Miele G 8066 Manual

Rinse aid is needed to prevent spotting
on dishes and glassware. The rinse aid
is filled in the reservoir and the set
amount will be automatically dispensed
during the final rinse.
For sparkling results Miele
recommends to use process chemicals
supplied by Miele.
G 8066
This model is equipped with a built-in
rinse aid dispensing pump.
The rinse aid container holds approx.
1.3 gal (5 liters) of rinse aid and is
connected to the dishwasher with a
siphon tube.
Place the rinse aid container on the
floor...

G 8066 WES DOS
This model comes standard with a
built-in dispensing pump and a
reservoir for rinse aid.
The reservoir is located on the inner
right hand side of the service panel and
holds approximately 8.5 oz (250 ml).
Open the service panel with the
handle.

Take theredcap off the filler spout.

Using the supplied funnel fill the
container with rinse aid.

Replace the cap and close the ser-
vice panel.Add rinse aid indicator
Fill the rinse aid reservoir when the
slot on the right hand sideof the...

Loading the machine
Removing excess soils
Scrape food from dishes before
placing them in the dishwasher.
Inadequate pre-cleaning can clog
the filters and interrupt the wash
program.
Do not use steel wool sponges.
Danger of corrosion! Only use a
non-abrasive stainless steel
sponge, soft nylon brush, plastic
sponge or the similar.Important
–Select baskets and inserts which are
appropriate for the application.
–Load items so that water can reach
all surfaces.
–Do not place dishes or cutlery inside
other...

Items not recommended for
dishwashing
–Cutlery with wooden or bone handles
–Wooden or plastic cutting boards
–Plastic items that are not heat
resistant (see also Special programs
with a lowered rinse temperature)
–Glued items, e.g. old knives with
handles which have been glued on
–Hand-made craft items
–Copper or tin itemsImportant
–Silver and aluminum items may
tarnish
–Clouding or etching may occur on
glassware after frequent washing
Use
24 

Loading examples
The dishwasher can be supplied with a
standard range of baskets or with
baskets to suit your individual
requirements. Because of the large
diversity of inserts and baskets not all
can be shown. Call Miele for more info.
The following illustrations show the
most popular baskets with examples of
loading plates, cups and cutlery.
U 200 plastic basket with insert
For 18 plates up to 9 ¾" (250 mm)
diameter. Distance between spikes
1 ¾" (45 mm).U 201 plastic basket with insert
For 30...

Only use detergents formulated
for use in this type of dishwasher.
Do not use household dishwasher
detergents!
Under certain circumstances,
i.e. special soiling, different
combinations of detergents and other
additives may be necessary. Contact
Miele’s Professional Department for
advice.
Miele recommends to use process
chemicals supplied by Miele for
excellent cleaning results.
G 8066
Detergents can be dispensed as
powder or liquid using an optional DOS
Module G 60 dispensing system.
The DOS module is...

Adding liquid detergent
The optional DOS Module G 60 is
needed for dispensing liquid detergent.
See "Programming special functions"
to set the concentration level and to
vent the dispensing system.
The detergent container holds approx.
1.3 gal (5 liters) of detergent and is
connected to the dishwasher by a
siphon tube.

Insert the siphon tube in the
container opening and push it down
to the bottom of the container.
Tighten it securely. Make sure to
follow the color code.
Remember to fill the...

G 8066 WES DOS
These models come standard with a
built-in dispensing pump and a
reservoir for detergent.
The reservoir is located on the inner left
hand side of the service panel and
holds approximately 0.3 gal (1.3 liters).
Open the service panel with the
handle.

Take thebluecap off the filler spout.

Using the supplied funnel fill the
container with detergent.

Replace the cap and close the ser-
vice panel.Detergent indicator
Fill the detergent reservoir when the
slot on the left hand sideof the...

Filling the tank and heating the
water
Close the door.
Open the water supply.
Press thebutton to turn the
dishwasher on.
All program indicators light.
Press the desired program button.
See "Selecting a program" for more
info.
The boiler and tank will fill with water
and the water will begin heating up.
This takes approx. 15 - 20 minutes, the
remaining time is displayed flashing.
While the water is heated, the
"Boiler-heating" indicator lights.
If a rinse or regeneration cycle is...

Selecting a program
Choose the program according to the
items being cleaned and the degree
of soiling.
See the "Program guide" for more
information.
The selected program will remain in
memory for the duration of the
operating session, e.g. through the
workday, until the machine is turned off.
Starting a program
Press the "Start"button.
The "Start" and "Program" indicators
light.
During the running program the
remaining time shows in the display.
The "min"...