Home > Lucent Technologies > Communications System > Lucent Technologies DEFINITY Communications System Generic 2.2 And Generic 3 V2 DS1/CEPT1/ISDN PRI Reference Manual

Lucent Technologies DEFINITY Communications System Generic 2.2 And Generic 3 V2 DS1/CEPT1/ISDN PRI Reference Manual

Here you can view all the pages of manual Lucent Technologies DEFINITY Communications System Generic 2.2 And Generic 3 V2 DS1/CEPT1/ISDN PRI Reference Manual. The Lucent Technologies manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 41

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Equipment and Software Requirements 
Page 3-12 ESF T1 Channel Service Unit 
3
— SW6-6 set to op en
— SW6-7 set to c losed
— .SW6-8 set to op en
nFor a d istanc e from 500 feet to 655 feet, switc hes SW6-1 throug h SW6-8 
should  b e set as follows:
— SW6-1 set to op en
— SW6-2 set to c losed
— SW6-3 set to op en
— SW6-4 set to c losed
— SW6-5 set to op en
— SW6-6 set to c losed
—...

Page 42

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Equipment and Software Requirements 
Page 3-13 ESF T1 Channel Service Unit 
3
Other ESF T1 CSU Settings
Following  are add itional ESF T1 CSU switc h setting s:
nLeave the unit memory add ress c od e alarm op tion (roc ker switc h SW1) to 
the d efault (fac tory) setting . This switc h allows ESF d iag nostic  test sets to 
ad dress up  to 256 ESF T1 CSUs. This switc h d oes not have...

Page 43

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Equipment and Software Requirements 
Page 3-14 CEPT1 Channel Service Unit 
3
Loop b ac k Units. There are two b asic  families of these jac ks, the 3100-XX and  
3101-XX series. Eac h family c ontains 16 versions of the jac k. The only d ifferenc e 
in the two families are the loop b ac k ac tivate and d eac tivate c od es. The 3100-XX 
series has a 5 d ig it c od e, 11000 to ac...

Page 44

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Equipment and Software Requirements 
Page 3-15 Multiplexers and Other Customer Premises Equipment 
3
Multiplexers and Other Customer 
Premises Equipment
NOTE:
Equip ment suc h as T1 multip lexers, b it c omp ression multip lexers, and  
ec ho c anc ellers c an c orrup t the DS1/CEPT1 b it stream. This is esp ec ially 
true of ec ho c anc ellers. Some T1 multiplexers, for examp le,...

Page 45

Physical Layer 
Page 4-1 Bit Rate 
4
DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
4
4Physical Layer
This c hap ter d isc usses how various asp ec ts of the p hysic al layer p rotoc ols for 
DS1 and  CEPT1 trunks have b een d esig ned  into the DEFINITY systems. It 
d isc usses these sub jec ts as they relate to narrowband  (64 kb p s) switc hing .
For tec hnic al information on wid eb and  switc hing  in DEFINITY systems, refer...

Page 46

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Physical Layer 
Page 4-2 Framing Format 
4
G2.2 Bit Rate Implementation
No spec ial ad ministration is required  to imp lement the b it rate in these systems.
G3V2 Bit Rate Implementation
To imp lement the d esired b it rate in G3V2 you must d o the following :
nDetermine the req uired  b it rate for your ap p lic ation. For examp le, you 
mig ht b e c onnec ting  to the pub lic...

Page 47

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Physical Layer 
Page 4-3 Framing Format 
4
However, either the superframe or the extend ed  sup erframe format may b e 
c hosen; the d ec ision must d epend  on the network eq uipment and  ap p lic ation.
The framing  format does not p lac e any req uirement on the typ e of sig naling  or 
line c od ing  to b e used . However, the type of framing  used  at b oth end s of the...

Page 48

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Physical Layer 
Page 4-4 Framing Format 
4
Figure 4-1. DS1 Superframe Format
DS1 ESF Framing
The ESF framing  format was d evelop ed  after the sup erframe format. Not all 
eq uip ment used  with the DS1 interfac e sup p orts ESF. Sp ec ific ally, most D4 
c hannel b anks (unless they are c onfigured  as LIU-3ESF or eq uivalent) and  
CDMs d o not c urrently sup port ESF framing ....

Page 49

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Physical Layer 
Page 4-5 Framing Format 
4
Figure 4-2. The Extended Super Frame
The sync hronization p attern for the ESF format is formed  b y the framing  b it from 
24 c onsec utive frames. Unlike the 12-b it sync hronization p attern for D4, whic h 
utilizes all of the availab le framing  b its for sync hronization, ESF emp loys only 6 of 
the availab le 24 framing  b its to c...

Page 50

DEFINITY Communications System Generic 2.2 and Generic 3 V2 
DS1/CEPT1/ISDN PRI Reference  
555-025-107  Issue 1
July 1993
Physical Layer 
Page 4-6 Framing Format 
4
NOTE:
The fac ility d ata link is a 4-kb p s d ata link d esig ned  to maintain and  
sup ervise the DS1 fac ility. However, this 4-kb p s d ata link is not used  b y 
DEFINITY systems.
The CRC is used  at the rec eiving  end  to d etec t transmission errors, as follows: 
The CRC is c alc ulated  at the transmitting  end  and  multip lexed...
Start reading Lucent Technologies DEFINITY Communications System Generic 2.2 And Generic 3 V2 DS1/CEPT1/ISDN PRI Reference Manual

Related Manuals for Lucent Technologies DEFINITY Communications System Generic 2.2 And Generic 3 V2 DS1/CEPT1/ISDN PRI Reference Manual

All Lucent Technologies manuals