Midway Cruis N Exotica 27 Dedicated Game Operations Manual

Service - 7
Dashboard Service
To service the Center Control Pod…
Refer to Center Control Pod Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾ Remove the Dashboard. Refer to service instructions for Dashboard.
¾  Disconnect the light bulbs from the sockets for both the Radio and Start buttons, and set
aside.
¾  Remove 5 hex head screws that form the outline of the pod and set aside.
¾  Lift the Center Control Pod from the Dashboard.
¾  Perform the desired...

Service - 8
To service the Dashboard PCB…
Refer to the Dash PCB Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Remove the Dashboard and the Center Control Pod. Refer to service instructions for the
Dashboard and the Center Control Pod.
¾  With the Center Control Pod removed from the dash, remove 5 hex head screws that are
used to fasten the PCB to the pod and set aside.
¾  Remove the ribbon and power cable connections.
¾  Perform the desired repair or...

Service - 9
Control Pod, Buttons and Shifter Service
To service a Start or Radio Button…
Refer to the Control Pod, Buttons and Shifter Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾ Remove the Dashboard. Refer to service instructions for Dashboard.
¾  Gently remove the bulb(s) from the socket using a rocking motion.
¾  Perform the desired repair or equipment replacement. NOTE: 
If changing a bulb, simply
reseat it in original socket. If repairing a...

Service - 10
To service Shifter…
Refer to the Control Pod, Buttons and Shifter Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Remove the 4 tamper-resistant buttons used to fasten the faceplate.
¾  Pull the plate forward enough to expose the switches. NOTE: 
Pulling the shifter out of the
pod requires quite a bit of force.
¾  Label and disconnect the wiring for the pod(s) being serviced.
¾  Lift assembly completely out of the pod and set aside.
¾  Perform...

Service - 11
(SEE DETAIL DRAWING) STEERING MECHANISM
Steering Assembly Service
To service Keypad…
Refer to the Keypad Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.

 Remove the Dashboard. Refer to service instructions for Dashboard.

 Label and disconnect wiring for keypad.

 Remove the 4 nuts and set of spacers used to fasten the Keypad to the dashboard.

 Lift the keypad out.

 Perform the desired repair or equipment replacement.
¾
  Re-install keypad,...

Service - 12
To service Lower Cabinet Speaker…
This speaker is located just above the pedal assembly.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Unlock and remove the rear cabinet door.
¾  Label and disconnect the wiring, including ground strap, to Board assemblies attached to
the electronics shelf.
¾  Remove the screws used to fasten the electronics shelf inside the cabinet, then remove
the shelf and set it aside.
¾  Locate the speaker. Remove the nuts from the mounting...

Service - 13
Dollar Bill Validator Service
To service CPU Board Assembly…
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Unlock and remove the rear door.
¾  Remove the perforated metal cover to expose the CPU Board Assembly.
¾  Carefully note the orientation of the JAMMA connector and the other cables.  Extract
the harness and other cables from the board connectors.
¾  Remove CPU board assembly mounting screws.  Lift the board out of the cabinet and
set in a safe place.  Use...

Service - 14
To service the Battery…
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Unlock and remove the rear door.
¾  Carefully note the position, and then gently lift the contact arm to release tension.  Do not
bend the arm.
¾  Slight finger pressure may be needed to pry the cell from its holder. Avoid direct shorts
across terminals or from terminals to ground.
¾  To install a battery, orient cell near its holder and slide it in under the contact arm.  Do not
force....

Service - 15
To service Fan Assembly…
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Unlock and remove the rear door.
¾  Remove the perforated metal cover to expose the fan assembly and set aside.
¾  Unplug the fan power connector from the wiring.
¾  Remove the screws used to fasten a fan down and then lift fan out.
¾  Perform the desired repair or equipment replacement.
To service Speakers in Head Rest…
Refer to the Seat Pedestal Service illustration.
¾  Switch off the power...

Service - 16
H-23081
Seat Pedestal Service
To service the Seat Slide Assembly…
Refer to the Seat Pedestal Service illustration.
¾  Switch off the power to the game machine and unplug the AC line cord.
¾  Disconnect the Seat Assembly from the cabinet by removing 8 tamper resistant screws
used to fasten the assembly to the slide rails in the cabinet.
¾  Slide the Seat Assembly halfway back along the rails to expose wiring.
¾  Disconnect the speaker cable and slide the seat the rest of the way off the...