Panasonic Kx Flm651 Operating Instruction Manual

							9. Help
69
For assistance, please visit http://www.panasonic.com/consumersupport drum unit. Remove the drum and toner unit 
(1) by holding the two tabs.
LDo not touch the transfer roller (2).
LIf you replace the toner cartridge and the 
drum unit at the same time, skip to step 7.
5Turn the two levers (1) on the used toner 
cartridge firmly, until the triangles (2) match.
6Remove the used cartridge (1) from the 
drum unit (2).
LThe toner may stick to the cartridge and 
the drum unit. Be careful when handling. 
See page 4 for details.
LDo not drop the toner on the green drum 
surface (3).
LPut the used toner cartridge into the 
protection bag.
7If you replace the drum unit at the same time, 
remove the new drum unit from the 
protection bag.
Place the new toner cartridge (1) into the 
drum unit (2) vertically.
1
2
1
2
1
2
3
1
2
FLM651-PFQX2292ZA-en.book  Page 69  Monday, September 12, 2005  2:22 PM 
						

							9. Help
70
For assistance, please visit http://www.panasonic.com/consumersupport
8Firmly press down the toner cartridge to 
snap into position.
9Turn the two levers (1) on the toner 
cartridge firmly.
10Make sure that the triangles (1) match, to 
install the toner cartridge correctly.
LIf the lower glass (2) is dirty, clean it with 
a soft and dry cloth.
11Install the drum and toner unit (1) by holding 
the tabs.
12Close the front cover (1) by pushing down 
on both sides, until locked.
LWhile the unit displays “PLEASE WAIT”, 
do not open the front cover, or disconnect 
the power cord.
Waste disposal method
Waste material should be disposed of under 
conditions which meet all national and local 
environmental regulations.
1
1
2
1
1
FLM651-PFQX2292ZA-en.book  Page 70  Monday, September 12, 2005  2:22 PM 
						

							9. Help
71
For assistance, please visit http://www.panasonic.com/consumersupport
Jams
9.5 Recording paper jam
The display will show the following.
PAPER JAMMED
9.5.1 When the recording paper 
has jammed near the drum and 
toner unit
1Lift open the front cover (1), holding OPEN 
(2).
2Remove the jammed paper (1) carefully by 
pulling it toward you.
LDo not touch the transfer roller (2).
3Close the front cover (1) by pushing down 
on both sides, until locked.
9.5.2 When the recording paper 
has jammed near the recording 
paper exit
1Lift open the front cover (1), holding OPEN 
(2).
Caution:
The fuser unit (3) gets hot. Do not 
touch it.
1
2
3
1
2
Caution:
The fuser unit (3) gets hot. Do not 
touch it.
1
1
2
3
FLM651-PFQX2292ZA-en.book  Page 71  Monday, September 12, 2005  2:22 PM 
						

							9. Help
72
For assistance, please visit http://www.panasonic.com/consumersupport
2Remove the paper tray cover (1).
3Remove the recording paper (1), then 
remove the drum and toner unit (2) to allow 
the jammed paper (3) to pull free from the 
rear cabinet.
4Lift both green levers (1) forward until they 
stop.
5Remove the jammed paper (1) from the 
fuser unit by pulling it upwards carefully, then 
install the drum and toner unit.
6Push back the levers (1) to the original 
position.
7Close the front cover (1) by pushing down 
on both sides, until locked.
8Pull the tension plate forward (1), then re-
insert the recording paper (2).
1
1
2
3
1
1
1
1
FLM651-PFQX2292ZA-en.book  Page 72  Monday, September 12, 2005  2:22 PM 
						

							9. Help
73
For assistance, please visit http://www.panasonic.com/consumersupport LBefore re-inserting, make sure to fan and 
straighten the recording paper.
9Attach the paper tray cover (1), then push 
back the tension plate (2).
9.5.3 When the recording paper 
is not fed into the unit properly
The display will show the following.
CHECK PICK UP
1Pull the tension plate forward (1), then 
remove the paper tray cover (2). Remove 
the recording paper (3).
2Re-insert the recording paper. Attach the 
paper tray cover, then push back the tension 
plate (see steps 7 to 8 on page 18).
LBefore re-inserting, make sure to fan and 
straighten the recording paper.
2
1
2
1
2
1
3
FLM651-PFQX2292ZA-en.book  Page 73  Monday, September 12, 2005  2:22 PM 
						

							9. Help
74
For assistance, please visit http://www.panasonic.com/consumersupport
9.6 Document jams - 
sending
1Lift open the front cover (1), holding OPEN 
(2).
2Hold the center part of the front cover (1), 
and pull open the inner cover (2).
LDo not touch the transfer roller (3).
3Remove the jammed document carefully 
(1).
4Push back the inner cover.
5Close the front cover (1) by pushing down 
on both sides, until locked.
Note:
LDo not pull out the jammed document forcibly 
before opening the front cover. Caution:
The fuser unit (3) gets hot. Do not 
touch it.
1
2
3
3
2
1
1
1
FLM651-PFQX2292ZA-en.book  Page 74  Monday, September 12, 2005  2:22 PM 
						

							9. Help
75
For assistance, please visit http://www.panasonic.com/consumersupport
Clean in g
9.7 Cleaning the inside of 
the unit
Clean the inside of the unit when:
– Documents frequently misfeed.
– Black line, a white line or a dirty pattern 
appear on the original document when 
sending or copying.
Caution:
LBe careful when handling the drum and 
toner unit.
See the caution for the drum unit on page 
68 for details.
LDo not use paper products, such as paper 
towels or tissues, to clean the inside of 
the unit.
1Disconnect the power cord and the 
telephone line cord.
2Lift open the front cover (1), holding OPEN 
(2).
3Clean the document separation roller (1) 
with a cloth moistened with isopropyl rubbing 
alcohol, and let all parts dry thoroughly.
4Hold the center part of the front cover (1), 
and pull open the inner cover (2).
LDo not touch the transfer roller (3).
5Clean the document feeder roller (1) with a 
cloth moistened with isopropyl rubbing 
alcohol, and let all parts dry thoroughly.
Clean the upper glass (2) with a soft and dry 
cloth.
6Push back the inner cover. Caution:
The fuser unit (3) gets hot. Do not 
touch it.
1
2
3
1
1
2
3
2
1
FLM651-PFQX2292ZA-en.book  Page 75  Monday, September 12, 2005  2:22 PM 
						

							9. Help
76
For assistance, please visit http://www.panasonic.com/consumersupport
7Remove the drum and toner unit (1) by 
holding the two tabs.
8Clean the lower glass (1) with a soft and dry 
cloth.
9Re-install the drum and toner unit (1) by 
holding the tabs.
10Close the front cover (1) by pushing down 
on both sides, until locked.
11Reconnect the power cord and the telephone 
line cord.
1
1
1
1
FLM651-PFQX2292ZA-en.book  Page 76  Monday, September 12, 2005  2:22 PM 
						

							10. General Information
77
10 General Information Printed Repo rts
10.1 Reference lists and 
reports
You can print out the following lists and reports 
for your reference.
–“SETUP LIST”:
Provides you with the current settings of the 
programming features (page 53 to page 58).
–“TEL NO. LIST”:
Provides you with names and numbers which 
are stored in the one-touch dial feature and 
navigator directory.
–“JOURNAL REPORT”:
Keeps records of fax transmission and 
reception. This report can be printed 
automatically after every 30 fax 
communications (feature #402 on page 55).
–“BROADCAST LIST”:
Provides you with names and numbers which 
are stored in the broadcast memory (page 
32).
–“PRINTER TEST”:
Allows you to check the print quality of your 
unit. If the test print has a dirty pattern, or 
blurred points or lines, clean the inside of the 
unit (page 75). If printing quality is still poor, 
replace the toner cartridge and drum unit.
1Press {MENU} repeatedly to display “PRINT 
REPORT”.
2Press {} repeatedly to display the 
desired item.
3Press {SET} to start printing.
4Press {STOP}.
{SET} {STOP} {MENU}
{}
FLM651-PFQX2292ZA-en.book  Page 77  Monday, September 12, 2005  2:22 PM 
						

							10. General Information
78
Specifications
10.2 Specifications
Applicable lines:
Public Switched Telephone Network
Document size:
Max. 216 mm (8
1/2) in width, Max. 600 mm 
(235/8) in length
Effective scanning width:
208 mm (8
3/16)
Effective printing width:
Letter/Legal: 208 mm (8
3/16)
A4: 202 mm (715/16)
Transmission time
*1:
Approx. 4 s/page (ECM-MMR)*2
Scanning density:
Fax resolution:
Horizontal: 8 pels/mm (203 pels/inch)
Vertical: 3.85 lines/mm (98 lines/inch)-in 
standard resolution,
7.7 lines/mm (196 lines/inch)-in fine/photo 
resolution,
15.4 lines/mm (392 lines/inch)-in super fine 
resolution
Copy resolution:
Up to 600 × 600 dpi
Scanning resolution:
Up to 200 × 400 dpi (Optical)
Up to 9,600 × 9,600 dpi (Interpolated)
Photo resolution:
64-level
Scanner type:
Contact Image Sensor
Printer type:
Laser Printer
Data compression system:
Modified Huffman (MH), Modified READ (MR), 
Modified Modified READ (MMR)
Modem speed:
33,600 / 31,200 / 28,800 / 26,400 / 24,000 / 
21,600 / 19,200 / 16,800 / 14,400 / 12,000 / 
9,600 / 7,200 / 4,800 / 2,400 bps; Automatic 
Fallback
Operating environment:
10 °C – 32.5 °C (50 °F – 90.5 °F), 20 % – 80 % 
RH (Relative Humidity)
Dimensions:
Approx. height 370 mm × width 430 mm × depth 
480 mm (14
9/16 × 1615/16 × 187/8)
Mass (Weight):
Approx. 9.4 kg (20.2 lb.)Power consumption:
Standby: Approx. 8 W
Transmission: Approx. 15 W
Reception: Approx. 290 W
Copy: Approx. 290 W
Maximum: Approx. 900 W (When the fuser lamp 
turns on)
Power supply:
120 V AC, 60 Hz
Fax memory capacity:
2 MB in total
Approx. 150 pages of memory transmission
Approx. 170 pages of memory reception 
(Based on the ITU-T No. 1 Test Chart in standard 
resolution.)
Laser diode properties:
Laser output: Max. 5 mW
Wave length: 760 nm – 800 nm
Emission duration: Continuous
Print speed:
Approx. 14 ppm (pages per minute)
Printing resolution:
600 × 600 dpi
*1 Transmission speed depends upon the 
contents of the pages, resolution, telephone 
line conditions and capability of the other 
party’s machine.
*2 Transmission speed is based upon the ITU-T 
No. 1 Test Chart. If the capability of the other 
party’s machine is inferior to your unit, the 
transmission time may be longer.
ITU-T No.1 Test Chart
Note:
LDesign and specifications are subject to 
change without notice.
LThe pictures and illustrations in these 
instructions may vary slightly from the actual 
product.
FLM651-PFQX2292ZA-en.book  Page 78  Monday, September 12, 2005  2:22 PM