OKI C711n User Manual

							
61 – C610/C711 User’s Guide
Make Cipher 
KeyExecuteResets a cipher key to be used on an 
encrypted 
SD card.
When this processing is done, all data 
stored on the 
SD card cannot be restored.
After execution, the following confirmation 
messages will appear.
Are You Sure?  Yes / No
No = display returns to the previous menu.
Yes = the printer automatically reboots and 
the cipher key reset is executed.
Display Conditions:
• SD Card implementation
• An encrypted SD card function is enabled.
ITEMSETTINGSEXPLANATION
Downloaded From ManualsPrinter.com Manuals 
						

							
62 – C610/C711 User’s Guide
Storage Setup
Note:
This menu only displays if the optional SD card is 
installed.
ITEMSETTINGSEXPLANATION
Check File 
SystemExecuteResolves mismatch between actual memory 
and displayed memory available in a file 
system. Performs administration data (FAT 
information) recovery. Performs recovery only 
for an SD Card.
Check All 
SectorsExecutePerforms recovery of defective SD Card sector 
information and a file system mismatch 
mentioned above. 
Enable SD 
CardNo
Yes
Even if a machine is inoperable at installation 
because of a faulty SD Card, the machine can 
be made operable by setting this parameter to 
No  (ignores the existence of the SD Card).
When No is set, access to a SD Card results in 
FAIL because the SD Card is regarded as not 
attached.
After setting change and exit from the menu, 
the printer will restart.
Erase SD 
CardExecuteDeletion of all data stored in the SD Card. 
DoD 5220.22-M sanitizing formula is used for 
clearing the card. Th e machine will restart 
after changing setup. The following message 
appears after pressing the Enter button.
Are You Sure?  Yes / No
No = return to the source menu.
Yes = the procedure for clearing disk stars 
immediately after the machine reboots.
If the Cancel button is held down during 
erasing, the following confirmation messages 
will appear to discontinue processing.
Do You Wish to Cancel?  Yes / No
No= procedure will continue.
Yes = procedure will discontinue. 
Downloaded From ManualsPrinter.com Manuals 
						

							
63 – C610/C711 User’s Guide
Enable 
initializationNo
Ye s
Prevents a setting change accompanying 
initialization of Block Device (SD Card, 
FLASH).
ITEMSETTINGSEXPLANATION
Downloaded From ManualsPrinter.com Manuals 
						

							
64 – C610/C711 User’s Guide
Power Setup
Language Setup
ITEMSETTINGSEXPLANATION
Peak Power 
ControlNormal
Low
Sets Peak Power Control level.
Power SaveEnable
Disable
Sets Enable/Disable of Power Save Mode.
SleepEnable
Disable
Sets Enable/Disable of Sleep Mode.
USB Host 
PowerOff
On
Set power supply for USB-HOST of the whole 
power save mode.
When Off, suppress power supply.
When On, do normal power supply.
ITEMSETTINGSEXPLANATION
Language 
initializeExecuteInitializes the message file loaded in FLASH.
When you press the Enter button, the 
following message, requesting confirmation, 
will appear, 
Are You Sure?  Yes / No
No = return to the source menu.
The procedure for clearing the disk will start 
immediately after the menu and rebooting.
Downloaded From ManualsPrinter.com Manuals 
						

							
65 – C610/C711 User’s Guide
Print Statistics   
ITEMSETTINGSEXPLANATION
Enter PasswordXXXXEnters a password to enter Print 
Statistics menu.
The default value is 0000.
The password for entry to Print 
Statistics is different from the 
password for entry to Functions-Admin 
Setup.
“Print Statistics” category is not shown 
when Print Statistics function is not 
supported.
Usage ReportEnable/
Disable
Enables/Disables the printing of the 
Usage Report.
When changing a setting value, the 
printer is rebooted.
Group CounterEnable/
DisableSpecifies if the Group counter is 
displayed in the Usage Report Print.
Enable: Displayed,
Disable: Not displayed.
Conditions for display:
Enable must be selected in Functions/
Print Statistics/Usage Report.
Supplies ReportEnable/
DisableKeeps track of consumable supplies.
When  Enable  is set, the maintenance 
counter is set.
Conditions for display:
Enable must be selected in Print 
Statistics > Usage Report.
Reset Main Counter ExecuteResets the main counter.
When it executes, the following 
message appears.
Are You Sure?  Yes / No
When  No is selected, it returns to 
original menu indication. When  Yes is 
selected, the main counter zero is 
cleared, the menu is passed through.
Display Conditions:
Enable must be selected in Print 
Statistics > Usage Report.
Downloaded From ManualsPrinter.com Manuals 
						

							
66 – C610/C711 User’s Guide
Reset Group 
Counter
ExecuteResets the group counter.
When it executes, the following 
message appears.
Are You Sure?  Yes / No
When No is selected, it returns to 
original menu indication. When  Yes is 
selected, the group counter zero is 
cleared, the menu is passed through.
Conditions for display:
Enable must be selected in Print 
Statistics > Usage Report.
Enable must be selected in Print 
Statistics > Group counter Report.
Reset Supplies 
CounterExecuteResets the frequency of consumable 
exchange (maintenance counter is not 
reset).
 Are You Sure?  Yes / No
When  No is selected, it returns to 
original menu indication. When  Yes is 
selected, the counter returns to zero
Conditions for display:
Enable must be selected in Print 
Statistics > Usage Report.
Enable must be selected in Print 
Statistics > Supplies Report.
Change 
Password
Changes the password.
Enable must be selected in Print 
Statistics > Usage Report
New 
Password
xxxxSets a new password to enter Print 
Statistics menu.
Verify 
Password
xxxxRe-enter new password set to enter 
Print Statistics set in New Password for 
confirmation.
ITEMSETTINGSEXPLANATION
Downloaded From ManualsPrinter.com Manuals 
						

							
67 – C610/C711 User’s Guide
Available Options
See the instructions supplied with the options. 
Duplex (two-sided printing) Unit ___
Oki P/N 70061601
The duplex unit adds the function of two-sided printing, using less 
paper and making large documents easier to handle. It also 
enables booklet printing, which uses even less paper and makes 
large documents even easier to handle.
The duplex unit slides straight into the rear of the printer and 
requires no tools to install.
Additional RAM Memory __________
Oki P/N 70061801 (256 MB), 70061901 (512 MB)
The basic printer model comes eq uipped with 256 MB of main 
memory. This can be upgraded with an additional memory board 
of 256 MB or 512 MB, giving a maximum total memory capacity of 
768 MB.
Installation takes a few minutes, and requires a medium size 
cross-head (phillip s-type) screwdriver.
Downloaded From ManualsPrinter.com Manuals 
						

							
68 – C610/C711 User’s Guide
SD Card _______________________
Oki P/N 70061701
The optional SD card enables collating of printed pages and can be 
used to store overlays and macros, fonts, and secure or proof 
documents waiting to be printed.
Installation takes a few minutes, and requires a medium size 
cross-head (philips  type) screwdriver.
Additional Paper Tray(s) __________
Oki P/N 44274501 
The paper trays hold 530 sheets  of 20-lb. US Bond (75 g/m2) 
paper and require no tools to install.
Downloaded From ManualsPrinter.com Manuals 
						

							
69 – C610/C711 User’s Guide
Troubleshooting
Provided that you follow the recommendations in this guide on the 
use of print media, and you keep the media in good condition prior 
to use, your printer should give years of reliable service. However, 
paper jams occasionally do occur,  and this section explains how to 
clear them quickly and simply.
Jams can occur due to paper misf eeding from a paper tray or at 
any point on the paper path. When a jam occurs, the printer 
immediately stops, and the 
Attention LED on the control panel 
informs you of the even
t. If printing multiple pages (or copies), 
do not assume that, having cleare d an obvious sheet, others will 
not also be stopped somewhere al ong the path. These must also 
be removed in order to restore normal operation.
Downloaded From ManualsPrinter.com Manuals 
						

							
70 – C610/C711 User’s Guide
Major Printer Components and Paper Path     
1. Duplex unit (if fitt ed). 6.  Operator panel.
2. Face-up stacker. 7. Front cover.
3. Paper exit. 8. Paper tray.
4. Fuser unit 9. Addition al paper tray (if fitted)
5. Top cover.
8
9
1
2
3
456
7
Downloaded From ManualsPrinter.com Manuals