Mitel Voice Processing Solutions Instructions Manual

Software Installation and Configuration 
Table 4-1 Configuration Parameters for Unified TCP/IP 
Parameter Description 
Domain Name A name for a series of nodes, attached to the node name to form a complete 
internet site name. For examples, if the domain name is centigramcorn, prepending 
the node name vmGO0 creates an internet site name of vmGOO.cen~igram.com. 
Current Module The module number where the Ethernet card is installed, from 1 to 4. The default 
Number is 1. 
Enable/Disable Specify whether...

Software Installation and Configuration 
Unified TCPllP Application Worksheet 
l 
~ 
Node name Domain name 
Full card name 
vmemo.cen”cigram.com 
+ t 
vmemo 
centigram.com 
Card and Network Card 
Configuration h;;;to$sable aE Q D 
configuration ’ cl” 
Node name 
vmemo Node IP address 1’29.3.74.160 
Subnet mask 
Broadcast 
address 255.255.0.0 
129.3.0.0 Network number 3 
I 
Operation mode 
tip LP Current card slot 4 
number El 
Gateway IP 
address 
129.3.75.7 TELNET 
configuration cl’ fiD 
Dependent...

Software installation and Configuration 
ecting the Server to ork 
Note: For complete step-by-step directions, refer to the procedures at the 
end of this chapter. 
The Ethernet card has an RJ-45 port which allows connection to unshielded twisted- 
pair (1 OBaseT) Ethernet wiring. Insert the RJ-45 plug into the RJ-45 port on the 
Ethernet card. The other end of the wire should be connected to a prewired wall 
jack or a concentrator or hub on your network. 
Verify the connection by powering on both the...

:, 
Software Insrallacion and Configuration 
If you cannot communicate over the network, you must check both the hardware 
and the software for problems. 
Check the following for hardware problems: 
Ensure the card is firmly seated in its slot and that it is receiving power. 
Check the wiring connection to both the card and the wall jack or 
concentrator. 
Check that your card is configured for an RJ-45 connector (jumpers 2 
and 3). See Chapter 3 for information on card jumpering. 
Ensure that the wiring...

Software Installation and Configuration 
Pinging host cgram: 188.15.7.20 
ICMP Echo Reply: TTL 60 
ICMP Echo Reply: TTL 60 
ICMP Echo 
Reply: TTL 60 
ICMP Echo 
Reply: TTL 60 
Host cgram replied to all 4 of the 4 pings. 
Figure 4-3 Successful Ping Results 
If this succeeds, the sofnvare is probably set correctly. 
ote: If pinging the module name does not work, ping the module II? 
address. If the II’ address works, there is a problem with name 
services on your network 
(/etc/hosts has the wrong values...

re 
Page 1 of 1 
VoiceMemo Release 6.OA and later 
Task Procedure 
Unified TCP/IP Software Procedures 
Unified TCP/IP Optional Feature Installation ................................... Cl?6470 
Install and Configure Unified TCP/IP Software.. ..................................... Cl? 6471 
Install an Optional Feature.. ..................................................................... CP 5402 
Test Unified TCP/IP Configuration ......................................................... CP 6472 
Dot. Rev. A  

Install Optional Feature With System Online 
Page 1 of 2 
VoiceMemo Release 6.OA and later 
The procedure describes how to install an optional feature with the Series 6 server 
online. Be sure the Optional Feature Diskette(s) and the Module Enable Diskette 
contain the serial number(s) for all disk(s) in the system. 
ate: The serial number on the Optional Feature diskette must match the serial 
number of the hard disk on which the software is being installed. If you 
receive an error message about an...

Cl? 5402 
Page 2 of 2 
VoiceMemo Release 6.OA and later 
step 
6. The following prompt appears: 
Prompt: 
Wait for paging queues to be empty? 
Response: N to continue. 
7. Exit to the VoiceMemo Configuration - Main Menu, then go to the VoiceMemo 
Configuration - Offline Menu. 
8. Duplicate the active configuration. 
Select: (B) Duplicate Active Configuration 
9. Exit to the VoiceMemo Configuration - Main Menu and activate the configuration. 
Select: (A) Activate Configuration Reference 
Llenu Map 2 
Doe....

Cl? 
Unified TCP/IP Optional Feature Installation 
Page 1 of 1 
VoiceMemo Release G.OA and later 
This procedure gives an overview of how to install, configure, and test both hardware and 
software for the Unified TCP/IP Optional Feature. This feature allows you to put your Series 6 
server on an Ethernet network and communicate with other nodes attached to the network. It 
also allows you to use Ethernet communications with the MESA-Net and OneView optional 
features. 
Step 
T- 
1. 
2. 
3. 
4. 
5. 
6....