Motorola I95cl User Guide

							11
Turning Your i 95cl Phone On/Off
Battery Charging Status
The battery strength indicator icon found on your phone’s display screen shows 
the amount of power in the battery.
When Using Phone
A short, chirp-like sound indicates a low battery. The icon flashes to indicate 
that you have approximately five minutes of talk time remaining.
When Charging Battery
Turning Your i95cl Phone On/Off 
NOTE: To register for the first time on the Nextel National Network, you must turn on 
your i95cl phone in your home market.
Powering the Phone On
Icon 
Display
Battery 
StrengthLow 
Battery11% to 
40%41% to 
70%Fully 
Charged
Icon 
Display
1 flashing bar 1 flashing bar,
1 continuous bar1 flashing bar,
2 continuous bars3 continuous bars
Battery 
St r e ng t hLow 
Battery31% to 
60%61% to 
90%Fully 
Charged
1Open the phone cover.
2For optimal signal strength, extend the antenna.
3Press and hold p on the keypad until the status light glows red, a tone 
briefly sounds, and Powering On displays. 
						

							12
nextel.com
If your display reads No Service or does not change to the idle screen when you 
turn on your phone, and you know you are in a Nextel coverage area, contact 
Nextel Customer Care. For details on Nextel coverage areas, go to nextel.com.
Powering the Phone Off
Enabling Over-the-Air-Radio-Service Software 
(OARSS) Security
To receive OARSS programming, you must enable OARSS security the first 
time you power on your phone or within 20 days of first activation of your 
4If you have enabled your SIM PIN security feature (see “Enabling/
Disabling the PIN Security Feature” on page 14), the Enter SIM PIN 
Code screen displays. Enter your SIM PIN (see “Entering the SIM 
PIN” on page 15).
Press C under OK.
5As your phone connects to the Nextel 
National Network, you will see We l c o m e  
To  N e x t e l and a connecting message. 
When the idle screen appears on the 
display, you are ready to use your i95cl 
phone!
1Press and hold p on the keypad until a tone briefly sounds and 
Powering Off displays.
2Close the phone cover.
3Push down the antenna. 
						

							13
Receiving OARSS Programming
phone. See “Receiving OARSS Programming” on page 13.
Receiving OARSS Programming
If you have been set up to receive OARSS programming, you will receive your 
Private ID and Talkgroup lists for Direct Connect use, your Personal Telephone 
Number and the Nextel Customer Care number via a Net Alert message.
In order to receive your programming, you must have enabled OARSS security 
(see “Enabling Over-the-Air-Radio-Service Software (OARSS) Security” on 
page 12). Within 24 hours of enabling OARSS security, you will receive a Net 
Alert message containing your lists.
Accepting Your Phone’s Programming
1When you power on your phone for the first time, after the idle screen 
appears, you will be prompted to select OK to update your browser info.
NOTE: If you press C under LATER, you will be prompted to enable 
security each time you power on your phone until you press 
C under OK. It is recommended that you do not choose 
LATER.
2Press C under OK. 
3You are prompted to enable security. Press C under YES.                      
A series of screens display. If you subscribe to a Nextel Online Service® 
plan, your home page displays.
4Press * to return to the idle screen. 
1You will receive a Net Alert with the message New Browser Message – 
Receive Programming Info.
2Press C under GOTO.
3You are prompted to accept changes to your phonebook. Press C under 
OK.
4A confirmation screen displays. Press C under OK.
5You are prompted again to accept changes to your phonebook. Press C 
under OK. 
						

							14
nextel.com
SIM Card
Your phone comes with a built-in level of security protection through the use of 
the SIM card. The SIM card stores all your Phonebook information and your 
Nextel account identification information. Since this information is stored on 
the SIM card, not in your phone itself, you can remove the information by 
removing the SIM card.
NOTE: Except for making emergency calls, your phone will not function without the 
SIM card.
The SIM card is located in the SIM card holder on the back of the phone, 
underneath the battery. You can verify the SIM card is in place by removing the 
battery and viewing the SIM card through the SIM card cover.
See “Inserting/Removing the SIM Card” on page 17 for information on locating 
the SIM card. If there is no SIM card in your phone, notify your Nextel 
Authorized Representative.
SIM Card Personal Identification Number (PIN) 
To prevent unauthorized use of your account, you can protect your SIM card by 
enabling the SIM PIN security feature. With the SIM PIN enabled, you must 
enter your PIN each time the phone is powered on. You can change or disable 
your PIN if desired.
NOTE: It is recommended that you enable the SIM PIN security feature to prevent 
fraudulent use of the SIM card.
Enabling/Disabling the PIN Security Feature
When the PIN security feature is enabled, you are prompted to enter your PIN 
each time you turn on your phone. Until a valid PIN is entered, you can use the 
phone only to make emergency calls. 
After the PIN is accepted, the phone registers on the network and the idle screen 
displays.
When the PIN security feature is disabled, the phone can be used without 
entering a PIN.
IMPORTANT: It is recommended that you enable the PIN security feature to protect 
personal data on your SIM card. This prevents anyone from using your 
phone and accessing your personal data.
6A confirmation screen displays. Press C under OK.
7Press * to return to the idle screen. 
						

							15
SIM Card
Once you have enabled the SIM PIN security feature, it is recommended that 
you change your PIN to a number known only to you (see “Changing the PIN” 
on page 16).
Entering the SIM PIN
IMPORTANT: Incorrectly entering your PIN three times causes the SIM card to be 
blocked. To unblock your SIM card, you must contact Nextel Customer 
Care. For more information, see “Unblocking the PIN” on page 16.
1At the idle screen, press q and then press R to scroll to Settings.
2Press C under SELECT. The Settings screen displays.
3Press R to scroll to Security. Press C under SELECT to access the 
Security screen.
4At the Security screen, press R to scroll to SIM PIN. Press C under 
SELECT to access the SIM PIN screen. 
5Press R to scroll to On or Off. On enables the SIM PIN security 
feature; Off disables the SIM PIN security feature. Press C under 
SELECT.
6At the Verify SIM PIN Code screen, enter the current SIM PIN and 
press C under OK.
NOTE: The default SIM PIN is 0000.
1From the Enter SIM PIN Code screen, enter 
your 4- to 8-digit PIN. An asterisk appears for 
each character entered. The default SIM PIN is 
0000.
NOTE: Other than emergency dialing, you will be unable 
to use any of the phone functions, including 
receiving phone calls, until you enter the PIN.
2Press C under OK. 
						

							16
nextel.com
If you enter an incorrect PIN, the message SIM PIN incorrect: Try again 
appears on your phone’s screen. After three consecutive incorrect attempts, the 
SIM card is blocked. Once blocked, the phone will not allow you to enter your 
PIN again, even after powering the phone off and back on. If this happens, see 
“Unblocking the PIN” on page 16.
Changing the PIN
NOTE: In order to change the PIN, the SIM PIN security feature must be set to On. See 
“Enabling/Disabling the PIN Security Feature” on page 14.
Unblocking the PIN
If you forget your PIN and unsuccessfully try to enter it three times, access to 
your phone will be blocked.
NOTE: Before you begin, obtain the PIN Unblocking Key (PUK) code from Nextel 
Customer Care, then read and understand the PIN unblocking sequence. 
When entering the key press sequence, each key press must occur within 5 
seconds of the prior key press.
1From the idle screen, press q and then press R to scroll to Settings.
2Press C under SELECT. The Settings screen displays.
3Press R to scroll to Security. Press C under SELECT to access the 
Security screen.
4At the Security screen, press R to scroll to New Passwords. Press C 
under SELECT to access the New Passwords screen.
5At the New Passwords screen, press R to scroll to SIM PIN and press 
C under SELECT.
6At the Enter Old SIM PIN Code screen, enter the current SIM PIN 
and press C under OK.
NOTE: The default SIM PIN is 0000.
7At the Enter New SIM PIN Code screen, enter a new 4- to 8-digit SIM 
PIN and press C under OK.
8At the Re-enter New SIM PIN Code screen, re-enter the new SIM PIN 
to confirm, and press C under OK. 
						

							17
SIM Card
IMPORTANT: If you unsuccessfully enter the PUK code ten times, the SIM card is 
permanently blocked and must be replaced. If this happens, all data will 
be lost. You will get a message to contact your service provider. Contact 
Nextel Customer Care for assistance. If the SIM card is blocked, the i95cl 
phone only allows outgoing Emergency calls.
Inserting/Removing the SIM Card
IMPORTANT: If you remove your SIM card and insert another SIM card into your 
phone, some information does not display when you use the phone with 
the new SIM card. All Phonebook information remains stored on your 
original SIM card. The following information does not display:
IMPORTANT: Do not touch the gold-colored areas of the SIM card.
To avoid loss or damage, do not remove your SIM card from your phone 
unless absolutely necessary.
Inserting SIM Card
1Press * * 0 5s.
2Enter the 8-digit PUK code.
3Press s.
4Enter a new 4- to 8-digit SIM PIN and press s. 
5Re-enter your SIM PIN and press s. If you entered the codes properly, 
the SIM Unlocked screen displays.
  Datebook events   Recent Calls list
  Voice Records   Call filtering settings in Styles
  Call Forwarding settings   Information stored in Memo
  Net Alert notifications   Browser Bookmarks
  Voice names for Phonebook entries and Shortcuts
1With the phone powered off, remove the battery cover and battery. See 
“Detaching the Battery” on page 10. 
						

							18
nextel.com
2With the external display facing away 
from you and the back of the phone 
exposed and facing up, locate the 
SIM card holder.
3Hold the SIM card with the gold contact 
side facing down and the cut corner in the 
lower left. Do not touch the gold-colored 
areas of the SIM card.
4Carefully slide the SIM card to the right and into 
the phone, until it lies flat in the SIM card holder.
SIM card 
holder
cut corner 
						

							19
SIM Card
Removing SIM Card
NOTE: To remove your SIM card, you need a ballpoint pen.
1With the phone powered off, remove the battery cover and battery. See 
“Detaching the Battery” on page 10.
2With the antenna pointing up and the back of 
the phone exposed and facing up, insert the 
tip of a ballpoint pen into the slot, which is to 
the right and along the right edge of the SIM 
card. 
3With your other hand, gently press the PUSH 
tab, which is to the left of the SIM card. Hold 
this tab down. 
4While holding the tab down, slide the SIM card to the left by moving 
the ballpoint pen to the left within the slot. 
slot
tab 
						

							20
nextel.com
Status of Your i95cl Phone
Your i95cl phone’s status light is located on the top right side of the phone, near 
the cover hinge. The status light indicates the status of your connection.
My Information
You can select My Info from the main menu to display or edit the following:
Name–enter your name in this field.
Private ID–your Private ID is displayed in this field. Your Private ID 
is your Nextel Direct Connect number and is composed of three parts:    
Area ID*NetworkID*Member ID. For example: 999*999*9999.
NOTE: The asterisks are part of your Private ID.
5When the ballpoint pen has moved the SIM card to the left as far as 
possible, very carefully lift the SIM card out of the phone. Do not touch 
the gold-colored areas of the SIM card. 
NOTE: Protect the SIM card as you would any delicate object. When the SIM card 
is not in the phone, you should store it in something protective, such as a 
mailing envelope.
Statu s Li g ht 
Indicatori95cl Phone Status
Flashing RedSigning on to the network. Please wait.
Solid RedNo service or out of coverage area.
If you are in a coverage area, keep your phone on 
and it will attempt to connect to the network every 
two minutes. If the phone does not connect after 15 
minutes, contact Nextel Customer Care.
Flashing GreenIn service/Ready to use.
NOTE: Nextel Direct Connect is only available in your 
home calling area.
Solid GreenIn use.