Lucent Technologies CentreVu Call Management System Release 3 Version 8 Software Installation And Setup Manual

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Overview2-3
Remote Terminal 
Access Tips
2
lWhen executing commands that take a long time to complete, (such 
as cpio and /olds commands), use the nohup command to 
ensure that the command will complete without interruption in case 
the data line disconnects. An example using the nohup command 
is shown below:
nohup cpio -icmudf -C 10240 -I /dev/rmt/0c “/cms” | tee
lWhen system reboots are required, verify that...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-4
Installing the Solaris Operating System    B
Overview2The Solaris installation program is a menu-driven, interactive program 
that guides you step by step through installing the 
Solaris software. It 
also has on-line help to answer your questions.
If the CMS computer you are installing requires disk mirroring, you 
must use information from this section and the...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-5
Before You 
Begin
B
Before you begin the Installation procedures described in this chapter, 
perform the following tasks:
lObtain the Solaris 7 Software 3/99 CD
lIdentify the host name of the system, which is designated by the 
Lucent Technologies’ Technical Service Center [TSC])
lIdentify the system’s Internet Protocol (IP) address (this may be the 
factory default or...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-6
5. Boot the system from the CD by entering the following:
boot cdrom
The CD boot process varies between platforms, and requires 
approximately 2 to 10 minutes to complete. 
The Select Language and Locale screen appears:
6. Choose the Language and Locale selections that are appropriate for 
your location and then click Continue. 
7. The 
Solaris Installation Program...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-7
Identifying the 
System
B
The Identify This System screen appears:
1. Select Continue.
The Host Name screen appears:
2. Select the Host name box and enter the host name for the system. 
The host name for a specific system is designated by TSC  

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-8
Provisioning personnel. Host names are case-sensitive and cannot 
start with a number. When finished, select Continue.
The Network Connectivity screen appears:
3. Select Yes, and then select Continue.
If the system is equipped with more than one network interface, 
the Primary Network Interface screen appears (otherwise, the IP 
Address screen appears):
NOTE: 

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-9
4.If the Primary Network Interface screen appears, select “hme0” for 
an 
Enterprise 3000, Enterprise 3500, or Ultra 5 computer, or “le0” for 
a 
SPARCserver computer, and then select Continue.
The IP Address screen appears:
5. Select the IP address box and enter the IP address. IP 
address 192.168.2.1 is the factory default. You should enter the 
factory default address...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-10
6. Select Continue if the displayed information is correct. If you select 
Change, the program returns to the Host Name screen.
The Name Service screen appears:
7. Select None, and then select Continue.
The Confirm Information screen appears: 

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-11
8. Select Continue if the displayed information is correct. If you select 
Change, the program returns to the Name Service screen.
The Subnets screen appears
:
9. If this CMS computer is using LAN connectivity to the switch and is 
part of a subnet on the customer’s network, you may need to select 
Yes to administer a subnet mask. If you select Yes, continue with...

  Installing Software and Setting Up CMS CentreVu®  CMS R3V8 Software Installation and Setup
Installing the Solaris Operating System2-12
Setting the Date 
and Time
B
The Time Zone screen appears:
1. Select Geographic region, and then select Set.
The Geographic Region screen appears: