Panasonic Epilator Es 2067 Operating Instructions

							
Operating Instructions
Manuel d’utilisation
Instrucciones de operación
Epilator
Épilateur
Depiladora Eléctrica
Model No.
Nº de modèle
Modelo No.
 ES2067
Before operating this unit, please read these instructions completely and save them for future use.Avant d’utiliser cet appareil, nous vous recommandons de lire l’ensemble de ces instructions et de les ranger dans un endroit accessible pour une consultation ultérieure.Antes de utilizar esta unidad, por favor lea estas instrucciones completamente, y guarde este manual para uso futuro.
•
•
•
Contents
English 2
Français 13
Español 25

ES2067_USA.indb   12008/01/12   11:38:35 
						

							
2
English

IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should 
always be followed, including the following:
Read all instructions before using this  appliance.
DANGER To reduce the risk of electric 
shock:
1.  Do not reach for an appliance that has fallen into water. 
Unplug immediately.
2.  Charger unit is not for immersion or for use in shower.
3.  Do not use an extension cord with this appliance.
4.  Do not place or store appliance where it can fall or be pulled 
into a tub or sink. Do not place in or drop into water or other 
liquid.
5.  Except when charging, always unplug this appliance from 
the electrical outlet immediately after using.
6.  Unplug this appliance before cleaning.
WARNING To reduce the risk of burns,  re, 
electric shock, or injury to persons:
1.  Do not use this appliance with damaged epilation/shaver 
heads as injury may occur.
2.  An appliance should never be left unattended when plugged 
in.
3.  Not for use by or on children or invalids. Close supervision 
is necessary when used near children or invalids.
4.  Use this appliance only for its intended use as described in 
this manual. Do not use attachments not recommended by 
the manufacturer.
5.  Never operate this appliance if it has a damaged cord or 
plug, if it is not working properly, if it has been dropped or 
damaged, or dropped into water. Return the appliance to a 
service center for examination and repair.
6.  Keep the cord away from heated surfaces.

ES2067_USA.indb   22008/01/12   11:38:35 
						

							
3
English

7.  Never drop or insert any object into any opening.
8.  Do not use outdoors or operate where aerosol (spray) 
products are being used or where oxygen is being 
administered.
9.  Always attach charger to appliance  rst, then to outlet.
SAVE THESE INSTRUCTIONS
CAUTION To reduce the risk of personal 
injury, follow these instructions:
1.  Before each use, always make sure that the epilation disks 
and outer foil are not damaged or deformed.
2.  Insert the charger securely into the appliance.
3.  Use only the included charger RE7-46 to charge the 
ES2067 epilator.
4.  Make sure skin is clean before and after use.
Always wipe away perspiration and keep skin in a hygienic 
state.
Failure to do so can cause infection and in ammation.
5.  When beginning use of the appliance, allow your skin time 
to adjust by testing it gradually over a period of two to three 
days.
6.  Discontinue use if skin trouble continues for more than two 
days.
Please consult a dermatology specialist in such instances.
7.  Always turn off the power switch when exchanging epilation 
or shaver heads.
Failure to do so could cause  nger injury, or hair to become 
entangled in the spinning gears, or damage to the 
appliance.
8.  Be careful not to let clothing or, etc., come in contact with 
epilation discs.
Failure to do so could result in becoming entangled in the 
discs.
9.  Never allow the appliance to come in contact with the hair 

ES2067_USA.indb   32008/01/12   11:38:35 
						

							
4
English

on your head, eyelashes, ribbons, etc., when switched on.
Doing so can cause personal injury or mechanical 
malfunction.
10. When unplugging, pull the plug, not the cord.
Failure to do so could cause electric shock or short-
circuiting.
11. Avoid dropping the appliance or allowing it to strike hard 
surfaces.
Doing so can cause personal injury or mechanical 
malfunction.

ES2067_USA.indb   42008/01/12   11:38:35 
						

							
5
English

ImportantBefore use
Before useDo not use the appliance if you have eczema, rashes, sensitive skin, proneness to infections, varicose veins, diabetes, hemophilia or poor blood clotting or other skin conditions.Using just before swimming and sports activities or sharing with other persons might result in bacteria entering the skin and causing damage and in ammation.Turning on the appliance without an epilation or shaver head attached might cause  nger injury, hair entanglement in the spinning gears or mechanical malfunction.The followings might cause sensitive skin damage, injury, in ammation, pain, bleeding, and severe pain.Using the appliance if the epilation discs, the  oat guard/the skin protector or the outer foil have been damaged.Using on or near your face, genitals, warts, pimples, bruises, rashes, wounds or loose skin.Applying strong pressure to the skin, repeatedly moving over the same area or using a jabbing motion.Using before or during menstruation, pregnancy, about one month after giving birth, when ill and when your skin is sunburned etc.The appliance can be used for wet or dry epilation. The following is the symbol for a wet epilator. It means that the appliance can be used in a bath or shower.
Safety precautionsNever use the charger in the bathroom.Always ensure the appliance is used on an electric power source matched to its rated voltage.Do not bend, twist, pull or modify the cord.Do not wrap the cord tightly around the appliance.Never use the appliance if the cord or the charger is damaged or overly hot or if the plug  ts loosely in a household outlet.Regularly clean the cord connector to prevent dust.The movement of the discs makes some noise but this is perfectly normal.Keep the appliance out of the reach of children or invalids.Do not leave the appliance near sinks, bathrooms or other high-humidity areas where it could be exposed to water and moisture after use.The followings might cause mechanical malfunction.
•
•
•
•
-
-
-
-
••
•••
••••
•

ES2067_USA.indb   52008/01/12   11:38:35 
						

							
6
English

Using nail polish remover, benzine, alcohol, etc. to clean the appliance.Leaving the appliance where it will be exposed to high temperatures or direct sunlight.Contact an authorized service center if the epilator or the cord get damaged.
Changing the headBefore use 1.  Remove the head while holding the head release button.2.  Push the head until it clicks.
Charging the applianceCharging 

1.  Plug the charger into the epilator () and a household outlet ().2.  Charge the appliance for approximately 1 hour. (Charging is completed when the charging light blinks.)The epilator can be used for approximately 30 minutes after 1 hour charge.
While charging:  Red light appears.After charging is completed:  Blinks once every second.10 minutes after charging is completed:  Blinks once every 2 seconds.Abnormal Charging:  Blinks twice every second.
••
•
•
The charge light may not turn on after a few minutes in some cases. However, it will turn on eventually if you continue charging.The appliance can be left plugged in after it is fully charged without deteriorating the battery life.The recommended charge temperature is 15-35 °C (59-95 °F).If you use the charger in temperature outside of the recommended range, the following problems might occur.The time it takes to charge the appliance increases. (approximately 3 hours)The charger stops functioning.If you use the charger in low temperature, the battery life might be reduced.The charger is intended to be correctly oriented in a vertical or  oor mount position.If the shape of the plug does not  t the power outlet, use an attachment plug adaptor of the proper con guration.
--
•
•
•
•
•
--•
•
•

ES2067_USA.indb   62008/01/12   11:38:35 
						

							
7
English

Wet/foam epilationUsing Do not use the epilation head for legs/arms to epilate your underarms and bikini-line.
Trim your hair before epilating for the  rst time or if you have not epilated for a long time.The recommended use temperature is 5-35 °C (41-95 °F).If you use the appliance in temperature outside of the recommended range, it may stop functioning or might reduce the operating time.
•
•
1.  Wet your skin.
2.  Remove the cap (only the epilation head for underarms/
bikini-line).
3.  Wet the discs and place a small quantity of liquid body 
soap on the discs.
4.  Press the 0/1 switch to turn on the power and then 
epilate.Foam makes the epilator slide better, so you can move it fast. Always wash the discs well after use to remove any residual soap.
Dry epilation
You can also epilate without wetting your skin or the discs.
For best epilation resultsUsing
9090
Apply the epilator at a right angle to your skin and press gently while moving it slowly against the hair growth, or your skin may be damaged.When using the appliance, pull your skin taut where the area is prone to sagging (on the inside of the knees and elbows).Rub your skin to lift short hair.Do not remove the frame of the epilation head.Please shave your hair with shaver head to no longer than 5 mm.Reddening might appear for your  rst use. Cool towel will help if you feel pain or there is a rash.We recommend regular use of massage sponges or exfoliation to prevent ingrown hair.
•
•
••••
•

ES2067_USA.indb   72008/01/12   11:38:36 
						

							
8
English

Moving directions
Move freely in any direction.Move in several directions as underarm hair grows in different directions.Move the epilator with the side that has the foam keeper facing the front.
Wet/foam shavingShaving
1.  Attach the shaver head.
2.  Wet your skin.Shaving with soap lather makes the skin slippery for a closer shave.Do not use shaving cream, skin cream or skin lotion as it will clog the blades.
3.  Press the 0/1 switch to turn on the power.Hair removal is easier and less painful when the hair is short.Slide the pop-up trimmer switch up to cut long hair.Press gently so that the whole of the blade is in close contact with the skin and the surface of the blade does not move up and down.
Shaving the bikini-line with the bikini comb
Place the bikini comb onto the shaver head and slide trimmer up.When the bikini comb is in place, make sure the comb is in close contact with the skin.
Dry shaving
You can also shave without wetting your skin or the head.
Cleaning the epilatorCleaning
Switch off and unplug the appliance before cleaning.Always unplug the charger from a household outlet and from the epilator before cleaning the appliance.Wipe the main body only with a dry cloth. The use of alcohol etc. might cause discoloration or deformation of the main body.When storing the epilator, always attach the protection cap for the epilation head for underarms/bikini-line, and the bikini comb for the shaver head and put the epilation head for legs/arms on the stand.
Washing your epilator
Always clean the frames and discs after use to keep them in a hygienic state.
••
•••
•
•
•
•

ES2067_USA.indb   82008/01/12   11:38:36 
						

							
9
English

Take care not to damage the  oat guard/the skin protector during cleaning.
1


2-4
1.  Remove the frame by pushing the frame release button.2.  Apply liquid hand soap to the discs and blade.3. Turn the switch on and then wet the discs to create foam.4.  Wash the head with water to clean hair.Do not use hot water.If soap is not completely washed away, then a white deposit can accumulate and prevent the blades from moving smoothly.5.  Turn the switch off, wipe the appliance with a dry cloth and dry it well.
Cleaning your epilator with the supplied brush
You can also clean the epilation head and the shaver head with the cleaning brush.
•
••

ES2067_USA.indb   92008/01/12   11:38:36 
						

							
10
English

Replacing the outer foilReplacing
Replace the shaving foil and the inner blade when you notice reduced shaving performance. Never remove the outer foil of the shaver head for any other reason than to change it.
Removing the outer foil
While pushing the outer foil gently with the  ngers, use a  ngernail to release the plastic panel  on the blade from the catches  on the inside of the frame.

Fitting the new outer foil
Hold the outer foil so that the surface with the plastic panel  (i.e. the surface that will come into contact with the inner blade) faces upward and then insert it into the frame so that the catches  on the frame  t into the holes on the foil.We recommend replacing the outer foil every year and the inner blade every two years.
Removing the built-in rechargeable batteries
ATTENTION:Lithium ion batteries that are recyclable power the product you have purchased. Please call 1-800-8-BATTERY for information on how to recycle these batteries.
R B R C
L i - i o nT M
WARNING for Lithium Battery:Fire, explosion, and severe burn hazard. Do not crush, disassemble, heat above 100 °C (212 °F), or incinerate.
•

ES2067_USA.indb   102008/01/12   11:38:37