Home > Mitel > Communications System > Mitel Sx 50 Dpabx Instructions Guide

Mitel Sx 50 Dpabx Instructions Guide

Here you can view all the pages of manual Mitel Sx 50 Dpabx Instructions Guide. The Mitel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 11

General Description 
Cover 
2.4 The dimensions of the impact-resistant plastic moulded Cover are shown in Figure 
2-5. It weighs 2.94 kg (6.48 lb) and covers and protects the complete SX-50 system. 
Natural convection cools the system through vents on the top and bottom. An integral 
keylock prevents unauthorized access. 
55.2 cm 
(21.7in.) 
- 
CID0020 
. 
Figure 2-5 Cover 
100 2-6 Revision 0 9104-091-lOO-NA issue 5  

Page 12

Physical Description 
Power Supply 
2.5 
The Power Supply unit (see Figure 2-6) mounts on the left side of the Card Frame. 
It is cooled by natural convection. Figure 2-7 shows the dimensions of the Power 
Supply. The weight of the Power Supply unit is 3.28 kg (7.2 lb). The Power Supply 
provides system power from a 120 Vat commercial power input. The front panel 
is 
equipped with the following: a 3-prong ac power supply input, an ON/OFF switch, a 
5 Amp slow-blow fuse, and two studs. The studs are...

Page 13

General Description 
I 
. 
0 
30.6 cm 
(12.1 in.) 
0 0 
P 0 
DD0004 
100 2-8 
Figure 2-7 Power Supply Dimensions 
Revision 0 9104-091-l 00-NA Issue 5  

Page 14

Physical Description 
Control Card 
2.6 The Control Card slides into the Card Frame from the right side, parallel to the wall. It 
plugs directly into the Power Supply unit, forming a backplane for the peripheral 
cards, It contains the following hardware: 
l Central Processing Unit (CPU), _ 
l DX switching matrix (switches voice and data), 
l Digital Signal Processor (tone generation, tone detection and conference circuits), 
l Five DTMF receivers, 
l Timing and control circuits, 
l Watchdog Timer...

Page 15

General Description 
The Control Card 2 (MCC2) has a six-pin connector, similar to the Night Bell connector, 
on the right:hand side of the card. The Music/Pager/Relay connector allows external 
:usic and paging equipment to be connected directly to the SX-50 DPABX. Pinouts 
;3r the connector are as follows: 
l Pin 6 (closest to the -/-segment display) and Pin 5 connect to a relay contact; 
. Pins 4 and 3 connect to an external paging amplifier; 
l Pin 2 and Pin 1 (closest to J4) connect to a music...

Page 16

Physical Description 
: CARDCONNECTOR 
(TO PERIPHERAL CARD) 
EDGE CONNECTOR 
(TO POWER SUPPLY) TEST POINTS 
AC NIGHT BELL 
RELAY A 
: RELAYS 
RETURN C 
: RINGING D 
RESET SWITCH 
STATUS SWITCH 
RS-232 PORT 
Ptl (GENERIC 
MODULE CONNECTOR) 
J4 
(ATTENDANT CONSOLE) 
7-SEGMENT 
DISPLAY 
MUSICIPAGEWRELAY 
-CARD EXTRACTOR 
0 0 0 0 0 0 0 
0 . 0 0 
I 
Due lo space limtitions, the grounding bracket IS not shown 
DDC012Rl 
Figure 2-9 Control Card 2 (MCC2) 
9104-091-l 00-NA Issue 5 
Revision 0 
100 2-11  

Page 17

General Description 
36.8 cm 
(14.5 in.) 
0 0 0 
I I 
C 
a 
28all 
(11 in.) 
4.5 cm 
(1.8 in.) 
. . 
IL 
C 
7 
A 
L 
c 
DD0019i 
Figure 
2-10 Control Card Dimensions 
Peripheral Circuit Cards 
2.8 The SX-50 system>7pperts up to 10 peripheral circuit cards. Located on the front 
edge of the circuit card is a 25-pair connector, LED displays and a plastic handle 
which facilitates the removal of the card from the Card Frame. A sample peripheral 
card is shown in Figure 2-10. 
Peripheral Circuit cards are...

Page 18

Physical Description 
There are seven different types of peripheral cards: 
l On-Premises Stations (ONS) Line Card, 
l Off-Premises Stations (OPS) Line Card, 
l Digital Network Interface Circuit (DNIC) Line Card, 
l Control Over Voice (COV) Line Card, - 
l Loop Start/Ground Start (LS/GS) Trunk Card, 
l Universal Card, and 
l Direct Inward Dial (DID) Trunk Card. _ 
Refer to Table 
2-1, Card and Module Types, for the dimensions and weight of each 
card. 
EDGE 
CONNECTOR 
EDG 2 
POST CONNECTOR 
CABLE TIE...

Page 19

General Description . 
Table 2-l Card and Module Types 
Card/Module Type Dimensions 
Weight 
Control Card/Control Card 2 1 28 cm X 40 cm (11 in. X 15.7 in.) 
1 1 .O kg (2.2 lb) 
Generic Module 
I I 
22.9 cm X 14.6 cm (9 in. X 5.75 in.) 0.37 kg (1 lb) 
ONS Line Card 
OPS Line Card 22.3 cm X 36.8 cm (8.8 in. X 14.5 in.) 
22.3 cm X 36.8 cm (8.8 in. X 14.5 in.) 0.75 kg (1.65 lb) 
0.75 kg (! .65 It?) 
1 I 
DNIC Line Card 22.3 cm X 36.8 cm (8.8 in. X 14.5 in.) 1 0.75 kg.(l.65 lb) 
COV Line Card 1 22.3 cm X...

Page 20

Physical Description 
r- 
c 
c 
r 
1 
1 
3 
2.54 cm 
(1 in.) 36.6 cm 
(14.5 in.) 
Figure 2-l 2 Peripheral Card Dimensions 
9104-091-l 00-NA Issue 5 
Revision 0 100 2-15  
Start reading Mitel Sx 50 Dpabx Instructions Guide

Related Manuals for Mitel Sx 50 Dpabx Instructions Guide

All Mitel manuals