OKI C3530 User Manual

C3530 MFP User’s GuideMaintenance > 81
MAINTENANCE
REPLACING CONSUMABLES AND SPARE PARTS
This section explains how to re place consumable items when due.
Only use genuine Oki Original  consumables to ensure the 
best quality and performance from your hardware. Non 
Oki Original products ma y damage your printers 
performance and invalidate your warranty.  
Downloaded From ManualsPrinter.com Manuals 

C3530 MFP User’s GuideMaintenance > 82
CONSUMABLE ORDER DETAILS
   
ITEMORDER NO.
Toner, black, Hi capacity 43459304
Toner, cyan, Hi capacity 43459303
Toner, magenta, Hi capacity 43459302
Toner, yellow, Hi capacity 43459301
Toner, black, Standard 43459404
Toner, cyan, Standard 43459403 
Toner, magenta, Standard 43459402 
Toner, yellow, Standard 43459401
Image drum, black 43460204
Image drum, cyan 43460203
Image drum, magenta 43460202
Image drum, yellow 43460201
Fuser, 120 V  43377001
Fuser, 230 V...

C3530 MFP User’s GuideMaintenance > 83
TONER CARTRIDGE REPLACEMENT
  
The toner used in this printer is a very fine dry powder. It is 
contained in four cartridges: one each for cyan, magenta, yellow 
and black.
Have a sheet of paper handy so that you have somewhere to 
place the used cartridge while you install the new one.
Dispose of the old cartridge responsibly by placing it inside the 
pack that the new one came in. Follow any regulations, 
recommendations, etc., which may be in force concerning...

C3530 MFP User’s GuideMaintenance > 84
1. Lift the scanner.
     
Scanner lift.jpg  
2. Press the cover release (a) and open the top cover of the 
printer (b) fully.
      
Printer top cover open.jpg   
Downloaded From ManualsPrinter.com Manuals 

C3530 MFP User’s GuideMaintenance > 85
   
3. Note the positions of the 4 cartridges.
     
ID Positions.jpg  
         
4. Carry out one of the following:
(a) If you are replacing a tone r cartridge that has been 
supplied with your printer (release lever has 3 
positions), pull the colored toner release lever on the 
cartridge to be replaced towards the front of the 
WARNING!
If the printer has been po wered on, the fuser may be 
hot. This area is clearly labelled. Do not touch it.
1. Cyan cartridge 2....

C3530 MFP User’s GuideMaintenance > 86
printer, in the direction of the arrow, but stop at the 
central (upright) position.
   
Toner 3 positions.jpg  
(b) If you are replacing any other toner cartridge (lever 
has 2 positions), pull the colored toner release 
lever (1) on the cartridge to be replaced fully 
towards the front of the printer.
5. Lift the right-hand end of the cartridge and then draw the 
cartridge to the right to release the left-hand end as 
shown above, and withdraw the toner cartridge...

C3530 MFP User’s GuideMaintenance > 87
6. Put the cartridge down gently on to a piece of paper to 
contain any toner spillage.
   
7. Remove the new cartridge fr om its box but leave its 
wrapping material in place for the moment.
8. Gently shake the new cartridge from end to end several 
times to loosen and distribute the toner evenly inside the 
cartridge.
    
To n e r  s h a k e . j p g  
CAUTION!
The green image drum surf ace is very delicate and 
light sensitive. Do not touch it and do not expose...

C3530 MFP User’s GuideMaintenance > 88
9. Remove the wrapping material and peel off the adhesive 
tape from the underside of the cartridge.
    
Ta p e  o f f . j p g  
10. Holding the cartridge by its top center with the colored 
lever to the right, lower it into the printer over the image 
drum unit from which the old cartridge was removed.
11. Insert the left end of the cartridge into the top of the 
image drum unit first, pushing it against the spring on the 
drum unit, then lower the right end of...

C3530 MFP User’s GuideMaintenance > 89
12. Pressing gently down on the cartridge to ensure that it is 
firmly seated, push the colored lever (1) towards the rear 
of the printer. This will lock the cartridge into place and 
release toner into the image drum unit.
   
Toner cartridge lock.jpg  
13. Close the printer top cover and press down firmly so that 
the cover latches closed.
14. Gently  lower the scanner on to its supports.
IMAGE DRUM REPLACEMENT
  
There is no need to switch the MFP off when...

C3530 MFP User’s GuideMaintenance > 90
1. Lift the scanner.
     
Scanner lift.jpg  
2. Press the cover release (a) and open the top cover of the 
printer (b).
      
Printer top cover open.jpg  
Downloaded From ManualsPrinter.com Manuals