Land Rover Range Rover Owners Handbook Lm 2nd Edition Exp Rover
Have a look at the manual Land Rover Range Rover Owners Handbook Lm 2nd Edition Exp Rover online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 364 Land Rover manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Locks & Alarm 20 TAILGATE Opening the upper tailgate With all doors unlocked, press the switch on the bottom edge of the upper tailgate and lift to open. If single point entry has been used and only the driver’s door is unlocked, press the tailgate release button (illustration above).Opening the lower tailgate With the upper tailgate open, press the release switch on the top of the lower tailgate (see inset), then lower the tailgate. H3929 H3935 H3930
Locks & Alarm 21 Emergency manual operation Upper tailgate: If the battery has been disconnected or has discharged, the tailgate can be opened manually as follows: •Fold the rear loadspace cover (see ‘Folding the loadspace cover from inside the vehicle’, page 110, for instructions). •From the rear loadspace, lever out the plastic tab (see inset). •Pull the tab to release the upper tailgate. •Raise the upper tailgate.Lower tailgate: With the upper tailgate open, push down on the two hidden catches (see upper insets), either side of the tailgate. The catches can be operated either one at a time, or simultaneously. H4052 H4233
Seats 22 SeatsMANUALLY OPERATED FRONT SEATS WARNING To avoid the risk of loss of control and personal injury, DO NOT adjust the drivers seat while the vehicle is in motion. The driver and front passenger seats should be positioned as far rearward as practical. Ideally the seat should be positioned so that the steering wheel can be held with the arms slightly bent and the seat back in a nearly upright position. Make sure your driving position is comfortable and enables you to maintain full control of the vehicle. A properly adjusted seat helps reduce the risk of injury from sitting too close to an inflating airbag.Sitting correctly The seats, head restraints, seat belts and airbags all contribute to the protection of the occupants. Optimal use of these components will give you more protection. Therefore, observe the following points: •Sit in the most upright position with the base of your spine as far back as possible and the backrest not reclined more than 30 degrees. •Adjust the head restraints so that the top of the head restraint is level with the upper portion of the head. •Do not move the front seat too close to the instrument panel. The driver should hold the steering wheel with slightly bent arms. The legs should also be slightly bent so that the pedals can be pressed to the floor. •The seat belt should rest in the centre of the shoulder. The lap part should fit tightly across the hips and not on the stomach. H4692 max. 30o
Seats 23 Forward/backward adjustment Lift the lever (arrowed in inset) to slide the seat forward or back. Ensure the seat is locked in position before driving.Seat back adjustment Lift the lever (arrowed in inset) and lean forwards or backwards in the seat until the desired angle is achieved. Release the lever to lock in place. WARNING DO NOT travel with the seat backs reclined steeply rearwards. Optimum benefit is obtained from the seat belt with the seat back angle set to no more than 30 degrees from the upright (vertical). H3780 H3777
Seats 24 Seat height adjustment WARNING Take care when adjusting the height of the driver’s seat - a rear seat passenger’s feet might become trapped when lowering the seat rearwards. Lift the lever (arrowed in inset) and apply weight to lower the seat rearwards, or allow the seat to rise forwards, as required.Lumbar support adjustment Press the right or left of the switch to increase or decrease support to the lumbar region of the back. Press the top or bottom of the switch to increase support at the top or bottom of the seat back. H3778 H3781
Seats 25 Cushion front edge adjustment (driver’s seat only) * Lift the lever (arrowed in inset) repeatedly to raise the front edge of the seat to the desired height. Push down on the lever repeatedly to lower the front edge.Head restraint adjustment WARNING Adjust the head restraint so that the cushion is level with the back of the head - NOT THE NECK! Head restraints are designed to restrain rearward movement of the head in the event of an accident or sudden stop - a properly adjusted head restraint can considerably reduce the risk of neck and head injuries. Push the restraint down to lower, pull the restraint up to raise. To fully lower the restraint, press the button (arrowed) while pushing down on the restraint. The angle of the restraint can be adjusted. Tilt the restraint to ensure it is as close to the back of the head as possible. To remove the head restraint, press the button on the left hand mounting and pull the restraint upwards. H3779 H3782
Seats 26 WARNING DO NOT drive with a head restraint removed from an occupied seat - serious injury could occur in the event of an accident. POWER OPERATED FRONT SEATS* WARNING To avoid the risk of loss of control and personal injury, DO NOT adjust the drivers seat while the vehicle is in motion. The seat adjustment controls are situated on the outboard side of the seat plinth. The driver and front passenger seats should be positioned as far rearward as practical. Ideally the seat should be positioned so that the steering wheel can be held with the arms slightly bent and the seat back in a nearly upright position. Make sure your driving position is comfortable and enables you to maintain full control of the vehicle. A properly adjusted seat helps reduce the risk of injury from sitting too close to an inflating airbag.Sitting correctly The seats, head restraints, seat belts and airbags all contribute to the protection of the occupants. Optimal use of these components will give you more protection. Therefore, observe the following points: •Sit in the most upright position with the base of your spine as far back as possible and the backrest not reclined more than 30 degrees. •Adjust the head restraints so that the top of the head restraint is level with the upper portion of the head. •Do not move the front seat too close to the instrument panel. The driver should hold the steering wheel with slightly bent arms. The legs should also be slightly bent so that the pedals can be pressed to the floor. •The seat belt should rest in the centre of the shoulder. The lap part should fit tightly across the hips and not on the stomach. H4692 max. 30o
Seats 27 Forward/backward adjustment Push and hold the switch forwards or backwards to move the seat to the desired position.Seat back adjustment Twist the switch forward or backward until the desired seat back angle is achieved. WARNING DO NOT travel with the seat backs reclined steeply rearwards. Optimum benefit is obtained from the seat belt with the seat back angle set to no more than 30 degrees from the upright (vertical). H3845 H3842
Seats 28 Seat cushion height adjustment (driver’s seat only) Push the switch up or down to raise or lower the cushion.Seat cushion angle adjustment Twist the front of the switch to tilt the seat cushion to the desired position. Note that the front and rear of the switch work independently - the front tilting the front of the cushion, the rear of the switch adjusts the height of the seat cushion. H3843 H3844
Seats 29 Lumbar support adjustment Press the right or left of the switch to increase or decrease support to the lumbar region of the back. Press the top or bottom of the switch to increase support at the top or bottom of the seat back.Shoulder support adjustment* Push the control forward or rearward to increase or decrease shoulder support. H3846 H4040