NEC Is15-2k Digital Cinema Projector User Manual

page 6.9
iS15-2K Cinema Projector: User Manual 6. Appendix
Projection lens data
L2K-14ZG L2K-18ZG L2K-22ZG L2K-30ZG
part numbers 102-933 102-934 102-935 102-936
01165056 01165057 01165058 01165059
throw ratio1.45 - 1.8 :1 zoom 1.8 - 2.4 :1 zoom 2.2 - 3.0 :1 zoom 3.0 - 4.3 :1 zoom
full DMD image width 3 - 25m 2 - 19m 2 - 15m 1 - 11m
(9 - 82ft) (7 - 62ft) (5 - 49ft) (4 - 34ft)
throw distance 5 - 45m 5 - 45m 2.2m - 6.9m 5 - 45m
(16 - 148ft) (16 - 148ft) (7.4 - 22.6ft) (16 - 148ft)
lens shift vertical ± 282...

page 6.10
6. AppendixiS15-2K Cinema Projector: User Manual
Notes
For more information about
supported input  formats  see
Specification, earlier in this
section.
For more information about
connecting the projector, see
Connecting the projector , in
2. Installation .
Connections
Cinema Input (SMPTE 292 / HD-SDI) connection
Signal
Ground
SMPTE 292 / HD-SDI signals are very high speed digital signals which req\
uire
better quality coaxial cable than conventional analogue video. The data rate is 1.5...

page 6.11
iS15-2K Cinema Projector: User Manual 6. Appendix
Notes
For more information about
supported input  formats  see
Specification, earlier in this
section.
For more information about
connecting the projector,
including examples of DVI input
configurations, see  Connecting
the projector , in
2. Installation .
Cable complexity and
interference can be reduced by
using the Digilink high
bandwidth optical connection
system. Contact your dealer for
more information.
DVI-D Input connection
1 TMDS Data...

page 6.12
6. AppendixiS15-2K Cinema Projector: User Manual
LAN connection
10BaseT Unshielded Twisted Pair cable
The standard wire colours as as follows:
1 White / Orange stripe
2 Orange
3 White / Green stripe
4 Blue
5 White / Blue stripe
6 Green
7 White / Brown stripe
8 Brown
Notes
For more information about
connecting the projector,
including examples of control
input configurations, see
Connecting the projector, in
2. Installation .
As this projector incorporates a
builit -in hub, only a standard,...

page 6.13
iS15-2K Cinema Projector: User Manual 6. Appendix
Serial control input
1 unused
2 Received Data
3 Transmitted Data
4 Data Terminal Ready
5 Signal Ground
6 Data Set Ready
7 Request To Send
8 Clear To Send
9 unused at present
Null-modem cable
(used to connect the projector to a computer)
RD 2 --- 3 TD
TD 3 --- 2 RD
DTR 4 --- 6 DSR
GND 5 --- 5 GND
DSR 6 --- 4 DTR
RTS 7 --- 8 CTS
CTS 8 --- 7 RTS
Modem settings
• Baud rate 38,400 bps
• Data length 8 bits
• Parity none
• Stop bits one
• Handshaking...

page 6.14
6. AppendixiS15-2K Cinema Projector: User Manual
Remote Control 2
6-4 short external control mode ON
6 open external control mode OFF
3-4 short power ON
3 open power OFF
8-4 short shutter CLOSED
8 open shutter OPEN
When GPIO control is enabled, the remote shutter control on pin 8 will n\
ot work.
Notes
For more information about
connecting the projector, see
Connecting the projector, in
2. Installation .
pin view of female connector 

page 6.15
iS15-2K Cinema Projector: User Manual 6. Appendix
General Purpose Input/Output (GPIO)
37 way D-Connector
1 Ext_GPIN_1_P
2 Ext_GPIN_2_P
3 Ext_GPIN_3_P
4 Ext_GPIN_4_P
5 Ext_GPIN_5_P
6 Ext_GPIN_6_P
7 Ext_GPIN_7_P
8 Ext_GPIN_8_P
9 Ext_GPOUT_1_P
10 Ext_GPOUT_2_P
11 Ext_GPOUT_3_P
12 Ext_GPOUT_4_P
13 Ext_GPOUT_5_P
14 Ext_GPOUT_6_P
15 Ext_GPOUT_7_P
16 Ext_PROJ_GOOD_P
17 N/C
18 Ext_TCODE_P
19 Ext_TCODE_SHIELD
GPIReccomended Operating Current 5mA
Absolute Maximum Current 50mA
Forward Voltage drop @ 5mA...

page 6.16
6. AppendixiS15-2K Cinema Projector: User Manual
Dimensions
without anamorphic lens
All dimensions in mm 

page 6.17
iS15-2K Cinema Projector: User Manual 6. Appendix
Dimensions
with anamorphic lens fitted
All dimensions in mm 

page 6.18
6. AppendixiS15-2K Cinema Projector: User Manual