NEC Neax 2400 Imx Wireless System Manual

TABLE OF CONTENTS ND-70290 (E)
Pag e iv
Revision 3.0
This page is for your notes. 

ND-70290 (E) LIST OF FIGURES
Page v
Revision 3.0
LIST OF FIGURES
Figure TitlePage
Figure 1-1 Route Connecting Diagram : Built-in PCS System  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Figure 1-2 Comparison : Standalone Type and Fusion Type   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Figure 1-3 Power Supply from the Built-in PCS System   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Figure...

LIST OF FIGURES ND-70290 (E)
Pag e v i
Revision 3.0
LIST OF FIGURES
Figure TitlePage
Figure 6-3 Make-Busy Set of ZT and Each B Channel   . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 314
Figure 6-4 Make-Busy Cancel of ZT and Each B Channel  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 314 

LIST OF TABLES
Ta b l e T i t l ePage
ND-70290 (E) LIST OF TABLES
Pag e vii
Revision 3.0 Table 1-1 System Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  .  6
Table 1-2 List of PCS Features  . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  10
Table 1-3 List of OG Call Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

LIST OF TABLES ND-70290 (E)
Pag e v iii
Revision 3.0
This page is for your notes. 

ND-70290 (E) PREFACE
Page ix
Revision 3.0
PREFACE
This manual explains the necessary hardware (such as circuit cards, terminal), the data programming, service
features, etc. for the Built-in PCS (Personal Communication System) System. Since this manual describes the only
specific information for the Built-in PCS System, see the existing manuals for the installation, functions, service
features and the system operation/maintenance job of the PBX itself. 

PREFACE ND-70290 (E)
Pag e x
Revision 3.0
This page is for your notes. 

ND-70290 (E) CHAPTER 1
Page 1
Revision 3.0
CHAPTER 1 GENERAL DESCRIPTION
1. GENERAL DESCRIPTION OF SYSTEM
The Built-in PCS System has its CSINT, which interfaces the ZT with the system, mounted in the Port Interface
Module (PIM). The Control Processor Rack (CPR) exclusively designed for the PCS is necessary in the PBX.
Figure 1-1 shows the entire route connecting diagram of this system.
Module structures of the Built-in PCS System are identical to that of the PBX. For more details, see the
“Installation...

CHAPTER 1 ND-70290 (E)
Pag e 2
Revision 3.0
GENERAL DESCRIPTION
Figure 1-2  Comparison : Standalone Type and Fusion Type
Wired Terminal
Standalone Type
Wired Terminal
Built-in PCS System
Wireless Terminal
Wireless Terminal
Wired TerminalWireless Terminal
NEAX2400
   IMX
FCCS
(Fusion Link)
Fusion Type
NEAX2400
   IMX
PS
ZT PSZT
ZT
ZT PS
PS 

ND-70290 (E) CHAPTER 1
Page 3
Revision 3.0
GENERAL DESCRIPTION
2. CONNECTION BETWEEN CSINT AND ZT
Figures 1-3 through 1-5 illustrate connection methods between the CSINT and the ZT. The CSINT and the ZTs
can be connected with two pairs of twisted cable using the following two connection methods - one, line voltage
from the Built-in PCS System and the other, the local power supply.
1. PBX line power from Built-in PCS System.
Line Power from the PCS System is power to the ZT supplied from the PBX.
Figure...