Lexmark Interpret S405 User Manual

Use theTo
6LINE Port
LINE
Connect the printer to an active telephone line (through a standard wall jack, DSL filter, or
VoIP adapter) to send and receive faxes.
7USB portConnect the printer to a computer using a USB cable.
Warning—Potential Damage: Do not touch the USB port except when plugging in or
removing a USB cable or installation cable.
8Printhead accessInstall the printhead.
Note: The carrier moves to the printhead access area when no printhead is installed in the
printer.
9Ink cartridge...

Ordering and replacing supplies
Ordering ink cartridges
Page yields available at www.lexmark.com/pageyields. For best results, use only Lexmark ink cartridges.
Lexmark S400 Series models (except Lexmark S408)
ItemReturn Program Cartridge1Regular cartridge2
Black cartridge100100A
High yield black cartridge100XL100XLA
Yellow color cartridge100100A
High yield yellow color cartridge100XL100XLA
Cyan color cartridge100100A
High yield cyan color cartridge100XL100XLA
Magenta color cartridge100100A
High yield...

Lexmarks warranty does not cover damage caused by non-Lexmark ink or ink cartridges.
Replacing ink cartridges
Make sure you have a new ink cartridge or cartridges before you begin. You must install new cartridges immediately
after removing the old ones, or the ink remaining in the printhead nozzles may dry out.
1Turn on your printer.
2Open the printer.
WFI IP
R
I
N
T
I
N
G
Note: The printhead moves to the cartridge installation position.
3Press the release tab, and then remove the used ink cartridge or...

If your ink cartridge comes with a twist cap, then twist and remove the cap.
5Install each ink cartridge. Use two hands to install the black cartridge.
Note: Install the new ink cartridges immediately after removing the protective cap to avoid exposing the ink to air.
6Close the printer.
Ordering paper and other supplies
To order supplies or to locate a dealer near you, visit our Web site at www.lexmark.com.
ItemPart Number
USB cable1021294
For more information, go to www.lexmark.com.
PaperPaper size...

PaperPaper size
Lexmark PerfectFinish Photo PaperLetter
A4
4 x 6 in.
L
Notes:
Availability may vary by country or region.
For best results when printing photos or other high-quality images, use Lexmark Photo Paper or Lexmark
PerfectFinishTM Photo Paper.
For more information, go to www.lexmark.com
Recycling Lexmark products
To return Lexmark products for recycling:
1Visit our Web site at www.lexmark.com/recycle.
2Find the product type you want to recycle, and then select your country or region from the...

Using the printer control panel buttons and menus
Using the printer control panel
15
6
78 910
234
Use theTo
1Power buttonTurn the printer on and off.
Switch to Power Saver mode.
Note: When the printer is on, press 
 to switch to Power
Saver mode. Press and hold 
 for three seconds to turn
off the printer.
2Copy buttonAccess the copy menu and make copies.
3Scan buttonAccess the scan menu and scan documents.
4Fax buttonAccess the fax menu and send faxes.
5Photo buttonAccess the photo menu and print...

Use theTo
8Select buttonSelect menu options.
Save settings.
Feed or eject paper. Press and hold for three seconds to
feed or eject paper from the printer.
9Back buttonReturn to the previous screen.
Exit from one menu level to a higher one.
10Setup buttonAccess the setup menu and change printer settings.
Note: The Copy, Scan, Fax, and Photo button lights are off
when this button is selected.
123
45
8
Cancel
Eco-Mode
7
6
Use theTo
1Address BookAccess fax numbers from a saved list of numbers....

Use theTo
62-Sided/Eco-ModeActivate 2-Sided to:
Print on both sides of the paper (duplex).
Activate Eco-Mode to:
Print on both sides of the paper (duplex).
Change to Power Saver mode after the printer is left idle for ten minutes.
Set screen brightness to low.
Note: 2-Sided/Eco-Mode is available only on select models.
7Cancel buttonCancel a print, copy, scan, or fax job in progress.
Exit from a menu level of the Copy, Scan, Fax, Photo, or File Print menu to the top level of
a menu.
Exit from a menu level...

Photo menuThe following Photo options will not time out after two minutes of inactivity or after you
turn off the printer, but they will return to the factory default settings when a memory card
or flash drive is removed.
Photo Effects
Photo Size
Layout
Quality
To change the temporary settings into new default settings
1From the printer control panel, press .
2Press the arrow buttons to scroll to Defaults, and then press .
3Press the arrow buttons to scroll to Set Defaults, and then press .
Use Current...

Saving paper and energy with Eco-Mode
The Eco-Mode feature significantly cuts paper usage, reduces paper waste, optimizes energy efficiency, and saves
money.
Note: If you are using Eco-Mode, then the Eco-Mode settings override any changes you may make to individual settings
that are part of Eco-Mode.
When Eco-Mode is enabled, the printer automatically switches to the following settings:
The printer display is dimmed.
The printer changes to Power Saver mode after ten minutes.
The printer prints on both...