Miele Wt 2670 Wpm Operating Instructions

Washing and drying in a
continuous sequence
Where the amount of laundry to be
washed and dried in one programme
does not exceed the maximum
weight permitted for the drying
programme, washing and drying in
one continuous sequence is
recommended.
It is very important to read both the
Washing and Drying sections
before proceeding.
ASort the laundry into colours and
fabric types
BSwitch the machine on
CSelect a programme
^Turn the programme selector to the
required programme.
Minimum iron
^
Press...

DLoad the drum
^Open the drum door and load the
laundry loosely in the drum.
Follow the load size indicator and do
not overload.
Do not use detergent dispensing
aids, e.g. plastic dispenser balls, for
washing followed immediately by the
drying programme. These
dispensers can melt during the
drying programme and cause
damage to the machine and the
laundry.
EClose the drum door
FAdd detergent
Follow the detergent percentage
display.
GStart the programme
^
Press theStart/Stopbutton.
HRemove the laundry when...

^Open the drum doorfully.
,Warning, the metal cap located
on the inside of the door glass is
very hot after drying.Do not touch
it. Danger of burning!
^Remove the laundry.
^Check the folds in the door seal for any
small articles, e.g. buttons which might
be lodged there. Remove any fluff from
drying from around the door seal.
Check that all items have been
removed from the drum. Items left
behind could colour run, shrink or be
damaged in the next washing or
drying programme.
Important:Always remove the...

Cancelling a programme
You can cancel a programme at any
time after it has started.
^Press theStart/Stopbutton briefly or
turn the programme selector toStop.
... During washing:
The suds will be pumped away and the
washing programme is cancelled.
... During drying:
The garments will be cooled down
before the door can be opened.
If you want to remove the laundry:
^Press theDoorbutton.
If you want to select a different
programme:
^Switch the machine off with theI-On/
0-Offbutton.
^Switch the machine back...

Altering the spin speed
^Press theOKbutton. The spin speed
will be shown highlighted. You can
use the–and+buttons to change
the spin speed up until the final spin
begins.
You can change the thermospin
speed up until the thermospin
begins.
Altering the drying level / drying time
You can alter the drying level or drying
time during the washing programme but
not once the drying programme has
started.
Selecting or deselecting a drying
programme
You can select or deselect the drying
function during a washing...

With delay start you can choose when
you want the programme to end. The
start of a programme can be delayed
from 30 minutes up to a maximum of 24
hours, allowing you to make use of
night-time economy electricity rates, for
example.
The current time of day needs to have
been set for delay start to work
correctly.
To select Delay start
^Select the programme you want and
then press thembutton.
9:51
Start time:9:51
Finish:11:19
The display shows the current time of
day and the time the programme is due
to...

,Disconnect the machine from the
electricity supply by switching off at
the wall socket and withdrawing the
plug before any cleaning and
maintenance work.
Cleaning the machine
,Do not use solvents, abrasive
cleaners, glass cleaners or
all-purpose cleaning agents.
These might damage plastic
surfaces and other components
because of the chemicals they
contain.
,The machine must not be hosed
down.
^Clean the casing with a mild
non-abrasive cleaning agent or soap
and water. Wipe dry with a soft cloth.
^The...

^Clean the siphon.
1. Remove the siphon from
compartment§and rinse under
warm running water. Clean the
siphon tube in the same way.
2. Replace the siphon.
If starching frequently, thoroughly
clean the siphon and siphon tube
regularly. A build-up of starch will
cause them to get clogged.Cleaning the detergent dispenser
drawer housing
^Use a bottle brush to remove
detergent residues and limescale
from the jets inside the detergent
dispenser drawer housing.
Descaling the machine
It the correct amount of...

Cleaning the porthole glass
^From time to time you should also
clean ...
–the door glass
on the inside using a
mild detergent or soap and water.
–the metal cap
on the inside of the
door glass with a suitable proprietary
stainless steel cleaning agent
following the manufacturers
instructions on the packaging.
^Wipe dry using a soft cloth.
Cleaning the filter in the water
inlet
The machine has a filter to protect the
water inlet valve.
The accessible filter in the union in the
open end of the inlet hose...

What to do, if...
With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without contacting the Service Department.
,Repair work to electrical appliances should only be carried out by a suitably
qualified person in accordance with local and national safety regulations.
Repairs and other work by unqualified persons could be dangerous. The
manufacturer cannot be held liable for unauthorised work.
The...