Panasonic Digital Camera Dmc Gf5 Owners Manual

							- 161 -
Playback/Editing
∫Operations performed during slide show
•
Normal playback resumes after the slide show finishes.•Display at the right of the screen while playing back corresponds to  3/4/ 2/1 on the 
cursor button.
•You can also adjust the volume by rotating the control dial.
∫ Changing the slide show settings
You can change the settings for slide show play back by selecting [Effect] or [Setup] on the 
slide show menu screen.
[Effect]
This allows you to select the screen effects when switching from one picture to the next.
[AUTO], [NATURAL], [SLOW], [SWING], [URBAN], [OFF]
•
When [URBAN] has been selected, the picture may appear in black and white as a screen 
effect.
•[AUTO] can be used only when [Category Selection] has been selected. The pictures are 
played back with the recommended effects in each category.
•[Effect] is set to [OFF] when playing a slide show with motion pictures only.•While viewing pictures in Portrait Mode (vertical) some selections in the [Effect] feature are 
disabled.
[Setup]
[Duration] or [Repeat] can be set.
•
[Duration] can be set only when [OFF] has been selected as the [Effect] setting.
Play/PauseExit slide show
Back to previous picture
(while pausing/playing back 
motion pictures)Ahead to next picture
(while pausing/playing back 
motion pictures)
Reduce volume levelIncrease volume level
ItemSettings
[Duration] [1SEC]/[2SEC]/[3SEC]/[5SEC]
[Repeat] [ON]/[OFF]
[Sound] [AUTO]: Music is played when the still pictures are played 
back, and audio is played when the motion pictures 
are played back.
[Music]: Music is played back.
[Audio]: Audio (only for motion pictures) is played back.
[OFF]: There will be no sound. 
						

							Playback/Editing
- 162 -
Playback in [Normal Play], [Picture Only], [Video Only], [3D Play], [Category Play] or 
[Favorite Play] can be selected.
1Select [Playback Mode] on the [Playback] menu. (P60)
2Touch the group to play back.
•Refer to P175 for the method to play back [3D Play] pictures in 3D.
When [Category Play] is selected in above step 2
3Touch the category to play back.
•Pictures are sorted into the categories shown below.
¢ Play back by selecting and touching the picture of the person you desire to play back.
4Touch [Set].
[Playback Mode]
Recording information e.g. Scene Detection or Scene Guide Modes
•[Face Recog.]¢
*
•[i-Portrait], [i-Night Portrait], [i-Baby] in Scene Detection•[Clear Portrait], [Silky Skin], [Backlit Softness], [Clear in Backlight], 
[Relaxing Tone], [Sweet Childs Face] and [Clear Night Portrait] in Scene 
Guide Mode
,•[i-Scenery], [i-Sunset] in Scene Detection•[Distinct Scenery], [Bright Blue Sky], [Romantic Sunset Glow], [Vivid 
Sunset Glow] and [Glistening Water] in Scene Guide Mode
.
•[i-Night Portrait], [i-Night Scenery] in Scene Detection•[Clear Nightscape], [Cool Night Sky], [Warm Glowing Nightscape], 
[Artistic Nightscape], [Glittering Illuminations] and [Clear Night Portrait] in 
Scene Guide Mode
•[Clear Sports Shot] in Scene Guide Mode
1•[Appetizing Food], [Cute Dessert] in Scene Guide Mode
•[Travel Date] 
						

							- 163 -
Playback/Editing
You can add text (comments) to pictures. After text has been registered, it can be stamped 
in prints using [Text Stamp] (P164).
1Select [Title Edit] on the [Playback] menu.  (P60)
2Touch [Single] or [Multi].
4Enter the text. (P138)
•Exit the menu after it is set.
Note
•To delete the title, erase all the text in the text input screen.•You can print out texts (comments) using the “ PHOTOfunSTUDIO ” bundled software on the 
CD-ROM (supplied).
•You can set up to 100 pictures at one time with [Multi].•Title editing is disabled during the following conditions:–Motion pictures–Pictures taken with [ ], [ ] or [ ]–Pictures recorded with other equipment
[Title Edit]
3
Select an image to add text.
•[ ’] is displayed for pictures with titles already registered.
[Single] setting
1 Drag the screen horizontally and select an image.
2 Touch [Set].
[Multi] setting
1 Touch a picture (repeat).
•
Selection will be canceled by touching the same picture again.2Touch [OK]. 
						

							Playback/Editing
- 164 -
You can stamp the recording date/time, name, location, travel date or title onto the 
recorded pictures.
1Select [Text Stamp] on the [Playback] menu. (P60)
2Touch [Single] or [Multi].
4Touch [Set].
[Text Stamp]
3
Select an image you wish to stamp with text.
•[ ‘ ] appears on screen if the picture is stamped with text.
[Single] setting
1 Drag the screen horizontally and select an image.
2 Touch [Set].
[Multi] setting
1 Touch a picture (repeat).
•
Selection will be canceled by touching the same picture again.2Touch [OK]. 
						

							- 165 -
Playback/Editing
5Select the item to stamp.
6Touch [ ].
7Touch [OK].
•Confirmation screen is displayed. It is executed when [Yes] is selected. 
Exit the menu after it is executed.
Note
•When you print pictures stamped with text, the date will be printed over the stamped text if you 
specify printing of the date at the photo shop or on the printer.
•You can set up to 100 pictures at one time in [Multi].•The picture quality may deteriorate when text stamping is carried out.•Depending on the printer being used, some characters may be cut at printing. Check before 
printing.
•The [Text Stamp] feature is disabled during the following conditions:–Motion pictures–Pictures recorded without setting the clock and title–Pictures that were previously stamped with [Text Stamp]–Pictures taken with [ ], [ ] or [ ]–Pictures recorded with other equipment
ItemDescription of settings
[Shooting Date]
[W/O TIME]:Stamp the year, month and date.
[WITH TIME]:Stamp the year, month, day, hour and minutes.
[OFF]
[Name] []:
([Face 
Recognition])
Name registered in [Face Recog.] will be 
stamped.
[]:
([Baby/Pet])Name registered in [Profile Setup] will be 
stamped.
[OFF]
[Location]
[ON]:Stamps the travel destination name set under 
[Location].
[OFF]
[Travel Date][ON]:Stamps the travel date set under [Travel Date].
[OFF]
[Title][ON]:Title input in the [Title Edit] will be stamped.
[OFF] 
						

							Playback/Editing
- 166 -
Recorded motion picture can be divided in two. It is recommended for when you want to 
divide a part you need with a part you do not need.
Dividing a motion picture is permanent. Decide before you divide!
1Select [Video Divide] on the [Playback] menu. (P60)
2Drag the screen horizontally to select a motion picture to divide, and touch 
[Set].
•
Touch [ ] during playback to fast forward (touch [ ] to fast rewind).
Note
•The [Video Divide] feature only works on motion pictures recorded on this camera.•Avoid trying to divide motion picture near the  very beginning or end of the motion picture.•With [MP4] motion pictures, the order of pictures will change if divided.
It is recommended to search these motion pictures by using Calendar Playback  (P53) or [Video 
Only] in the [Playback Mode].
•With [AVCHD] motion pictures, the order of pictures will not change.•The [Video Divide] feature will be disabled during the following conditions:–Motion pictures with a short recording time
[Video Divide]
3
Touch [ ] at the location to divide.
•Motion picture is played back from the same location when [ ] is 
touched again.
•Make fine adjustments to the division position by touching [ ]/
[ ] while the motion picture is paused.
•Display at the right of the screen corresponds to  3/4/2 /1 on the 
cursor button.
4Touch [ ].
•Confirmation screen is displayed. It is executed when [Yes] is selected. 
Exit the menu after it is executed.
•Motion picture may be lost if the card or battery is removed while processing the dividing. 
						

							- 167 -
Playback/Editing
To allow easy posting to web pages, attachment to e-mail etc., picture size (number of 
pixels) is reduced.
1Select [Resize] on the [Playback] menu. (P60)
2Touch [Single] or [Multi].
Note
•
You can set up to 100 pictures at one time in [Multi].•The picture quality of the resized picture will deteriorate.•It may not be possible to resize pictures recorded with other equipment.•The [Resize] feature is disabled during the following conditions:–Motion pictures–Pictures stamped with [Text Stamp]–Pictures taken with [ ], [ ] or [ ]
[Resize]
3
Select the picture and size.
[Single] setting
1 Drag the screen horizontally to select an image, and then 
touch [Set].
2 Touch the size you wish to change, and then touch [Set].
•
Confirmation screen is displayed. It is executed when [Yes] is 
selected. 
Exit the menu after it is executed.
[Multi] setting
1Touch the size you wish to change.
2 Touch a picture (repeat).
•
Selection will be canceled by touching the same picture again.3Touch [OK].
•Confirmation screen is displayed. It is executed when [Yes] is 
selected. 
Exit the menu after it is executed. 
						

							Playback/Editing
- 168 -
You can enlarge and then clip the important part of the recorded picture.
1Select [Cropping] on the [Playback] menu. (P60)
2Drag the screen horizontally to select an image, and then touch [Set].
3Select the parts to be cropped.
Touch [ ]: Enlarge
Touch [ ]: Reduce
Drag:  Move
•
You can also move using the cursor buttons 3/4/2 /1.•Enlarge/reduce can also be performed by rotating the control dial.
4Touch [Set].
•Confirmation screen is displayed. It is executed when [Yes] is selected. 
Exit the menu after it is executed.
Note
•The picture quality of the cropped picture will deteriorate.•It may not be possible to crop pictures recorded with other equipment.•The [Cropping] feature is disabled during the following conditions:–Motion pictures–Pictures stamped with [Text Stamp]–Pictures taken with [ ], [ ] or [ ]•Information regarding the Face Recognition in the original picture will not be copied to images 
having undergone [Cropping].
You can manually rotate the images by 90 o each time.
1Select [Rotate] on the [Playback] menu.  (P60)
•The [Rotate] function is disabled when [Rotate Disp.] in the [Setup] menu is set to [OFF].
2Drag the screen horizontally to select an image, and then touch [Set].
3Select the rotation direction.
Touch :
The picture rotates clockwise in steps of 90 o.
Touch :
The picture rotates counter-clockwise in steps of 90 o.
•
Exit the menu after it is set.
Note
•When you play back pictures on a PC, they canno t be displayed in the rotated direction unless 
the OS or software is compatible with Exif. Exif  is a file format for still pictures which allows 
recording information etc. to be added. It was established by “JEITA (Japan Electronics and 
Information Technology Industries Association)”.
•It may not be possible to rotate pictures that have been recorded with other equipment.
[Cropping]
[Rotate] 
						

							- 169 -
Playback/Editing
You can do the following if a mark has been added to pictures and they have been set as 
favorites.
•
Play back the pictures set as favorites only as a slide show.•Play back only the pictures set as favorites. ([Favorite Play])•Delete all the pictures not set as favorites. ([All Delete Except Favorite])
1Select [Favorite] on the [Playback] menu.  (P60)
2Touch [Single] or [Multi].
∫ Canceling all the [Favorite] settings
1Select [Favorite] on the [Playback] menu.
2Touch [Cancel].
•Confirmation screen is displayed. It is executed when [Yes] is selected. 
Exit the menu after it is executed.
•In [Playback Mode] the [Cancel] Mode is disabled.
Note
•You can set up to 999 pictures as favorites.•You may not be able to set pictures taken with other equipment as favorites.•The [Favorite] feature is disabled for pictures taken with the [Quality] set to [ ].
[Favorite]
3
Select the picture.
•[ Ü ] is displayed on pictures that are already registered as favorites.[Single] setting
Select the picture and touch [Set/Cancel].
•
Setting is canceled by touching [Set/Cancel] again.•Exit the menu after it is set.
[Multi] setting
Touch the pictures you wish to set as favorites.
•
Setting is canceled by touching the same picture again.•Exit the menu after it is set. 
						

							Playback/Editing
- 170 -
DPOF “Digital Print Order Format” is a system that allows the user to select which pictures 
to print, how many copies of each picture to  print and whether or not to print the recording 
date on the pictures when using a DPOF compatible photo printer or photo printing store. 
For details, ask at your photo printing store.
For more information visit:
http://panasonic.jp/dc/dpof_110/white_e.htm
1Select [Print Set] on the [Playback] menu.  (P60)
2Touch [Single] or [Multi].
4Touch [ ]/[ ] to set the number of prints, and then touch [Set].
•When [Multi] has been selected–repeat steps 3 and 4 for each picture.•Exit the menu after it is set.
∫Canceling all the [Print Set] settings1Select [Print Set] on the [Playback] menu.
2Touch [Cancel].
•Confirmation screen is displayed. It is executed when [Yes] is selected. 
Exit the menu after it is executed.
∫To print the date
After setting the number of prints, set/cancel  printing with the recording date by touching 
[Date].
•
Depending on the photo printing store or the printer, the date may not be printed even if you set 
to print the date. For further information, ask at your photo printing store or refer to the 
operating instructions for the printer.
•The date print feature is disabled for pictures that are stamped with text.
Note
•The number of prints can be set from 0 to 999.•Depending on the printer, the date print settings of the printer may take precedence so check if 
this is the case.
•It may not be possible to use the print settings  with other equipment. In this case, cancel all the 
settings, and reset the settings.
•If the file is not based on the DCF standard, the print setting cannot be set.•The [Print Set] feature is disabled for motion pict ures and pictures taken with the [Quality] set to 
[].
[Print Set]
3
Select the picture.
[Single] setting
Drag the screen horizontally to select an image, and then 
touch [Set].
[Multi] setting
Touch the picture you wish to print.