Panasonic Indoor Pan Tilt Head Aw Rp400 Operating Instructions

Before attempting to connect, operate or adjust this product, 
please read these instructions completely.
AW-PH400
AW-RP400
AW-RC400
AW-RL400
AW-PH400
AW-RC400AW-RP400
AW-RL400
Before attempting to connect, operate or adjust this product, 
please read these instructions completely.
Indoor Pan/Tilt HeadAW-PH400P
Pan/Tilt Control PanelAW-RP400N
Cable Compensation UnitAW-RC400N
Roll UnitAW-RL400G 

2
Safety precautions
1indicates safety information.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, 
DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
“dangerous voltage” within the product’s
enclosure that may be of sufficient magnitude
to constitute a risk of...

3
Safety precautions
1indicates safety information.
The socket outlet shall be installed near the
equipment and easily accessible or the mains plug or
an appliance coupler shall remain readily operable.
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8) Do not install near any...

4
Contents
Safety precautions  ........................................................... 2
Operating precautions ...................................................... 5
Introduction ...................................................................... 6
Accessories ...................................................................... 6
Precautions for use  .......................................................... 6
Installation precautions .................................................... 7...

5
Operating precautions
≥Handle the units carefully.
Dropping the units or subjecting them to strong impact may give rise to malfunctioning or accidents.
≥Turn off the power before connecting or disconnecting the cables.
Be absolutely sure to turn off the power before connecting or disconnecting the cables.
≥Do not use the units outdoors.
≥Maintenance
Wipe the units using a dry cloth. To remove stubborn dirt, dip a cloth into a diluted solution of kitchen detergent, wring them
out well, and wipe the...

Indoor Pan/Tilt Head  AW-PH400
6
Introduction
Accessories
Precautions for use
≥The stand-alone indoor pan/tilt head can be rotated
through 300 degrees in the vertical direction and 
400 degrees in the horizontal direction.
≥Operations can be performed at high speeds of up to 
90 degrees per second.
≥Equipment such as a camera and lens with a total weight
of 17.6 lbs (8 kg) can be mounted on the unit.
≥The camera can also be rotated using the AW-RL400 roll
unit available as an option.
≥The shooting...

Indoor Pan/Tilt Head  AW-PH400
AW-PH400
7
Installation precautions
≥Do not install the unit on any of its sides.
≥Avoid using the unit in the kitchen and other locations with lots of steam and oily vapors.
≥Mount the camera on the pan/tilt head only when you have finished installing it.
≥The maximum load-bearing capacity of this unit is 17.6 lbs (8 kg).
It cannot be used if the load to be borne exceeds 17.6 lbs (8 kg).
≥Do not use a lens which will impair or upset the unit’s balance. 
Even if the load...

Indoor Pan/Tilt Head  AW-PH400
8
Parts and their function
16
7
8
9
5 2
3
4
:;<
=
>
? 

Indoor Pan/Tilt Head  AW-PH400
AW-PH400
9
1Rotary head
This rotates in the horizontal direction.
2Pedestal
3POWER ON/OFF switch
When this is set to ON, the unit’s power is turned on;
when it is set to OFF, it is turned off.
4AC 120 inlet [AC IN] (AC 3-point inlet)
Connect the accessory AC power cable to this inlet.
5Camera mounting base mounting screws
M5!22 mm hexagon socket head screws, M5 flat
washers (3 of each provided as accessories)
These parts are used to secure the camera mounting
base to the...

Indoor Pan/Tilt Head  AW-PH400
10
=Guide pin
Use this to determine the direction in which the camera is
to be mounted.
>Camera mounting screws (U1/4” 20UNC)
These are used to secure the camera firmly after it has
been mounted.
?Side blank panel
This is used when the mounting direction of the pedestal
connector panel is to be changed.
@SDI IN connector [SDI IN]
Use a coaxial cable to connect this to the SDI OUT
connector on the AW-PB504 SDI card or other card
installed in the convertible camera.
ALENS I/F...