Home > Nortel > Communications System > Nortel Modular Ics 6.1 Programming Record Manual

Nortel Modular Ics 6.1 Programming Record Manual

Here you can view all the pages of manual Nortel Modular Ics 6.1 Programming Record Manual. The Nortel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 111

102
Modular ICS 6.1 Programming RecordP0603536   02
Telco featuresThese commands allow you to assign settings for external voice messaging 
services.
 VMsg ctr tel#sThese commands allow you to determine which voice message center the set 
will use, and how it will access the network.
 VMsg center 1
 VMsg center 2
 VMsg center 3
 VMsg center 4
 VMsg center 5Choose the voice message center you want the set to use.
 Use: line| routing tblSelect whether the set will access the voice message...

Page 112

103
P0603536   02Modular ICS 6.1 Programming Record
 Protocol
 PrivNetId
 Discon timerSpecify the duration of an Open Switch Interval for a Trunk Cartridge.
 Answer timerSelect the minimum duration, in seconds, of an answer signal before a call is 
considered to be answered, for an E&M trunk cartridge.
 CO failSelect the carrier failure standard used by your T1 service provider. 
This setting only appears for DTIs.
 I/F levelsInterface levels defaults to the ISDN loss plan setting....

Page 113

104
Modular ICS 6.1 Programming RecordP0603536   02
 D-packet servceConfigure the D-packet service for this loop. 
Only one loop on each card can support D-channel packet service.
 D-packet servceTurn the D-packet service for this loop on or off.
 Lp001Select the loop that supports the D-packet service:
 S-loop (for BRI-ST Card) 
 LT-loop (for BRI-U2 or BRI-U4 Card)
 TEIsAdd up to eight Terminal Endpoint Identifiers (TEIs). 
Each TEI is supplied by your service provider. A TEI is...

Page 114

105
P0603536   02Modular ICS 6.1 Programming Record
 ConfigUse to configure the settings for the SDI.
 PtlSelect the physical interface  used to connect the SDI to the networking 
equipment.
 DS0 rateSelect the transmission rate of the channels (Fixed lines) assigned to the SDI.
 TxClk srcSelect whether data travelling through the SDI is synchronized using timing 
(clocking) from the SDI or the DTE.
 TxClk invrsnInvert the signal used by the SDI to synchronize data from the DTE to...

Page 115


				            

Page 116

Meridian, Norstar, and Companion are trademarks of Nortel Networks Corporation.
Meridian, Norstar and the Business Communications System are manufactured by Nortel Networks Corporation.
This document is for use with Norstar Modular ICS and Norstar Modular ICS-XC 6.1 systems.
© 2003 Nortel Networks Corporation
All rights reserved
P0603536   02
Printed in Canada 
Start reading Nortel Modular Ics 6.1 Programming Record Manual

Related Manuals for Nortel Modular Ics 6.1 Programming Record Manual

All Nortel manuals