Panasonic Cpc+AII/B Digital Business System Release Notes Manual

DBS Release Notes
CPC-EX, Version 1 .O (Preliminary)Panasonic@June 10, 1996
to specify Data Length for Serial Port 2...
FFI 2# 2# 15# (3 or 4)#
-f
3=7 bits
4=8 bits
NoteslSerial Port 2 requires a special interface cable.
lSerial Port 2 can be used for Bus Monitor/Maintenance only. You must
continue to use the backplane port (Serial Port 1) for SMDR.
lPort selections are made from the Attendant phone as follows:
to set Serial Port I for...and Serial Port 2 for...
dial ##90Bus Monitor/Maintenance
no...

Panasonic@June 
lo,1996DBS Release Notes
CPC-EX, Version 1 .O (Preliminary)
Tl NetworkingNOTE:
The following inform&on covers Tl Networking features that directly affect CPC-EX
operation. For detailed information regarding 
TI Networking, see “Tl Networking
Reference Guide”, Part 
No.550XlOO01, Section 540.
CPC-EX allows up to 4 DBS’s to be connected together via Tl interface to form a DBS phone
network. Such a network provides the following new features:
lNetwork Extension to Extension Calling.
Call...

Dl3S Release NotesPanasonic@CPC-EX, Version 1 .O (Preliminary)
June 
lo,1996
Node 3 - leading digit 3
Node 4 
- leading digit 4Figure 15. Tl Network Extension Numbering.
Node 1
Extension XXX
Tl Node Network Trunks
Node 2
Extension 2XXX
When an extension in one node is called via the intercom from an extension in a different node, the
called extension rings 
- Intercom Voice Calling and OHVA do not work when calling from one node
to another.
The DBS determines how to route the calls based on the network...

Panasonic@June 
lo,1996DBS Release Notes
CPC-EX, Version 1 .O (Preliminary)
Paging Across Nefwork Nodes
Every node can allow or deny network paging for each class of service.
Network Route Selection
A’new option is available for Forced Least Cost Routing to include network route selection. This
option provides 50 6-digit entries which determine how dialed numbers are routed through the
network for optimal cost performance.
For example, if Node 1 of a networked system is in the 20 1 area code and Node 2...

DBS Release NotesPanasonic@CPC-EX, Version 1 .O (Preliminary)June 
lo,1996_. .
Independent Node Attendant Assignment
A central network operator can be assigned for Dial 0 access from any node. Each node can
independantly designate a network attendant. For example, Nodes 
1,2 & 3 can send Dial 0 calls to
the attendant on Node 1, while Node 4 sends Dial 0 calls to its local attendant.
Settings Modified for Networking
The following programming addresses have been modified to add parameters necessary for Tl...

Panasonic@June 
lo,1996
DES Release Notes
CPC-EX, Version 1 .O (Preliminary)
SMDR Printing Mode I: Outbound and Inbound
DescriptionSMDR data sent to Serial Port 1 can now include Network Calls also.
Programming
to specify the call type to be included in SMDR...
FFl 2# 2# 6# (0 r 2)#
O=Include outbound calls only
l=Include both inbound and outbound calls
new-W 2=Include inbound, outbound, and network calls
TI Trunk Type
DescriptionThe setting for Tl Trunk Type now includes a parameter for E&M Network....

DBS Release NotesPanasoniaBCPC-EX, Version 1 .O (Preliminary)June 10.1996
Extension Numbers
DescriptionThe address for extension number assignments has been modified to allow for
4-digit extensions.
Programming
I
to assign extension numbers to ports...FF3 (l-l 
44)# I# (1OO-N699)#
+
Extension PortExtension Number
Defaults: Port l=lO, 100, or 1000
Port 2=11,101, or 1001
Port 
3=12,102, or 1002
etc.
Note: N=DBS network node number l-4
Forced LCR/NRS
DescriptionThe address for Forced Least Cost Routing has...

Panasonic@D6S Release Notes
June lo,1996CPC-EX, Version 1 .O (Preliminary)
Other Changes to Programming Addresses
Flexible Function Screen Soft-Key Assignments (FFl 2# 7# 2539# (I-lO)# (xxxxxxxx)#) and FF
Key Assignments have been modified to allow up to S-digit entries.
New Programming Addresses
New programming addresses have been added to support Tl Networking. These new addresses are
applicable only in a networked environment and can be ignored in a stand-alone (non-networked
DBS). Refer to the Tl...

DBS Release NotesPanasonic@CPC-EX, Version 1 .O (Preliminary)
June 
lo,1996
Modification to Toll Restriction Service
DescriptionThe program address for TRS Operator Access (FF7 l# lS#...) has been modified
to allow an extension to dial “O+NXX” phone numbers, even if “O-only” dialing is
denied.
Four settings are possible. See Table 5 for descriptions.
ProgrammingFF7 
I# 18# (l-l 44)# (093)#
fz
Extension PortSee Table 5
Table 5.TRS Operator Access settings
IF EQUAL ACCESS CODE FORMAT IS:
0 
= Old Format...

Panasonic@DBS Release Notes
June 
lo,1996CPC-EX, Version 1 .O (Preliminary)
IF EQUAL ACCESS CODE FORMAT IS:IF EQUAL ACCESS CODE FORMAT 1s:
0 = Old Format (10XxX ONLY)1 = New Format (1OlXXXX ONLY)
SettingActionType of CallSettingActionType of Call
1Allow“O-only” and “OO-only” only calls.1Allow“O-only” and “OO-only” calls.
“IOXXXO-only” calls.“101XXXXO-only” calls.
Allow/Deny 
“0” + additional digits per TRS tables.Allow/Deny “0” + additional digits per TRS tables.
“00” + additional digits per TRS...