NEC Neax 2000 Ivs2 Ccis System Manual

 NEAX2000 IVS2 CCIS System ManualPage 8  ND-70918 (E), Issue 1.0
CHAPTER 1  GENERAL INFORMATION
System Outline
ANALOG NETWORK
When No. 7 CCIS is provided via an analog network, the CCH is connected to the Common
Signaling Channel Controller in the distant office via MODEMs, directly. Voice signals are
transmitted/received through analog trunks (LDT/ODT).
Figure 1-4 shows the system configuration of No. 7 CCIS provided via analog network.
Figure 1-4  No. 7 CCIS with LDT/ODT
MP TDSW DIGITAL PBX
M: Modem...

CHAPTER 1  GENERAL INFORMATION
System Outline
NEAX2000 IVS2 CCIS System Manual    
ND-70918 (E), Issue 1.0   Page 9
CENTRALIZED BILLING
Centralized Billing is a function that transmits billing information at each associated office to the
central office within the same network through the common signaling channels of No. 7 CCIS. In
the No. 7 CCIS of the PBX, the system can transmit, as a local office, its own billing information
to the centralized office or transfer the billing information from other...

 NEAX2000 IVS2 CCIS System ManualPage 10  ND-70918 (E), Issue 1.0
CHAPTER 1  GENERAL INFORMATION
System Outline
Service Conditions for Centralized Billing
If all the PBXs within the network are the IVS, the PBX can be a centralized billing office. In that
case, there are the following conditions:
For Center Office;
 Built-in SMDR cannot be used.
 The output format of the billing information sent to SMDR is the NEAX 2400IMS format.
 The RS port of AP00 can be used to send a billing information to...

CHAPTER 1  GENERAL INFORMATION
System Outline
NEAX2000 IVS2 CCIS System Manual    
ND-70918 (E), Issue 1.0   Page 11
For Local Office using AP00;
 AP00 cannot be used when Built-in SMDR is provided in the local office (CM08>800: 0).
 Billing information of local office cannot be sent to the SMDR of the local office.
 Maximum number of call records which can be sent to Center Office is 3600 per hour.
 When the link between Local Office and Center Office is down, due to such as a failure of 
Center...

 NEAX2000 IVS2 CCIS System ManualPage 12  ND-70918 (E), Issue 1.0
CHAPTER 1  GENERAL INFORMATION
System Outline
Inter-Office Digital Data Transmission through No. 7 CCIS
The PBX can provide Inter-Office Digital Data Transmission through No. 7 CCIS.
When the PBX is an end office in the Inter-Office Digital Data Transmission through No. 7 CCIS
with Digital Interface, the digital signal is transmitted directly. A maximum of 64 Kbps digital data
transmission is available for the direct digital transmission....

CHAPTER 1  GENERAL INFORMATION
CARD NAME AND FUNCTION
NEAX2000 IVS2 CCIS System Manual    
ND-70918 (E), Issue 1.0   Page 13
CARD NAME AND FUNCTION
Table 1-1 shows the circuit card name and function for No. 7 CCIS.
Table 1-1  Card Name and Function 
EQUIPMENT 
NAMEFUNCTIONAL
NAMEFUNCTION
PN-AP00-B AP00 Application Processor Card
Provides four RS-232C ports, and is used for SMDR, 
Hotel Printer, CIS, PMS, MCI, CS report functions.
One card per system.
PN-CP14 MP Main Processor Card
Provides Memory, TDSW...

 NEAX2000 IVS2 CCIS System ManualPage 14  ND-70918 (E), Issue 1.0
CHAPTER 1  GENERAL INFORMATION
CARD NAME AND FUNCTION
PN-M10 M10 Optical Interface Card
Provides internal optical modem for digital network or 
Remote PIM.
Line length: 10 km (6.2 miles) or less
Line coding: CMI
PN-2ODTA ODT 2-line Out Band Dialling Trunk Card
Used as either a 2-wire E&M trunk or a 4-wire E&M 
trunk. Equipped with –48 V DC-DC on-board power 
supply.
Both No. 0 and No. 1 circuits must be set to the same 
purpose (2-wire or...

CHAPTER 1  GENERAL INFORMATION
CARD NAME AND FUNCTION
NEAX2000 IVS2 CCIS System Manual    
ND-70918 (E), Issue 1.0   Page 15
PZ-M537 EXPMEM Memory Expansion Card for MP/AP00 Card
The system capacity is expanded as follows:
When mounted on PN-CP14 (MP) card:
 
When mounted on PN-AP00-B (AP00) card:
 
PZ-M542
[For Other 
Countries]CONN Coaxial Cable Connection Card
Used to connect a coaxial cable for the Digital Trunk 
Interface.
Max. two cards can be connected to LTC connector of 
each PIM. Table 1-1...

 NEAX2000 IVS2 CCIS System ManualPage 16  ND-70918 (E), Issue 1.0
CHAPTER 1  GENERAL INFORMATION
System Capacity
SYSTEM CAPACITY
No. 7 CCIS with Digital Interface
No. 7 CCIS with Analog Interface
Table 1-2  System Capacity for No. 7 CCIS with Digital Interface
DESCRIPTIONCAPACITY
24DTI 30DTI
DTI Card
84
CCH Card84
AP00 Card (for Centralized Billing) 11
Trunks for DTI192 124
DTI Trunk Routes64 64
Trunks per DTI Card24 31
Table 1-3  System Capacity for No. 7 CCIS with Analog Interface
DESCRIPTION CAPACITY...

CHAPTER 1  GENERAL INFORMATION
Time Slot Assignment Condition
NEAX2000 IVS2 CCIS System Manual    
ND-70918 (E), Issue 1.0   Page 17
TIME SLOT ASSIGNMENT CONDITION
As shown in Figure 1-6, the 30-DTI/CCH cards uses the time slots on the basic highway 4.
However, the following conditions are required on the time slot assignment.
 The total number of time slots for all 30-DTI/CCH card must be less than 128 time slots or 
less including all other application processor (AP) cards, which use the highway 4....