Panasonic Kx Dt321 Information Manual

							Stand Usage
Document Version 2009-03                                                                                                 11
Stand  Us ageAttaching the Stand
Place the catches ( ) of the stand into hooks located in the unit. 
Gently push the stand in the direction indicated until it locks into 
place. The stand will be mounted in the high position.
Removing the Stand
Hold the stand with both hands.
Gently rotate the stand in the direction indicated until it is released.
Cabling
When using the stand, ensure that the cords are clamped as 
shown.
A
A
Clamp 
						

							Stand Usage
12                                                                                                   Document Version 2009-03
Adjusting from High to Low Position
Hold the stand with both hands as shown and rotate the stand in 
the direction indicated until it locks into the low position ( ).
Adjusting from Low to High Position
Hold the stand with both hands as shown and rotate the stand in 
the direction indicated until it locks into the high position ( ).
B
1B
A
A1 
						

							Wall Mounting
Document Version 2009-03                                                                                                 13
Wall Mounting1.Remove the stand if it is attached. For information on removing 
the stand, refer to page 11.
2.Drive the 2 screws (included) into the wall either 83 mm  
(3-1/4 in) or 100 mm (3-15/16 in) apart, and mount the unit on 
the wall.
•You can find a wall mounting 
template on page 19.
•Make sure that the wall that the 
unit will be attached to is strong 
enough to support the unit 
(approx. 730 g [1.61 lb]).
•Make sure that the telephone 
line cords are not trapped or 
pinched against the wall.
•Make sure the cords are 
securely fastened to the wall.
•When this unit is no longer in 
use, make sure to detach it 
from the wall.
Locking the Handset Hook
Pull down the handset hook until it locks to 
prevent the handset from falling off the handset 
cradle when the unit is mounted to a wall or set at 
a high angle. To temporarily place the handset 
down during a conversation, hook it over the top 
edge of the unit as shown.
83 mm(3-1/4 in)100 mm(3-15/16 in)
Washer
Drive the screw
to this point. 
						

							Important Information
14                                                                                                   Document Version 2009-03
Im p ort an t In fo rm at i onWhen using a KX-DT321 DPT, keep the following conditions in 
mind.
•If you are having problems making calls, unplug the extension line and 
connect a known working telephone. If the known working telephone 
operates properly, have the defective telephone repaired by an 
authorized Panasonic factory service center. If the known working 
telephone does not operate properly, check the PBX and the internal 
extension wiring.
•Wipe the unit with a soft cloth. Do not clean the unit with abrasive 
powders or with chemical agents such as benzene or thinner.
•Use only the correct Panasonic handset.
•Do not disassemble this unit. Dangerous electrical shock could result. 
The unit must only be disassembled and repaired by qualified service 
technicians.
•If damage to the unit exposes any internal parts, immediately disconnect 
the cable or cord.
•Never attempt to insert wires, pins, etc. into the vents or other holes of 
this unit.
Take special care to follow the safety suggestions listed 
below.
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl 
or sink. Damp basements should also be avoided.
2) Keep the unit away from heating appliances and devices that generate 
electrical noise, such as fluorescent lamps, motors, and televisions. 
These noise sources can interfere with the performance of the unit. It 
also should not be placed in rooms where the temperature is less than 
5 °C (41 °F) or greater than 40 °C (104 °F).  
Allow 10 cm (3-15/16 in) clearance around the unit for proper 
ventilation.
Placement 
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are 
not spilled into, the unit. Do not subject this unit to excessive smoke, 
dust, moisture, mechanical vibration, shock, or direct sunlight. 
3) Place the unit on a flat surface. 
						

							Important Information
Document Version 2009-03                                                                                                 15
WARNING:
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT 
EXPOSE THIS UNIT TO RAIN OR MOISTURE.
THIS HANDSET EARPIECE IS MAGNETIZED AND MAY RETAIN SMALL 
FERROUS OBJECTS.
THE USE OF EXCESSIVE SOUND VOLUME THROUGH EARPHONES, 
HEADPHONES, OR HEADSETS MAY CAUSE HEARING LOSS.
DISCONNECT THE TELEPHONE LINE CORD FROM THIS PRODUCT IF 
THIS PRODUCT EMITS SMOKE, AN ABNORMAL SMELL OR MAKES 
UNUSUAL NOISE. THESE CONDITIONS CAN CAUSE FIRE OR 
ELECTRIC SHOCK. CONFIRM THAT SMOKE HAS STOPPED AND 
CONTACT AN AUTHORIZED SERVICE CENTER.
IMPORTANT NOTICE:
•Under power failure conditions, the DPT may not operate. Please ensure 
that a separate telephone, not dependent on local power, is available for 
use in remote sites in case of emergency.
When you ship the product:Carefully pack and send it prepaid, adequately insured and preferably in the 
original carton. Attach a postage-paid letter, detailing the symptom to the 
outside of the carton.
DO NOT send the product to the Executive or Regional Sales offices. They 
are NOT equipped to make repairs.
Product service:Panasonic factory service centers for this product are listed in the service 
center directory.
Consult your authorized Panasonic dealer for detailed instructions. 
						

							Important Information
16                                                                                                   Document Version 2009-03
Important Safety Instructions
When using this unit, basic safety precautions, including those below, 
should always be followed to reduce the risk of fire, electric shock and injury 
to persons.
1.Read and understand all instructions.
2.Follow all warnings and instructions marked on this unit.3.Unplug this unit from the main unit before cleaning. Do not use liquid or 
aerosol cleaners. Clean with a soft cloth.
4.Do not use the unit near water, for example, near a bathtub, kitchen 
sink, or laundry tub, in a wet basement, or near a swimming pool.
5.Place this unit on a flat surface. Serious damage and/or injury may 
result if the unit falls.
6.The unit should never be placed near or over a radiator or other heat 
source.
7.Do not allow anything to rest on the extension cord. Do not locate this 
unit where the cord may be stepped on or tripped on.
8.To reduce the risk of fire or electric shock, do not overload wall outlets 
and extension cords.
9.Do not insert objects of any kind into this unit through openings, as they 
may touch dangerous voltage points or short out parts that could result 
in a risk of fire or electric shock. Never spill liquid of any kind on the unit.
10.To reduce the risk of electric shock, do not disassemble this unit. Only 
qualified personnel should service this unit. Opening or removing 
covers may expose you to dangerous voltages or other risks. Incorrect 
reassembly can cause electric shock.
11.Unplug this unit from the main unit and have the unit serviced by 
qualified service personnel in the following cases: 
A.When the power supply cord or plug is damaged or frayed.
B.If liquid has been spilled on the unit.
C.If the unit has been exposed to rain or water.
D.If the unit does not operate according to this manual. Adjust only the 
controls that are explained in this manual. Improper adjustment of 
other controls may result in damage and may require service by a 
qualified technician to restore the product to normal operation.
E.If the unit has been dropped, or damaged.
F.If the unit’s performance deteriorates.
12.Avoid using a wired telephone during an electrical storm. There is a 
remote risk of electric shock from lightning.
13.Do not use a telephone in the vicinity of a gas leak to report the leak.
SAVE THESE INSTRUCTIONS 
						

							Important Information
Document Version 2009-03                                                                                                 17
FCC and Other Information
F.C.C. REQUIREMENTS AND RELEVANT INFORMATIONThis equipment has been tested and found to comply with the limits for a 
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 
are designed to provide reasonable protection against harmful interference 
in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, 
which can be determined by turning the equipment off and on, the user is 
encouraged to try to correct the interference by one or more of the following 
measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
CAUTION:To assure continued compliance with FCC rules, do not make any 
unauthorized changes or modifications to this equipment would void the 
user’s authority to operate this device.
When programming emergency numbers and/or making test calls to 
emergency numbers:
1) Remain on the line and briefly explain to the dispatcher the reason for 
the call before hanging up.
2) Perform such activities in the off peak hours, such as early morning 
hours or late evenings. 
						

							Important Information
18                                                                                                   Document Version 2009-03
Customer Information
This equipment complies with Part 68 of the FCC rules and the 
requirements adopted by the ACTA. On the bottom of the cabinet of this 
equipment is a label that contains, among other information, the following 
product identifier:  
US: ACJKXNANKX-DT321
 If requested, this number must be provided to the telephone company.
If trouble is experienced with this equipment KX-DT321, for repair or 
warranty information, please contact:
Panasonic Service and Technology Company-BTS Center
415 Horizon Drive Bldg. 300 Ste. 350-B
Suwanee, GA 30024-3186
If the equipment is causing harm to the telephone network, the telephone 
company may request that you disconnect the equipment until the problem 
is resolved.
Hearing Aid Compatibility:This telephone provides magnetic coupling for hearing aids.
Compliance with TIA-1083 standard:
Telephone handsets identified with this logo have 
reduced noise and interference when used with T-Coil 
equipped hearing aids and cochlear implants.
T
Compatible with
Hearing Aid T-Coil
TIA-1083 
						

							Document  Version 2009-03                                                                                                     19
WALL MOUNTING TEMPLATE
1. Drive the screws into the wall 
    as indicated.
2. Hook the unit onto the screw 
    heads.
     Note:
    Make sure to set the print size to 
    correspond with the size of this 
    page. If the dimensions of the 
    paper output still deviate slightly 
    from the measurements indicated 
    here, use the measurements
    indicated here.
100 mm (3-15/16 in)   83 mm (3-1/4 in)  for base unit
One screw at either point One screw here 
						

							PSQX4696ZA-UU (A) KK0309YH0 (M)
Panasonic Consumer Electronics Company,
Division of Panasonic Corporation of North America
One Panasonic Way Secaucus, New Jersey 07094
http://www.panasonic.com/csd
Copyright:This material is copyrighted by Panasonic Communications Co., Ltd., and 
may be reproduced for internal use only. 
All other reproduction, in whole or in 
part, is prohibited without the written consent of Panasonic Communications 
Co., Ltd.
© Panasonic Communications Co., Ltd. 2009