor, then 
push the adaptor in the direction 
of the arrows (1 and 2).
• The word “UP WALL” should face 
upward.
•...

52
Optional Headset
Connecting an optional headset to the handset allows hands-free phone 
conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88, 
KX-TCA88HA, KX-TCA91, KX-TCA92, or KX-TCA98 headset. To order, call the 
accessories telephone number on page 2.
Connecting an optional headset
Open the headset jack cover, and insert the headset plug into the headset jack as 
shown below. 
• Headset sold separately. Model shown here is KX-TCA88.
To switch to the speakerphone while using the...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)53
Direct Commands
After pressing [MENU], you can also program menu items directly by pressing ([0] 
to [9], [*] and [#]) instead of using the soft keys.
Menu item Command Selection items Page
Ringer volume[1] [1]  [0] : Off  [1] : Low  [2] : Medium   
[3] : Highp. 15
Ringer tone 
(for handset)[1] [2] [1]–[3] : Tone pattern 1 – 3
[4]–[7] : Melody pattern 1 – 4p. 16
Incoming call tone 
(for handset)[1] [3]  [1] : On  [2] : Twice  [0] :...

Direct Commands
54
During programming:
When “Save” is displayed, press the right soft key to save the new settings.
To exit programming, press [OFF].
• If you press the direct command incorrectly, press [OFF], then re-enter 
programming mode by pressing [MENU].
• For function details, see the corresponding pages.
Ringer tone 
(for base unit)[0] [*] [1] [1]–[3] : Tone pattern 1 – 3
[4]–[7] : Melody pattern 1 – 4p. 17
Incoming call tone
(for base unit)[0] [*] [2] [1] : On  [2] : Twice  [0] : Off p. 48...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)55
If the Following Appear on Your Display...
The following will be displayed when the unit needs your attention.
Display message Cause & Remedy
Recharge battery• The battery needs to be charged. Recharge the 
battery (p. 10).
Charge for 6h• The battery has been discharged. The handset will 
not work. Fully charge the battery (p. 9).
No link to base.
Move closer to 
base, try again.• The handset has lost communication with the base...

56
Troubleshooting
If the handset display shows error messages, see “If the Following Appear on 
Your Display...” (p. 55) for the Cause & Remedy.
Problem Cause & Remedy
“No link to base. Move 
closer to base, try 
again.” is displayed and an 
alarm tone sounds.• You are too far from the base unit. Walk 
closer to the base unit.
• Confirm the base unit’s AC adaptor is 
plugged in.
• Raise the base unit antenna.
• If the above remedies do not solve the 
problem, the handset may have lost 
communication...

For assistance, please call: 1-800-211-PANA(7262)57
Troubleshooting
Useful Information
You cannot redial. • If the last number dialed was more than 
48 digits long, the number will not be redialed 
correctly.
You cannot make long 
distance calls.• Please make sure you have long distance 
service.
The handset does not display 
the caller’s name and/or 
phone number.• You need to subscribe to Caller ID.
• Other telephone equipment may be 
interfering with your phone. Disconnect it and 
try again.
• Other...

Troubleshooting
58
“Recharge battery” is 
displayed, “7” flashes, or 
the handset beeps 
intermittently.• Fully charge the battery (p. 9).
“Charge for 6h” and “8” 
are displayed and the handset 
does not work.• The battery has been discharged. Fully 
charge the battery (p. 9).
• Check battery installation (p. 9).
You charged the battery fully, 
but “Recharge battery” is 
still displayed and/or “7” 
continues to flash, or “Charge 
for 6h” and “8” are 
displayed.• Clean the charge contacts and charge again...

Useful Information
For assistance, please call: 1-800-211-PANA(7262)59
Important Safety Instructions
When using this unit, basic safety precautions should always be followed to reduce 
the risk of fire, electric shock, or personal injury.
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on this unit.
3. Unplug this unit from AC outlets before cleaning. Do not use liquid or aerosol 
cleaners. Use a damp cloth for cleaning.
4. Do not use this unit near water, for...

60
Important Safety Instructions
CAUTION:
To reduce the risk of fire or injury to persons, read and follow these instructions.
1. Use only the battery(ies) specified.
2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local 
waste management codes for special disposal instructions.
3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and 
may cause burns or injury to the eyes or skin. The electrolyte may be toxic if 
swallowed.
4. Exercise care in...