Panasonic Hands Free Kit Cy Bt200u Operating Instructions

							English
11
if applicable, travel to and from the servicer, and loss of media, data or other memo-
ry contents. The items listed are not exclusive, but are for illustration only.) ALL
EXPRESS AND IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MER-
CHANTABILITY, ARE LIMITED TO THE PERIOD OF THE LIMITED WARRANTY.
Some states do not allow the exclusion or limitation of incidental or conse-
quential damages, or limitations on how long an implied warranty lasts, so the
exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have other
rights which vary from state to state. If a problem with this product develops
during or after the warranty period, you may contact your dealer or
Servicenter. If the problem is not handled to your satisfaction, then write to
warrantor’s Consumer Affairs Department at the addresses of the warrantor.
PARTS AND SERVICE WHICH ARE NOT COVERED BY THIS LIMITED WAR-
RANTY ARE YOUR RESPONSIBILITY.
Customer’s Record
Model
No.
Serial
No.
Dealer’s
No.
Code
No.
Dealer’s
Address
Date of 
Purchase
CANADA
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga Ontario L4W 2T3
PANASONIC PRODUCT LIMITED WARRANTY
Panasonic Canada Inc. warrants this product to be free from defects in materi-
als and workmanship and agrees to remedy any such defect for a period as
stated below from the date of original purchase.
CAR AUDIO PRODUCT – ONE (1) YEAR, PARTS AND LABOUR(The labour to install or remove the product is not warranted)
ACCESSORIES - NINETY (90) DAYS, (IN EXCHANGE FOR DEFECTIVE ITEMS)
LIMITATIONS AND EXCLUSIONSThis warranty does not apply to products purchased outside Canada or to any
product which has been improperly installed, subjected to usage for which the
product was not designed, misused or abused, damaged during shipping, or
which has been altered or repaired in any way that affects the reliability or detracts
from the performance, nor does it cover any product which is used commercially.
Dry cell batteries are also excluded from coverage under this warranty.
This warranty is extended to the original end user purchaser only. A purchase
receipt or other proof of the original purchase date is required before warranty
service is performed.
THIS EXPRESS, LIMITED WARRANTY IS IN LIEU OF ALL OTHER WAR-
RANTIES, EXPRESS OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
IN NO EVENT WILL PANASONIC CANADA INC. BE LIABLE FOR ANY SPECIAL,
INDIRECT OR CONSEQUENTIAL DAMAGES.
In certain instances, some jurisdictions do not allow the exclusion or limitation
of incidental or consequential damages, or the exclusion of implied warranties,
so the above limitations and exclusions may not be applicable. 
						

							12
Components
Operating Instructions(YFM264C099ZA)Qty: 1
Product Registration Card
Qty: 1
Customer Care Plan
Qty: 1
Main Unit
Qty: 1
Switch Unit (2 m)(ASMYSW100N)Qty: 1Microphone with Bracket (5 m)
(L0FBBB000005)Qty: 1
System-up connecting cable (3 m)(YEAJ071812A)Qty: 1
Double-sided Tape(YFX994C128ZA)Qty: 2
Double-sided Tape(YFX994C129ZA)Qty: 1
Cable Clamp
Qty: 5
Note:
¡The number in parentheses underneath each accessory part name is the part number for maintenance and service.
¡Accessories and their part numbers are subject to modification without prior notice due to improvements.
CY-BT200U CY-BT200U 
						

							English
13
Contents
Safety Information ............................ 2
Customer Services Directory  .......... 8
Limited Warranty  ............................ 10
Components ................................... 12
Introduction .................................... 14
Glossary .......................................... 16
Names of Controls and Functions... 17
Preparation (Bluetooth Audio) ....... 18
Basic Operation 
(Bluetooth Audio).. 19
Preparation (Hands-Free Kit) ......... 20
Basic Operation 
(Hands-Free Kit).... 22
Advanced Operation 
(Hands-Free Kit).23
Installation ...................................... 24
Wiring .............................................. 26
Troubleshooting ............................. 28
Specifications ................................. 34 
						

							14
What users can do with CY-BT200U
Connection of this unit to a head unit allows users to perform the
functions described below.
Listening to the audio system (Bluetooth audio)
Combination of this unit and a Bluetooth-ready mobile phone or
audio device allows users to play the phone or device through
this unit.
Hands-free conversation on a mobile phone 
(Hands-Free Kit)
Combination of this unit and a Bluetooth-ready mobile phone
allows users to have hands-free conversation on the phone.
¡Telephone picking up
¡Callback with use of the call register
This unit is designed only for receiving calls with taking
account of safety. No call can be made with this unit. 
(But a call-back call can be made.)
This unit does not support the voice dial function.
Note: 
¡A certain distance shall be provided between this unit and the
Bluetooth-ready device. Failure to observe this may cause low
quality tone or bad connection condition.
¡Do not use this unit and other wireless devices at the same
time. Failure to observe this may cause interference between
this unit and those devices.
¡Bluetooth connection will shorten the battery life of the
Bluetooth-ready device.
¡This unit cannot support the cable connection mobile phones.
¡This unit (only 1 unit) is connectable to the head unit through
the Expansion Module (CY-EM100U, option) as well as con-
nectable to the head unit directly.
Panasonic welcomes you to our constantly growing family of electronic products owners.
We endeavor to give you the advantages of precise electronic and mechanical engineering, manufactured with carefully
selected components, and assembled by people who are proud of the reputation their work has built for our company. We
know this product will bring you many hours of enjoyment, and after you discover the quality, value and reliability we have
built into it, you too will be proud to be a member of our family.
❑ Overview
Introduction
Hands Free Kit with Audio Streaming featuring Bluetooth®technology 
						

							English
15
CY-BT200U CY-BT200U
Microphone with Bracket
Switch Unit
Main Unit
Head unit
❑ Installation sample 
						

							16
Glossary
Bluetooth®
The Bluetooth word mark and logo are owned by the Bluetooth
SIG, Inc. and any use of such  marks by Matsushita Electric
Industrial Co.,Ltd. is under license. Other trademarks and trade
name are those of their respective owners.
Bluetooth
Bluetooth is a name of the wireless communication technology
for the mobile information equipment such as portable PCs,
PDAs, mobile phones, etc. These devices can be connected each
other without cables and communicate each other.
Bluetooth uses 2.45 GHz band’s wave that can be used without a
license. Bluetooth chips are relatively small and their power con-
sumption is low. Communication service distance of Bluetooth is
approximately 10 m.
Bluetooth profile
Bluetooth profile is a standard protocol used in Bluetooth com-
munications settled for each category of the communication
equipment.
This hands-free unit supports the following Bluetooth profiles:
HFP (Hands-Free Profile), OPP (Object Push Profile), A2DP
(Advanced Audio Distribution Profile), AVRCP (Audio/VideoRemote Control Profile)
Link key
This is an up to 16-byte password used for device identification.
Entering the same PIN number of the device to be connected
allows identification. Once identification is completed, the Link
key is established. Identification is enabled without input of the
Bluetooth Pin Number from next time thanks to holding the Link
key at both sides.
PIN (Personal Identification Number)
This is a password used for self identification.
Pairing
Pairing is authentication between 2 Bluetooth devices with using
a link key.
Pairing allows Bluetooth devices to communicate each other.
iPod®
iPod is a trademark of Apple Inc., registered in the U.S. and other
countries. 
						

							English
17
CY-BT200U CY-BT200U
[Hang-on] /Blue LED
[Hang-up] /Red LED Status indicator (Blue LED)
lights: Call waiting/Talking
stays out: Not connected
blinks rapidly: Receiving a call
blinks slowly: Pairing/
Reconnecting
System-up connector
To a Head unit or a port of Expansion
module
Microphone connector
To the microphone with
Bracket
Switch Unit connector
To the Switch Unit
Main unitMicrophone with Bracket
Names of Controls and Functions
Switch Unit 
						

							18
Preparation (Bluetooth Audio)
Perform electrical wiring for CY-BT200U (this unit) and
install it. (
\page 26, 27) Refer to the individual instructions
for the devices to be connected as well.
qItems for preparation
¡CY-BT200U (this unit)
¡Bluetooth-ready audio device
Note:For the models to be supported, visit the Web Site at:
http://www.panasonic.com (Refer to the description regarding
Car Audio/AV.)
We do not guarantee that all the functions of this unit are
available on all of the Bluetooth-ready devices.
¡Head unit
The models to be supported are shown below as of December
2007.
CQ-VX100U/CQ-VW100U, CQ-RX400U/CQ-RX200U
wPairing
This unit should register the Bluetooth-ready device to be cou-
pled before using.
Pairing establishment is performed on the menu screen of the
head unit. Refer to the Operating Instructions of the head unit for
further information.
Note:
¡If another device is already registered, deletion of the regis-
tered data for the device is required in advance. Refer to the
Operating Instructions of the head unit for further information.
¡Only the latest paired the Bluetooth-ready is usable.
¡This unit is displayed as “Panasonic BT200” on the screen of
the Bluetooth-ready device. 
¡If the displayed device is different from the connected device,
the pairing is not successfully completed. Try to establish the
pairing again. 
¡Once pairing is established, this operation is not required until
replacing the Bluetooth-ready device with another Bluetooth-
ready device.
eVolume adjustment
(head unit) 
						

							English
19
The connected Bluetooth-ready device is operable from the
head unit. Refer to the Operating Instructions of the head unit
for further information.
Note:Some audio devices may be inoperable from the head
unit.
❑ Track selection
[7] (TRACK): Next track
[6] (TRACK): Preceding track (press twice)
Note: Hold down for fast forward/reverse.
❑ Pause
Press [BAND] (5
h).
Press again to cancel.
❑ Automatic reconnection
This unit stores the data of the device that was connected to this
unit last time. (Stored data for 1 Bluetooth audio device and for 1
Hands-Free Kit) Turning on the power of the head unit allows
this unit to automatically attempt to connect to the device that
was connected last time.
Note:With regard to some devices, reconnection cannot be per-
formed.
Basic Operation (Bluetooth Audio) 
						

							20
Preparation (Hands-Free Kit)
Perform electrical wiring for CY-BT200U (this unit) and
install it. (
\page 26, 27) Refer to the individual instructions
for the devices to be connected as well.
qItems for preparation
¡CY-BT200U (this unit)
¡Bluetooth-ready mobile phone
Note:For the models to be supported, visit the Web Site at:
http://www.panasonic.com (Refer to the description regarding
Car Audio/AV.)
We do not guarantee that all the functions of this unit are
available on all mobile phones.
¡Head unit
The models to be supported are shown below as of December
2007.
CQ-VX100U/CQ-VW100U, CQ-RX400U/CQ-RX200U
wPairing
This unit should register the Bluetooth mobile phone to be cou-
pled before using.
Pairing establishment is performed on the menu screen of the
head unit. Refer to the Operating Instructions of the head unit for
further information.
Note:
¡If another device is already registered, deletion of the regis-
tered data for the device is required in advance. Refer to the
Operating Instructions of the head unit for further information.
¡Only the latest paired mobile phone is usable.
¡This unit is displayed as “Panasonic BT200” on the screen of
the mobile phone. 
¡If the displayed device is different from the connected device,
the pairing is not successfully completed. Try to establish the
pairing again. 
¡Once pairing is established, this operation is not required until
replacing the phone with another mobile phone.