Miele H 6860 Bp Manual

Cleaning and care
121
If pyrolytic cleaning is cancelled
If pyrolytic cleaning is cancelled the
oven door will remain locked until the
temperature inside the oven drops to
below 280 °C.
The following will cause the Pyrolytic
cleaning programme to stop:
–Switching the oven off.
–A power cut.
If you turn the oven off Switch appliance
off? will appear in the display.
0004Select Yes if you want to cancel the
Pyrolytic cleaning programme.
The door will unlock once the
temperature in the oven has dropped
below...

Cleaning and care
122
Removing the door
The door weighs approx. 10 kg.
The door is connected to each door
hinge by retainers.
Before the door can be removed the
locking clamps on both hinges must
first be unlocked.
0004Open the door fully.
0004Release the locking clamps by
turning them as far as they will go.
Do not attempt to take the door off
the retainers when it is in the
horizontal position as the retainers
will spring back against the oven. 
Do not use the handle to pull the
door off the retainers...

Cleaning and care
123
Dismantling the door
The oven door is an open system with
4 glass panes which have a heat-
reflective coating on some of their
surface.
When the oven is operating, air is
directed through the door to keep the
outer pane cool.
If soiling has worked its way in between
the glass panes, the door can be
dismantled in order to clean in between
the panes.
Take particular care as scratches can
damage the glass. When cleaning
the glass panes do not use abrasive
cleaning agents, hard sponges...

Cleaning and care
124
Danger of injury. 
Always remove the door before
disassembling it.
0004 Place the door on a protective
surface (e.g. on a tea towel) with the
outside pane facing downwards to
prevent it getting scratched. 
The door handle should line up with
the edge of the table so that the glass
lies flat and does not get broken
during cleaning.
0004Flip the two glass pane retainers
outwards to open them.
You can now remove the inner panes
and the two middle panes one after the
other....

Cleaning and care
125
0004Carefully lift the top of the two middle
panes up and take it out.
0004Then lift the bottom of the two middle
panes up carefully and take it out.
0004Clean the door panes and other parts
with a clean sponge and a solution of
hot water and washing-up liquid or a
clean damp microfibre cloth.
0004Dry all parts with a soft cloth.
Then reassemble the door carefully:
The two middle panes are identical. To
help you put them back in correctly
the material number is printed on the...

Cleaning and care
126
0004Refit the seal.
0004Push the inner pane with the matt
printed side facing downwards into
the plastic strip and place it between
the retainers.
0004Flip both the glass pane retainers
inwards to close them.
The door is now reassembled and is
ready to fit back on the oven.    

Cleaning and care
127
Refitting the door
0004Hold the door securely on both sides
and carefully fit it back into the hinge
retainers.
Make sure that the door goes back
on straight.
0004Open the door fully.
If the locking clamps are not locked,
the door could work loose resulting
in damage.
Ensure that the locking clamps are
locked after refitting the door.
0004Flip both locking clamps back up as
far as they will go into a horizontal
position.   

Cleaning and care
128
Removing the side runners
with FlexiClip runners
You can remove the side runners
together with the FlexiClip runners (if
present).
If you wish to remove the FlexiClip
runners separately beforehand, please
follow the instructions in "Features –
Fitting and removing FlexiClip
telescopic runners".
Danger of burning.
Make sure the oven heating
elements are switched off and cool.
0004 Pull the side runners out of holder (1)
at the front of the oven and then pull
them out of the...

Cleaning and care
129
Lowering the top heat/grill
element
Danger of burning.
Make sure the oven heating
elements are switched off and that
the oven cavity is cool.
0004Remove the side runners.
0004Undo the wing nut.
Use caution not to damage the top
heat/grill element.
Do not use force when lowering the
top heat/grill element.
0004Carefully lower the top heat/grill
element.
You can now clean the roof of the oven.
0004Raise the top heat/grill element and
tighten the wing nut securely.
0004Refit the side...

Cleaning and care
130
Descaling the steam injection
system 
When to run the descaling process
The frequency of descaling will depend
on the water hardness level in your
area.
The descaling process can be run at
any time.
However, to ensure that the oven
functions correctly you will be
automatically prompted to run the
descaling process after a certain
number of programmes.
The oven will let you know when only
10 programmes can be run before you
have to run the descaling process. The
programmes will...