Panasonic KX MB773 User Manual

1. Introduction and Installation
11
1.2 Accessory information
To ensure that the unit operates properly, we 
recommend the use of a Panasonic toner cartridge and 
drum unit. See page 94 for specifications.
1.2.1 Available accessories
–Replacement toner cartridge*1
LModel No. (Part No.): KX-FAT92E/KX-FAT92X
–Replacement drum unit
LModel No. (Part No.): KX-FAD93E/KX-FAD93X
*1 Approx. 2,000 sheets of A4 size paper can be 
printed with KX-FAT92E/KX-FAT92X.
Find in g the  Co ntrols
1.3 Button descriptions...

1. Introduction and Installation
12
M{FAX AUTO ANSWER} (KX-MB773/KX-MB783 
only)
LTo turn the auto answer setting ON/OFF (page 
48).
{POWER SAVE} (KX-MB263 only)
LTo set the unit to the power save mode manually.
N{FA X} (KX-MB773/KX-MB783 only)
LTo switch to the fax mode (page 22, 43).
O{BROADCAST} (KX-MB773/KX-MB783 only)
LTo send a document to multiple parties (page 45).
P{MANUAL BROAD} (KX-MB773/KX-MB783 only)
LTo send a document to multiple parties manually 
(page 45).
QStation keys...

1. Introduction and Installation
13
1.4.2 Rear view
* The pictured model is KX-MB783.
Removing the shipping tape
Remove the shipping tape (1).
Note:
LShipping tape positions are subject to change 
without notice.
Installation
1.5 Toner cartridge and drum unit
The included toner cartridge is a starter toner cartridge.
Caution:
LRead the following instructions before you begin 
installation. After you have read them, open the 
drum unit protection bag. The drum unit contains 
a photosensitive drum....

1. Introduction and Installation
14
3Place the toner cartridge (3) into the drum unit (4) 
vertically.
4Turn the green levers (5) on each side of the toner 
cartridge while pressing down firmly.
5Make sure that the triangles (6) match, to install the 
toner cartridge correctly.
6Lift the top cover release lever (7) and open the top 
cover (8).
Note:
LDo not touch the transfer roller (9).
LIf the lower glass (j) is dirty, clean it with a soft 
and dry cloth.
3
4
5
6
8
9
7
j...

1. Introduction and Installation
15
7Install the drum and toner unit (k) by holding the 
tabs.
LMake sure that the triangles (l) match, to install 
the drum and toner unit correctly.8Close the top cover until locked.
Caution:
LTo prevent injuries, be careful not to put your 
hands under the top cover.
To replace the toner cartridge and the drum unit
When the display shows the following, replace the toner 
cartridge.
TONER LOW
TONER EMPTY
LTo check the drum life and quality, please print the 
printer test...

1. Introduction and Installation
16
LTo maintain print quality and machine life, we 
recommend you to clean slots and openings (page 7) 
and the inside of the unit (page 88, 91) when 
replacing the toner cartridge and/or drum unit.
Waste disposal method
Waste material should be disposed of under conditions 
which meet all national and local environmental 
regulations.
Toner save feature 
If you want to reduce toner consumption, set the toner 
save setting to ON (feature #482 on page 58). The toner...

1. Introduction and Installation
17
If the top part of the extender is detached
1.With the top part of the extender in the open position, 
insert the tab (1) into the left hole (2) of the 
extender.
2.Slide the other tab (3) into the right hole (4) of the 
extender from below until it clicks into place.If the extender is detached
1.Line up the extender (1) with the left side of the 
output tray. Make sure that the triangles (2) match, 
to attach the extender correctly.
2.Snap the extender (3) into the...

1. Introduction and Installation
18
1.7 Recording paper
The paper input tray unit can hold:
– Up to 250 sheets of 60 g/m2 to 75 g/m2 paper.
– Up to 230 sheets of 80 g/m2 paper.
– Up to 200 sheets of 90 g/m2 paper.
LPlease refer to page 93 for information on recording 
paper.
LThe unit is set for printing A4 size paper by 
default. If you want to use letter or legal size 
paper, change the setting (feature #380 on page 
57).
1Pull the paper input tray (1) until it clicks into place, 
then pull it...

1. Introduction and Installation
19
5Insert the paper input tray to the unit, lifting the front 
part of the tray. Then push it completely into the unit.
Note:
LIf the paper is not loaded correctly, re-adjust the 
paper guides, or the paper may jam.
LIf the paper input tray does not close, the plate in the 
paper input tray may be lifted. Push the paper and 
make sure that the paper is laid flat in the paper input 
tray.
Caution for the paper input tray
LDo not drop the paper input tray.
LHold the paper...

1. Introduction and Installation
20
Caution:
LWhen moving the unit, be sure to hold by the 
grip. Do not hold by the handset unit.
To remove the handset unit
1.Pull the handset unit slightly forward (1), then lift it in 
the direction of the arrow (2) to remove the rib.
2.Remove the tab (3), then disconnect the handset 
connector (4). Correct Incorrect
1
2
34
MB263HX_773_783EX-PFQX2807ZC-OI-en.book  Page 20  Monday, August 6, 2007  11:42 AM
Downloaded From ManualsPrinter.com Manuals