Motorola Mc9500k Manual

Using the Phone 5 - 27
Figure 5-43    Message Options Window
4.Ta p  Send when youve finished the message.
If the phone is turned on, your text message is sent. If it’s off, you are prompted to turn on the phone. If you do 
so, the message is sent; otherwise when you tap ok, the message is saved in the Drafts folder and sent when 
the phone is turned on.
If you are out of coverage area, the message is saved in the Drafts folder and sent when you return to a 
coverage area.
NOTEOn the MC959X-K, the...

5 - 28 MC9500-K Mobile Computer User Guide
Establishing a MC9596 Data Connection
5.Ensure a SIM card is installed in the MC9500-K.
6.Configure a GPRS data connection. See MC9500-K Series Mobile Computer Integrator Guide.
7.Tap the connectivity icon  ,   or   at the top of the screen.
Figure 5-44    Connectivity Dialog Box
8.Ta p  Settings.
9.Ta p  Connections icon.
10.Ta p  Managing existing connections.
11 .Tap and hold on the data connection until a menu appears.
Figure 5-45    Data Connection...

Using the Phone 5 - 29
Figure 5-46    Connecting Using GPRS
13.If the SIM card is protected with a Personal Identification Number (PIN), a dialog box pops up requesting the 
appropriate PIN to unlock the SIM card. In this case, enter the PIN and tap ok.
14.When a connection is established, launch Internet Explorer to browse the Internet or launch an applicable 
application.
Ending a Data Connection
To cancel a data connection in progress, tap Cancel in the Connecting... dialog window.
To end an...

5 - 30 MC9500-K Mobile Computer User Guide
Establishing an MC9598 Data Connection
A data connection allows Internet access across a wireless network. Data connection is pre-packaged with service 
accounts.
To verify active data service:
1.Ta p  Start > Internet Explorer.
2.In the address bar, enter a URL for a web site.
3.Tap   to display the Connectivity dialog. The dialog box displays the data connection information.
Figure 5-48    Data Connection
Ending a Data Connection
To cancel a data connection in...

Using the Phone 5 - 31
2.Ta p  Disconnect.
NOTETapping Disconnect during an active data transfer (e.g., downloading a web page) automatically reconnects 
the connection. You cannot disconnect the connection until the data transfer is complete
. 

5 - 32 MC9500-K Mobile Computer User Guide 

Chapter 6 Using GPS Navigation
Introduction
The MC9500-K includes Global Positioning System (GPS) technology using the SiRFstar III chipset. GPS 
technology is based on a worldwide system of GPS satellites orbiting the earth that continuously transmit digital 
radio signals. These radio signals contain data on the satellites’ locations and their exact clock time and are used 
to determine your location on the earth.
Software Installation
Third-party GPS navigation software is required. Evaluation...

6 - 2 MC9500-K Mobile Computer User Guide
4.Ensure that the Baud rate drop-down list is set to 57600.
5.Ta p  ok to close the Setting window.
Operation
Acquiring satellite signals may take several seconds to a few minutes. It is best to be outside and have a clear, 
unobstructed view of the sky. Without a clear view, acquisition takes much longer and could result in the MC9500-K 
being unable to compute the initial position quickly. When operating the device indoors access to the GPS signals 
may be...

Using GPS Navigation 6 - 3
A-GPS follows the Secure User Plane Location (SUPL) protocol which allows a mobile device to communicate with 
a SUPL server. Refer to the EMDK Help file for information on setting up SUPL on the MC9500-K. 

6 - 4 MC9500-K Mobile Computer User Guide