Panasonic Kx Dt321 Information Manual

Stand Usage
Document Version 2009-03                                                                                                 11
Stand  Us ageAttaching the Stand
Place the catches ( ) of the stand into hooks located in the unit. 
Gently push the stand in the direction indicated until it locks into 
place. The stand will be mounted in the high position.
Removing the Stand
Hold the stand with both hands.
Gently rotate the stand in the direction indicated until it is released.
Cabling
When using the...

Stand Usage
12                                                                                                   Document Version 2009-03
Adjusting from High to Low Position
Hold the stand with both hands as shown and rotate the stand in 
the direction indicated until it locks into the low position ( ).
Adjusting from Low to High Position
Hold the stand with both hands as shown and rotate the stand in 
the direction indicated until it locks into the high position ( ).
B
1B
A
A1 

Wall Mounting
Document Version 2009-03                                                                                                 13
Wall Mounting1.Remove the stand if it is attached. For information on removing 
the stand, refer to page 11.
2.Drive the 2 screws (included) into the wall either 83 mm  
(3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on 
the wall.
•You can find a wall mounting 
template on page 19.
•Make sure that the wall that the 
unit will be attached to is strong...

Important Information
14                                                                                                   Document Version 2009-03
Im p ort an t In fo rm at i onWhen using a KX-DT321 DPT, keep the following conditions in 
mind.
•If you are having problems making calls, unplug the extension line and 
connect a known working telephone. If the known working telephone 
operates properly, have the defective telephone repaired by an 
authorized Panasonic factory service center. If the known...

Important Information
Document Version 2009-03                                                                                                 15
WARNING:
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT 
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
THIS HANDSET EARPIECE IS MAGNETIZED AND MAY RETAIN SMALL 
FERROUS OBJECTS.
THE USE OF EXCESSIVE SOUND VOLUME THROUGH EARPHONES, 
HEADPHONES, OR HEADSETS MAY CAUSE HEARING LOSS.
DISCONNECT THE TELEPHONE LINE CORD FROM THIS PRODUCT IF 
THIS PRODUCT EMITS SMOKE, AN...

Important Information
16                                                                                                   Document Version 2009-03
Important Safety Instructions
When using this unit, basic safety precautions, including those below, 
should always be followed to reduce the risk of fire, electric shock and injury 
to persons.
1.Read and understand all instructions.
2.Follow all warnings and instructions marked on this unit.3.Unplug this unit from the main unit before cleaning. Do not use...

Important Information
Document Version 2009-03                                                                                                 17
FCC and Other Information
F.C.C. REQUIREMENTS AND RELEVANT INFORMATIONThis equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation.
This equipment generates, uses, and...

Important Information
18                                                                                                   Document Version 2009-03
Customer Information
This equipment complies with Part 68 of the FCC rules and the 
requirements adopted by the ACTA. On the bottom of the cabinet of this 
equipment is a label that contains, among other information, the following 
product identifier:  
US: ACJKXNANKX-DT321
 If requested, this number must be provided to the telephone company.
If trouble is...

Document  Version 2009-03                                                                                                     19
WALL MOUNTING TEMPLATE
1. Drive the screws into the wall 
    as indicated.
2. Hook the unit onto the screw 
    heads.
     Note:
    Make sure to set the print size to 
    correspond with the size of this 
    page. If the dimensions of the 
    paper output still deviate slightly 
    from the measurements indicated 
    here, use the measurements
    indicated here.
100 mm...

PSQX4696ZA-UU (A) KK0309YH0 (M)
Panasonic Consumer Electronics Company,
Division of Panasonic Corporation of North America
One Panasonic Way Secaucus, New Jersey 07094
http://www.panasonic.com/csd
Copyright:This material is copyrighted by Panasonic Communications Co., Ltd., and 
may be reproduced for internal use only. 
All other reproduction, in whole or in 
part, is prohibited without the written consent of Panasonic Communications 
Co., Ltd.
© Panasonic Communications Co., Ltd. 2009