Miele Kfn 8762 Sed Operating And Installation Instructions

Installation
^Remove any cable clips from the
back of the appliance.
^Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^Carefully push the appliance into
position. The appliance can be
placed directly against a wall.
Aligning the appliance
^To align the appliance adjust the feet
using the spanner supplied.
Installation
41
 

The appliance is supplied right hand
hinged. If left hand door hinging is
required, follow the instructions below.
Removing the door handles:
First the side section of the handle must
be removed:
^Pull door handleatowards you. Side
sectionbslides back, creating a
gapdbetween side sectionband
mounting platec.
^
Place a suitable object (e.g. a spoon
handle) in gapd, and slowly lever
the handle towards the door.
Be careful not to let the spoon
handle slip, causing damage to the
appliance.
The side...

^Remove coverh, and unscrew hinge
bracketi.
^Fit hinge pinjin the second hole of
hinge bracketi.
^Refit bracketkand coverlturned
through 180° on the opposite side.
^
Screw hinge bracketiinto the
opposite side.
TheM4 screwhas to be screwed into
the left hole of the hinge bracket.
^
Turn coverhthrough 180°, and fit it
on the other side.
^
Exchange covermin the middle of
the appliance with hinge bracketn.
To do this:
Unscrew covermand hinge bracket
n, turn them around and screw in on
the opposite side.
^...

In the following illustration the lower
door is not shown in the closed
position to make it easier to see
what happens next.
^Turn door supportdaround, pull
hinge pineout, and refit on the
opposite side.
^
Fit both parts into hinge platef. To
do this push hinge pinethrough
hinge platefinto door supportd.
Swing the door support in, push
upwards and re-assemble with screw
c.
^
Align the lower door with the
appliance housing using the long slot
in hinge platef. Then tighten screw
c.
^
Refit plinth fasciaa,...

It is important to check that the side
section of the handleddoes not
come into contact with the door seal
when opening the door, as this
would damage the door seal
permanently.
If, after you have refitted the handle,
you find that the side section does
touch the door seal when the door is
opened:
^Realign mounting platecwith grub
screwsauntil the mounting plate
and the side section of the handled
are at the correct angle and the side
section does not touch the seal when
the door is opened.
Changing the...

The appliance can be installed in a
kitchen run. To match the height of the
rest of the kitchen, the appliance can
be fitted with a suitable top boxa.
A ventilation gap of at least 50 mm
depth must be allowed for behind the
appliance and top box, if fitted, for air
to circulate.
A gap of at least 40 mm is required
between the top of the appliance (or
top box) and the ceiling to ensure that
air can circulate without hindrance.
Otherwise the appliance has to work
harder, resulting in an increase in...

47
 

Alteration rights reserved / 1606
KFN 8562 SD ed, KFN 8762 SD ed, KFN 8763 SD ed, KFN 8962 SD edM.-Nr. 06 208 653 / 00
en/GB