Land Rover Range Rover Owners Handbook Lm 2nd Edition Exp Rover

							Fuses
220
20 30 Driver’s seat,
Steering column
21 30 Passenger’s seat
22 7.5
Telephone
*
23 15 Steering column
24 30 Central locking,
Exterior mirrors
Electric windows - front
25 5 Immobilisation
26 30 Windscreen wipers
27 20 Glove box light, 
Interior lights,
Windscreen washers
28 30 Headlight cleaning
29 10 Heated steering wheel
30 15 Electronic damper control
31 5 Engine management,
Immobilisation
32 5
33 5 Transmission
34 7.5 Air conditioning,
Blower
35 5 Anti-lock Braking System,
Dynamic Stability Control
36 - -
37 5 Transfer neutral - to be inserted when 4-wheel towing 
38 - -
39 5 Immobilisation
40 5
CD autochanger
*
41 5
Rain sensor*,
Rear window wash/wipe
42 5 Vanity mirror illumination
43 5 Alarm
44 5Airbag SRS - DO NOT REMOVE
45 5 Instruments
46 5 Instruments
Fuse 
numberRating 
(amps)Circuit protected 
						

							Fuses
221
47 30 Heated screen washers, 
Heated windscreen
48 -  -
49 30
Navigation system,
*
On-board computer,*
On-board monitor,*
Audio system
50 -  -
51 10 Anti-lock Braking System,
Dynamic Stability Control,
Fuel pump,
Air pump
52 25 Heated seats - front
53 30 Engine management
54 15 Transmission
55 30 Anti-lock Braking System,
Dynamic Stability Control
56 -  -
57 15 Air suspension
58 20 Sunroof
59 20 Auxiliary heater (diesel models only),
Independent heater
60 30 Central locking,
Electric windows - rear
Fuse 
numberRating 
(amps)Circuit protected 
						

							Fuses
222
REAR LOADSPACE FUSE BOX
The fuse box is situated on the right hand side 
of the loadspace behind the rear loadspace 
access hatch. Pull the handle to open the panel 
(see ‘REAR LOADSPACE ACCESS HATCH’, 
page 107).Owners are advised against removing or 
replacing the relays (identified as R1-R10) 
and fusible links (MF1-MF3). Failure of any of 
these items should be investigated by a 
qualified technician.
Fuse specification
H405385868471747677798081828788
Fuse numberRating (amps)Circuit protected
71 20 Cigar lighter/socket
72 - -
73 - -
74 15 Trailer socket
75 - -
76 20 Trailer socket
77 20 Auxiliary power socket (loadspace)
78 - -
79 30 Heated rear window
80 20 Rear screen wash/wipe
81 20 Heated rear seats
82 15 Rear blower
83 - -
84 5 Remote handset
85 25 Fuel pump
86 10 Central locking system, tailgate
87 50 Trailer socket
88 50 Trailer socket
89 - 
						

							Bulb Replacement
223
B ulb Re plac emen tREPLACING BULBS
Check the operation of all exterior lights before 
you drive the vehicle.
Replacement bulbs
NOTE: All bulbs must be rated at 12 volts
NOTE: In certain territories it is a legal 
requirement to carry spare bulbs, in case of 
bulb failure. A replacement bulb kit is available 
as an approved accessory from your Land 
Rover dealer.Halogen bulbs
Halogen bulbs are used for main beam, dipped 
beam and front fog and reverse lights. Take 
care NOT to touch this type of bulb with your 
fingers; always use a cloth to handle them. If 
necessary, clean the bulb with methylated 
spirits to remove fingerprints.
Xenon light units
*
Some vehicles are fitted with Xenon dipped 
beam headlight units. Xenon lights provide 
significantly improved visibility, especially 
during adverse weather and driving conditions.
The operational life of a Xenon light is 
significantly longer than that of a conventional 
or Halogen bulb. However, the very high 
voltage required to ignite the gas and metal 
vapour used to power Xenon lights could cause 
very serious injury. Replacement or 
maintenance of Xenon lights should only be 
carried out by qualified personnel.
 Used Xenon light units contain mercury, 
which is hazardous and can be injurious 
to health. Seek advice about the proper disposal 
of Xenon light units from a Land Rover dealer or 
your local authority.
Light emitting diodes (LEDs)
Controls, displays and some lights and other 
equipment items inside your vehicle have light 
emitting diodes (LEDs) behind a cover as their 
light source. These LEDs resemble 
conventional lasers and are classified by law as 
“Class 1 light emitting diodes”. Replacement 
LEDs should be fitted only by qualified 
personnel.
WARNING
DO NOT remove the cover or expose the eyes 
directly to the unfiltered light source for 
several hours at a time, as this could cause 
irritation to the iris.
IMPORTANT INFORMATION
Before replacing a bulb, always switch off 
the starter switch and appropriate lighting 
switch to prevent any possibility of a short 
circuit. Only replace bulbs with the same 
type and specification.
BulbWatts
Headlights dipped beam 
(Halogen)55 (H7)
Headlights main beam 55 (H7)
Front side lights 5 
Direction indicators 21 
Front fog lights 55 (H7)
Side repeater lights 5 
Reverse lights 6 (H6)
Rear fog guard lights 21 
Tail lights 5
Number plate lights 5
Door/puddle lights 5
Interior lights 6
Luggage/footwell lights 5
Luggage/tailgate lights 6
Glovebox light 5
Vanity mirror light 1.2 
						

							Bulb Replacement
224
HEADLIGHT MAIN BEAM
From inside the engine compartment, press the 
tab (solid arrow) and open the cover.Disconnect the electrical connector and release 
the spring clip (see inset). Pull the bulb out to 
remove.
NOTE: Do not touch the replacement bulb glass 
with your fingers. If necessary, clean the bulb 
with methylated spirits.
H3878
H3879 
						

							Bulb Replacement
225
HEADLIGHT DIPPED BEAM
From inside the engine compartment, press the 
tab (solid arrow) and open the cover.Disconnect the electrical connector and release 
the spring clip (see inset). Pull the bulb out to 
remove.
NOTE: Do not touch the replacement bulb glass 
with your fingers. If necessary, clean the bulb 
with methylated spirits.
H3880
H3881 
						

							Bulb Replacement
226
FRONT DIRECTION INDICATOR AND 
SIDELIGHT
Light unit removal
From inside the engine compartment, unscrew 
the nut (anti-clockwise), to release the light unit 
(see inset). The nut is attached to a safety strap, 
which prevents it from falling into the engine.
Keeping hold of the light unit, ease it away from 
the vehicle body, disengaging the two locating 
lugs (arrowed).Bulb replacement
The upper of the two bulbs is the direction 
indicator, the lower is the sidelight bulb. The 
removal process is identical for both bulbs.
Having released the light unit form the front of 
the vehicle, turn the relevant bulb holder 90º 
anti-clockwise and pull to release. Twist and 
pull to remove the bulb.
Refitting the light unit
When refitting the light unit, position the two 
lugs first, then position the light unit, so that the 
securing bolt lines up correctly with the 
thumbwheel. Tighten the nut (turn clockwise) 
to fix the unit in position.
H3811
H3812 
						

							Bulb Replacement
227
REAR LIGHT CLUSTER 
(Tail, indicator & fog lights) 
From outside the vehicle and with the tailgate 
fully open, remove the two retaining screws (as 
shown). From the side of the vehicle, use a 
suitable tool to carefully lever the unit away 
from the vehicle and rearwards, to release the 
light unit from the vehicle.
Be careful to avoid damage to the paintwork, 
when levering the light unit from the vehicle. 
Cover any tool used with a cloth and apply 
gentle and constant pressure. Do not use 
excessive force - if in doubt, consult your 
dealer.Press the two tabs (arrowed in inset) together, 
to release the light unit from the lens assembly. 
Twist and pull the appropriate bulb to release. 
The bulbs are located as follows:
1.Rear indicator bulb.
2.Tail light bulb.
3.Rear fog guard light bulb.
NOTE: The brake lights and high mounted stop 
light fitted to your vehicle, are LED lights and 
should be replaced by your dealer if they fail.
H3813
H38143
1
2