Panasonic Hdc Hs700 Operating Instructions

21VQT2M75
33 Photoshot button [ ] (l37)
34Zoom lever [W/T] (In Motion Picture 
Recording Mode or Still Picture 
Recording Mode) (
l 55)Thumbnail display switch [ / ]/
Volume lever [ sVOL r] (In Playback 
Mode) ( l43)
35 HDD access lamp [ACCESS HDD]
36 Status indicator ( l29)
37 Internal microphones
38 Recording start/stop button (l 35)
39 Mode dial ( l30)
40 Shoulder strap fixture
41 Grip belt
Adjust the length of the grip belt so that it fits 
your hand.
1 Flip the belt.
2 Adjust the length.
3 Replace...

22VQT2M75
Preparation
Setup
1
Power supply
∫About batteries that you can use with this unit
The battery that can be used with this unit is VW-VBG130/VW-VBG260/VW-VBG6.
≥This unit has a function to distinguish the batteries that can be used, and the 
batteries (VW-VBG130/VW-VBG260/VW-VBG6) that are compatible with this function. 
(The batteries that are not compatible with this function cannot be used.)
≥To use the VW-VBG6 for this unit, the battery pack holder kit VW-VH04 (optional) is required....

23VQT2M75
≥We recommend using Panasonic batteries ( l12, 24, 25, 155).
≥ If you use other batteries, we cannot guarantee the quality of this product.
≥ Do not heat or expose to flame.
≥ Do not leave the battery(ies) in an automobile exposed to direct sunlight for a long period 
of time with doors and windows closed.
Install the battery by inserting it in the direction shown in the figure.
Inserting/removing the battery
Removing the batteryBe sure to hold down the power 
button until the status indicator...

24VQT2M75
∫Charging/Recording time
≥Temperature: 25 oC (77 oF)/humidity: 60% 
Charging and recording time
HDC-TM700
Battery model number
[Voltage/Capacity  (minimum)]Charging timeRecording modeMaximum 
continuous 
recordable timeActual 
recordable  time
Supplied battery/
VW-VBG130 (optional) [7.2 V/1250 mAh] 2h35min1080/60p 1 h 35 min 55 min
HA, HG, HX, HE 1h40min 1h
VW-VBG260 (optional)
[7.2 V/2500 mAh] 4h40min1080/60p
3 h1 h 50 min
HA, HG,  HX, HE 3h10min 1h55min
VW-VBG6 (optional)*
[7.2 V/5400 mAh]...

25VQT2M75
* The battery pack holder kit VW-VH04 (optional) is necessary.
≥These times are approximations.
≥ The indicated charging time is for when the battery has been discharged completely. 
Charging time and recordable time vary depending on the usage conditions such as 
high/low temperature.
≥The actual recordable time refers to the recordable time when repeatedly starting/stopping 
recording, turning the unit on/off, moving the zoom lever etc.
≥ The batteries heat up after use or charging. This is...

26VQT2M75
Important:
While the DC cable is connected to the AC adaptor, the battery will not charge.
≥Do not use the AC cable with any other equipment as it is designed only for this unit. 
Also, do not use the AC cable from other equipment with this unit.
1Connect the AC cable to the AC adaptor and the AC outlet.
2Connect the DC cable to the AC adaptor.
3Connect the DC cable to the DC input terminal [DC IN].
≥When removing the AC adaptor, be sure to hold down the power button until the status 
indicator...

27VQT2M75
Preparation
Setup
2
Recording to a card
The unit can record still pictures or motion pictures to an SD card, built-in memory or HDD. 
To record to an SD card, read the following.
Use SD cards conforming to Class 4 or higher of the SD Speed Class Rating* for 
motion picture recording.
* The SD Speed Class Rating is the speed standard for successive writes.
≥ 4 GB or more Memory Cards that do not 
have the SDHC logo or 48 GB or more 
Memory Cards that do not have the SDXC 
logo are not based on...

28VQT2M75
Caution:
Check that the access lamp has gone off.
1Open the LCD monitor.
2Open the SD card/terminal 
cover and insert (remove) the 
SD card into (from) the card 
slot.
≥Face the label side  B in the direction 
shown in the illustration and press it 
straight in as far as it will go.
≥ Press the center of the SD card and then 
pull it straight out.
3Securely close the SD card/
terminal cover.
≥Securely close it until it clicks.
≥Do not touch the terminals on the back of 
the SD card.
≥ Do not...

29VQT2M75
Preparation
Setup
3
Turning the unit on/off
You can turn the power on and off using the power button, the LCD monitor or the viewfinder.
Press the power button to turn on the power
AThe status indicator lights on.
Opening the LCD monitor or extending the viewfinder turns on the power. Closing the LCD 
monitor/viewfinder turns off the power.
During general use, you may find it convenient to turn the power on/off using the LCD 
monitor or viewfinder.
∫ To turn on the power
A The status indicator...

30VQT2M75
Preparation
Setup
4
Selecting a mode
Change the mode to recording or playback.
Operate the mode dial to change the mode to  ,   or  .
Motion Picture Recording Mode (l35)
Still Picture Recording Mode ( l37)
Playback Mode ( l41, 86)
≥Align with the status indicator  A.
HDC-TM700&HS700P&PC-VQT2M75_mst.book  30 ページ  ２０１０年２月２３日　火曜日　午前１０時３４分