Home
>
Lucent Technologies
>
Communications System
>
Lucent Technologies CentreVu Call Management System Release 3 Version 8 Guide
Lucent Technologies CentreVu Call Management System Release 3 Version 8 Guide
Here you can view all the pages of manual Lucent Technologies CentreVu Call Management System Release 3 Version 8 Guide. The Lucent Technologies manuals for Communications System are available online for free. You can easily download all the documents as PDF.
Page 41
Installing Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Factory installation procedures for disk mirroring35 Step 8: Install the CMS software 2 Now you will complete the installation of the usual software by installing CMS. In general, the steps are as listed below. Detailed installation instructions can be found in CentreVu CMS R3V8 Software Installation and Setup (585-210-941). The steps to be completed are these: lInstall CMS software lInstall CMS patches (if...
Page 42
Installing Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Factory installation procedures for disk mirroring36 5. Enter the following command: 6. Check the output for a line like this: bootdevice2 < device definition> where, again, is the string recorded in item 2. 7. Verify that the system boots normally off the alternate boot device, and log in as the root user: 8. Reboot with a shutdown command and again log in as root: 9. Verify that everything is normal. 10. Enter the...
Page 43
Installing Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Factory installation procedures for disk mirroring37 13. Enter the following command: 14. Do a CMSADM backup. For instructions, see the CentreVu CentreVu CMS R3V8 Administration (585-210-910) document or the maintenance and troubleshooting document for your hardware platform. When the CMSADM backup is finished, the factory installation procedure for disk mirroring is complete.# chmod +x /olds/chkDisks
Page 44
Installing Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Factory installation procedures for disk mirroring38
Page 45
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Using the alternate boot device39 3 Maintaining Mirrored Systems3 This chapter contains procedures you are likely to need to maintain a disk-mirrored system, including replacing disk drives, recovering from disk failures, and using the olds scripts. Using the alternate boot device3 When you set up your mirrored system, you created an alternate boot device named bootdevice2. The alternate boot device is a fail-safe...
Page 46
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Maintaining the chkDisks crontab40 Maintaining the chkDisks crontab3 The chkDisks crontab runs each night and checks to see whether any potential or actual drive problems have been logged. The results of the search are logged to /olds/elog and mailed to the root user. This section shows how to start and stop chkDisks, and how to verify that it will run. Activating chkDisks 3 Activate chkDisks by doing the...
Page 47
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Doing a CMSADM backup on a mirrored system41 Doing a CMSADM backup on a mirrored system3 This section describes how to perform a traditional CMSADM backup on a mirrored system. Mirroring is intended as a way to minimize data loss should a system crash occur, not as a way to avoid backing up data. Mirrored systems must be backed up just as often as unmirrored systems. Step 1: Print the vfstab file3 Print out the...
Page 48
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Doing a CMSADM backup on a mirrored system42 3. Display the CentreVu CMS Administration menu by entering a cmsadm command. For example: 4. Enter the number of the backup option. The system prompts for the tape drive. 5. Enter the appropriate option number. The system begins calculating the approximate number of tapes required and informs you of its calculation. For example: 6. Insert the tape, wait for it to...
Page 49
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Restoring from a CMSADM Backup43 Restoring from a CMSADM Backup3 This section contains the procedure for restoring /cms data files from a traditional CMSADM backup tape. You may want to perform a CMSADM restore when, for example, your file systems are still intact, but some data has been corrupted. If your CMS is running on a Sun Enterprise 3500, and you have had a crashed or corrupted disk, check the...
Page 50
Maintaining Mirrored Systems CentreVu CMS Release 3 Version 8 Disk-Mirrored Systems Restoring from a CMSADM Backup44 You may get error messages concerning the /home directory. These errors display when the directory is already present. Ignore them. 4. Restore any CentreVu CMS maintenance backups dated after the latest CDMADM backup. See the CentreVu CMS R3V8 Administration (585-210-941) document for details on restoring a maintenance backup. NOTE: