NEC Neax 2400 Ipx Circuit Card System Manual

CHAPTER 3 NDA-24318
Page 34
Issue 1
OFFICE DATA PROGRAMMING
13. When all lines of an IPTRK circuit card are busy, alternate routing to C.O. line or Tie line is available.
Details on alternate routing patterns are shown in the table below:
14. PAD can be provided for RECEIVE control only.
15. This feature does not support Broad Band Services H0, H1 of ISDN/CCIS line. This feature supports 1B
only.
16. This feature does not support any OAI/ACD services.
17. Depending to the firmware version of the IPTRK...

NDA-24318 CHAPTER 3
Page 35
Issue 1
OFFICE DATA PROGRAMMING
STEP 2:ACRD - Assign Route Class Data of speech routes. It is not required to assign the signal route data.
IPTRK circuit card assigned by the AFCH command is used as the FCCS signal channel controlling
card. An example data assignment is shown in the following figure.
Figure 3-9   Example Data Assignment (ACRD)
Note 1:
 This CDN, TC/EC is used for setting Echo Canceller. Assignment is 0=Echo Canceller OFF, 1=Echo
Canceller ON.
Note 2:This data...

CHAPTER 3 NDA-24318
Page 36
Issue 1
OFFICE DATA PROGRAMMING
STEP 3:ACTK - Assign the connection trunk data of IPTRK circuit card. It is not required to assign the trunk
data for D-channel. An example data assignment is shown in the following figure.
Figure 3-10   Example Data Assignment (ACTK)
Note 1:
When the IPTRK circuit card is furnished without a sub board (PZ-8VCTB), only LV0-LV7 of Group 04
are used.
Note 2:When the IPTRK circuit card is furnished without a sub board (PZ-8VCTB), only LV0-LV7 of...

NDA-24318 CHAPTER 3
Page 37
Issue 1
OFFICE DATA PROGRAMMING
STEP 5:AFCH - Assign FCH number (FCHN) to each IPTRK circuit card which is used as the FCCS signal
controlling card.
Figure 3-11   Example Assignment of FCHN
Note:
This setting is an example.
FCHN
1
FCHEN
000040 AFCH command display
Note
 
Node A
HUB IPTRK
Router
(Speech and FCCS Signal)C_RT2
(speech and FCCS Signal)C_RT1
IPTRK
to CPU
FCHN   = 1    
FCHEN = 000040
In this example, FCHN = 1 is assigned to the IPTRK circuit card controlling FCCS...

CHAPTER 3 NDA-24318
Page 38
Issue 1
OFFICE DATA PROGRAMMING
STEP 6:AETH - Assign the following data:
FPC (Fusion Point Code): FPC number (1-253) of the Destination Node
FCHN (FCH Number): FCH Number, specified in Step 5
C_RT (Connection Route): Connection Route Number of speech channel (1-1023)
DST_IP (Destination IP Address): IPTRK IP address of the Destination Node
NEXT_IP (Next IP Address): IPTRK IP address of the Destination Node
Example data assignment is shown in the following figure, and the...

NDA-24318 CHAPTER 3
Page 39
Issue 1
OFFICE DATA PROGRAMMING
STEP 7:ACAN - Assign the Fusion Connection Index Code (FCIC) to Self node FPC:
FPC (Fusion Point Code): FPC number (1 - 253) of the Self node
FCIC (Fusion Connection Index Code): Unique Fusion CICs in Self node
C_LENS (Connection_LENS): IPTRK LENS data (speech channel data) specified in Step 3
Example data assignment is shown in Figure 3-13.
STEP 8:AFRT - Set Connection Route Numbers of the speech channels for the FCHN, which was assigned in...

CHAPTER 3 NDA-24318
Page 40
Issue 1
OFFICE DATA PROGRAMMING
STEP 9:AG IP - Assign IP addresses of IPTRK circuit card and its connected route.
LENS (Line Equipment Number): Assign the first LEN of IPTRK-accommodated
HW block
KIND (Kind of Selection): IPTRK (FCCS)
IPTK_IP (IP Address of IPTRK): IP address of the IPTRK circuit card
DG_IP (IP Address of Default Gateway): IP address of the router
NETMSK (Net Mask of IP Address): Net Mask of IP address
ToS CONTROL: IP Precedence or DiffServ (either)
QoS1 (QoS...

NDA-24318 CHAPTER 3
Page 41
Issue 1
OFFICE DATA PROGRAMMING
Figure 3-14   Example Assignment of IP Addresses of IPTRK Circuit Card and Connected Router
IPTRK
rrr.rrr.rrr.r
IPTRKqqq.qqq.qqq.q
Node A
PO WE RPO WERRouter
Router
(
1) 
To 
Nod
e 
B(
2) T
o Nod
e 
C
(1) (2)
PO WERRouter
IPTRK
sss.sss.sss.s
Node B
IPTRK
ttt.ttt.ttt.t
Node C
PWR
00
0102
0308 0910 1112 13 14 1516 17 18 1920 21 22 2300 0102 03
slot 06/07
070504 06 IPTK_IP   qqq.qqq.qqq.q
 DG_IP   xxx.xxx.xxx.x
 MULT   Point to Mult
04 0506 07 09...

CHAPTER 3 NDA-24318
Page 42
Issue 1
OFFICE DATA PROGRAMMING
3.4.1 FCCS Routing Example Data Sheets
This figure represent example data for FCCS Networking via IP [F-36] (Point-to-Multipoint).
Figure 3-15   FCCS Networking via IP [F-36] [Point-to-Multipoint Connection] Example Data Sheet 1
NEAX2400 IPX
  FPC 1
 IPTRK
IPTRK
C_RT: 100
IP Address: 10.40.221.20
FCHN: 10
C_RT: 100
IP Address: 10.40.221.21
FCHN: Not assigned for this IP trunk
IP Address:
10.40.221.254
PO WE RRouter  Intranet
IP Address:...

NDA-24318 CHAPTER 3
Page 43
Issue 1
OFFICE DATA PROGRAMMING
This figure represent example data for FCCS Networking via IP [F-36].
Figure 3-16   FCCS Networking via IP [F-36] Example Data Sheet 2
NEAX2400 IPX
  FPC 1
 IPTRK
IPTRK
C_RT: 100
IP Address: 10.40.221.20
FCHN: 10
C_RT: 101
IP Address: 10.40.221.21
FCHN: 11
IP Address:
10.40.221.254
PO WE RRouter
IP Address:
10.40.222.254
PO WE RRouter
 IPTRK
NEAX2400 IPX
  FPC 2
C_RT: 150
IP Address: 10.40.222.20
FCHN: 20
 IPTRK
NEAX2400 IPX
  FPC 3
C_RT: 200
IP...