Mitel Fax Memo Manual

# 152 In-ring minimum power 
The line card port uses these parameters for incoming ringing detection. 
l Incoming ringing bursts must be at least as long as the in-ring on-time low 
value, and less than the In ring on time high value. 
l There must be an interval between ringing bursts that is at least as long as the 
in-ring off-time value. 
l Incoming ringing power must be above the in-ring maximum power threshold 
to be detected. 
l When incoming ringing power falls below the in-ring minimum...

DTMF Detection: 
#6 DTMF detect enabled/disabled 
This parameter is used to selectively disable or enable DTMF detection on line card 
ports. DTMF detection normally is enabled; it may be disabled to prevent callers 
OHP 
certain ports from logging into mailboxes, for example. 
#25 Enable DTMF Co1 3 
This line exception enables fourth column DTMF tones (A, B, C, D). Default is 
disabled. 
#32 DTMF receive debounce time 
The DTMF receive debounce time specifies the amount of time apTMF key must be...

#128 Minimum busy half cycle (greet) 
When the greet command is active, the line card uses the minimum busy half cycle 
(greet), together with line exceptions 174 (minimum busy detection time) and #175 
(maximum busy detection time) to determine if a signal it is receiving is a busy tone. 
This parameter also is used with parameters 172 (minimum reorder detection time) 
and 173 (maximum reorder detection time) to detect reorder tone while the greet 
command is active. 
#lO Silence timeout 
#ll Speak...

# 162 Minimum speech frames 
This is the minimum number of consecutive frames of speech (as determined by 
#163) required to set the recording timeout. The Minimum Speech Frames parameter 
prevents recording from stopping after it has started. 
# 163 Minimum miniframes speech 
This is the minimum number of miniframes of speech needed to determine that an 
entire frame contains speech. This parameter also prevents recording from stopping 
after it has started, 
PromDt and MessarJe Outmt Controls: 
r. 
#I4...

APPENDIX III: Line Card Interfkes 
The following line card interfaces are supported by the platform: 
l Loop start-The loop start interface is with 4/8-port loop start line cards. 
l Ground start-The ground start interface is provided with 4/8-port ground start line 
cards. 
l DID-The DID/E&M interface is provided with 4/8-port loop DID line cards. 
l 2-wire E&M-This interface is provided with DID/E&M line cards. Both E&M 
Types I & V are supported. 
l Tl-The platform supports direct digital connections...

4  

1 VoiceMemo Configuration Main Menu 3 Mailboxes 
. 
tem$;tena3RdRL 
System Configuration 
2 VoiceMemo Application 
VoiceMemo Configuration 
Main Menu 
VoiceMemo Configuration 
Clffline Menu 
Line Groups Menu 
(Define Line & Fax Groups) 
( 
A&Gather Menu 
-+ (El or (V-1 Monthly Gather Menu 
I 
VoiceMemo Configuration + 
Online Menu I 
(M) 
II I Day/Night Menu 
I I 
61 
Lt 
Dialing Plan Menu 
(and Star Prefix Dplan) 
Dial String and 
Mailbox Menu I  VoiceMemo Modify 
Application 
II I 
I 
.I 
Dial-by:Name...

5 Paper Application 
Define Pagers Menu 
(Pager systems supported) 
8 Hard llisk Utilities 
Main Menu 
System Maintenance 
Menu 
SCSI Shutdown Menu 
-=i Kedundancy Update 
Menu 
8 Billing 3 Reports 
ceMemo Configuration 
Main Menu 
RS232 Programmable 
Menu !I 
I 
L 
I 
-P 
(data entry parameters) Hard Disk Utilities Menu 
6 RS432 Message Lights Application 
7 ltTMF4o-PtM Message Lights Application 
2ei 
(other reports) 
18 Phoneline Exceptions 
Main Menu ksh 
Menu 
._ :: 
.  ..___ ..a  

11 FGOS,6COS,LCOS,RCOS,NCOS and TCOS 
I Main Menu 
System Maintenance 
Menu 
System Configuration 
Menu 
Feature Class of 
Service Menu 
Even More Limits 
Parameters Menu 
cp, i FaxMemo Limits 
Menu 
FF+&-&/j 
RCOS Selected Menu 
Mh 
NPA/NXX Menu L I 
I 
I “i’ 
Network Class of 
Service Menu 
Tenant Class of 
Service lvbu 
12 System Maintenance 
r I 
II I Auto. Receptionist 
Extensions Menu QL 
I 
- 
t 
Network Menu 
- 
* Utility Menu 
I 
-4 Console ! Serial Port Setup 
Menu 
r 
-4 Alans Maintenance Menu...