NEC Neax 2000 Ivs2 Installation Procedure Manual
Here you can view all the pages of manual NEC Neax 2000 Ivs2 Installation Procedure Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 411
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS PZ-8PFTB (PFT) NEAX2000 IVS2 Installation Procedure Manual ND-70928 (E), Issue 1.0Page 385 PZ-8PFTB (PFT) Locations of Lamps, Switches, and Connectors Lamp Indications This card has no lamps. Switch Settings This card has no switches. PFT1 PFT0
Page 412
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS PZ-VM00-M (VM) NEAX2000 IVS2 Installation Procedure ManualPage 386ND-70928 (E), Issue 1.0 PZ-VM00-M (VM) Location of Lamps, Switches, and Connectors CPU Board (Top Side) DSP Board (Bottom Side) BIOSHDD TXDRXD MODRI COM2 COM1 SW1-1SW1-4 CPU Board (top side) VM00-M Card Internal modem RST PL0PL3 DSP SWP BL0 BL7 CN3 (VM01 Card Slot) DSP Board (bottom side) MB VM00-M Card
Page 413
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS PZ-VM00-M (VM) NEAX2000 IVS2 Installation Procedure Manual ND-70928 (E), Issue 1.0Page 387 Lamp Indications LAMP NAMECOLOR FUNCTION CPU BoardRXD Green Not used TXD Red Not used MOD Green Not used RI Red Incoming call HDD Red Accessing to the HDD –Built-in hard disk is faulty BIOS Red BIOS programming is in operation –DOS mode has been activated DSP BoardBL0-7 RedRemains lit when the corresponding circuit is in use. Flashes at 60 IPM when the corresponding...
Page 414
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS PZ-VM00-M (VM) NEAX2000 IVS2 Installation Procedure ManualPage 388ND-70928 (E), Issue 1.0 Switch Settings The figure in the SWITCH NAME column and the position in the SETTING POSITION column indicate the standard setting of the switch. When the switch is not set as shown by the figure and , the setting of the switch varies with the system concerned. NOTE 1: When the power is on, flip the MB switch to ON (UP position) before plugging/unplug- ging the...
Page 415
CHAPTER 3 LAMP INDICATIONS AND SWITCH SETTINGS PZ-VM01 (VM) NEAX2000 IVS2 Installation Procedure Manual ND-70928 (E), Issue 1.0Page 389 PZ-VM01 (VM) Location of Lamps, Switches, and Connectors Lamp Indications Switch Settings This card has no switches. LAMP NAMECOLOR FUNCTION PL4-7 Red DSP circuit operating VM01 Card (on VM00 DSP Board)PL4PL7
Page 416
NEAX2000 IVS2 Installation Procedure ManualPage 390 ND-70928 (E), Issue 1.0 This page is for your notes.