Panasonic Electronic Board UB-5838C, UB-5338C Operating Instructions

Wall-Mounting Construction51
Installation
■Wall Types and Installation Procedures
The method for attaching the wall-mounting fixtures to the wall will vary depending on the nature of the wall’s 
structure.
Three available options are listed below.
Other methods may be necessary depending on the wall.
● Metal or Concrete walls
Stud plugs (sold in stores) are needed.
Drill eight holes in the wall.
For the correct hole size, refer to the instructions for 
the particular stud plugs used.
Insert the bolt...

Wall-Mounting Construction
52
● Plasterboard walls
Split-wing toggles (sold in stores) are needed.
●Wooden walls
Wood screws (sold in stores) are needed.
Insert the bolt through the hole in the wall-mounting 
fixture and attach the split-wing toggle. Then insert 
the split-wing toggle into the hole while the arms are 
horizontal.
For the correct hole size, refer to the instructions for 
the particular split-wing toggles used.
After the arms expand, pull the wall-mounting fixture 
out until the arms of...

53
Installation
Optional Stand Assembly (UE-608035)
■Included Parts
Check that the following parts are included with the optional stand (UE-608035).
*1Use four screws and rivets when installing the electronic board.*2The included wrench is necessary for tightening and loosening the screws, so keep it in a safe location.
Note
•Before assembly, be sure to lock the casters.
No.Part nameIllustrationQ’ty
Stand Base 2
Support Beam 2
Fall-prevention Extension Leg 4
Flat Head Screw (M6  × 60 mm [2
3/8]) 4
Nut 4...

Optional Stand Assembly (UE-608035)
54
■ Assembly Instructions
1
Assemble the fall-prevention extension legs.
2
Assembling the stand
Locking casters side (rear)
UB5838C-PJQXC0259ZA_mst.book  54 ページ  ２００９年５月２６日　火曜日　午後２時５９分 

Optional Stand Assembly (UE-608035)55
Installation
3
Pull the fall-prevention extension legs down.
Note
•When folding back the fall-prevention extension legs, release the lock as follows ( 1, 2).
4
Mount the unit.
•Refer to “Assembling the unit” (page 40).
2
1
1
1
2
UB5838C-PJQXC0259ZA_mst.book  55 ページ  ２００９年５月２６日　火曜日　午後２時５９分 

Information for Users on Collection and Disposal of Old Equipment and used Batteries
These symbols on the products, packaging, and/or accompanying documents mean that used electrical and 
electronic products and batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used batteries, please take them to applicable 
collection points, in accordance with your national legislation and the Directives 2002/96/EC and 2006/66/EC.
By disposing...