Miele H 212 Instruction Manual

Remove any soiling immediately
after use.
If not, it might become impossible to
remove.
Continued use without regular
cleaning will make the oven much
harder to clean.
The accessories are not
dishwasher-proof.
Useful tips
– Soiling caused by spilt juices and
cake mixtures is best removed whilst
the oven is still warm. Exercise
caution and make sure the oven is
not too hot - danger of burning.
– To make cleaning easier, you can
dismantle the oven door, remove the
shelf runners and the FlexiClip
telescopic...

Stubborn soiling (does not
apply to the FlexiClip
telescopic runners)
Spilt fruit and roasting juices may
cause lasting discolouration or matt
patches on enamelled surfaces.
This discolouration is permanent but
will not affect the efficiency of the
finish. Do not use force to remove
this discolouration! Clean these
following the instructions given here.
Baked on deposits can be removed
with a glass scraper or a
non-abrasive stainless steel spiral
pad.
Remove catalytic panels before
using oven spray. The...

Stubborn soiling on the
FlexiClip telescopic runners
Do not clean FlexiClip telescopic
runners in a dishwasher. The special
lubricant used in the telescopic
runners will wash out during
dishwashing.
In the case of stubborn soiling on the
surfaces of the telescopic runners, or
clogged bearings caused by fruit juices
spilling over, proceed as follows:
Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid. If necessary,
use the back of a washing-up
sponge to...

Removing oil and grease soiling from
the catalytic enamelled panel
Remove any accessories from the
oven, including the shelf runners.
Wipe large deposits of soiling from
the oven interior and the inside of the
door before starting the cleaning
process to avoid them baking on.
Select the Fan Plusfunction and
a temperature of 250 °C.
Then heat the empty oven for at least
an hour.
The length of time required will depend
on the level of soiling.
If the catalytic coating is very heavily
soiled with oil...

Removing the door
The oven door is connected to the
hinges by retainers.
Before removing the door from the
retainers, the locking clamps on both
hinges have to be released.
Open the door fully.

Release the locking clamps by
turning them as far as they will go.
Do not attempt to take the door off
the retainers when it is in the
horizontal position as the retainers
will spring back against the oven.
Do not use the handle to pull the
door off the retainers as the handle
could break.
Raise the door up...

Dismantling the door
The oven door is an open system with
three glass panes which have a
heat-reflective coating on some of their
surface.
During operation, cool air is passed
through the oven door to keep the outer
pane cool.
If soiling has worked its way in between
the glass panes, the door can be
dismantled in order to clean in between
the panes.
Take particular care as scratches
can damage the glass.
When cleaning the glass panes, do
not use abrasive cleaning agents,
hard sponges or brushes and do...

To remove the inner panes:
Gentlylift the inner pane up and out
of the plastic strip.

Lift the middle pane upgentlyand
pull it out.

Clean the door panes and other
individual parts with a clean sponge
and a solution of hot water and
washing-up liquid or a clean, damp
microfibre cloth.

Dry all parts with a soft cloth.Then reassemble the door carefully:
Refit the middle pane in such a way
that the material number is legible
(i.e. not reversed).

Push the inner pane with the matt
printed side facing...

Flip the two glass pane retainers
inwards to close them.
The door is now reassembled and is
ready to fit back on the oven.
Cleaning and care
78 

Fitting the door
Hold the door securely on both sides
and carefully fit it back into the hinge
retainers.
Make sure that the door goes back
on straight.Open the door fully.
It is essential that the locking
clamps lock securely when the door
is refitted after cleaning. Otherwise
the door could work loose from the
retainers and be damaged.
Flip both locking clamps back up as
far as they will go into a horizontal
position.
Cleaning and care
79 

Removing the shelf runners
with FlexiClip telescopic
runners
Danger of injury!
Do not use the oven without the
shelf runners.
You can remove the shelf runners
together with the FlexiClip telescopic
runners (if present).
If you wish to remove the FlexiClip
telescopic runners separately
beforehand, please follow the
instructions in Features – Fitting and
removing the FlexiClip telescopic
runners.
Danger of burning!
Make sure the oven heating
elements are switched off and the
oven interior is cool.Pull...