Land Rover Range Rover 2000 2001 Owners Handbook 2nd Edition Aus Rover

							Fuses
158
ENGINE COMPARTMENT FUSE BOX
WARNING
Batteries emit explosive hydrogen gas;
ensure that sparks and naked lights are kept
away from the engine compartment.
Fuses 23 to 44 inclusive, listed on the
following page, are located in the engine
compartment fuse box.
Press each of the four latches in the direction
of the arrows (moulded into the lid) and pivot
the lid upward to disengage the three side
location posts.
A label on the underside of the cover identifies
the fuses and their ratings. The following list
supports the information on the cover.A fuse puller (red tweezers) is provided for
extracting the fuses. To remove a fuse, press
the fuse puller on to the head of a fuse and
pull.
Refit the cover by engaging the three side
posts in the slots in the fuse box. Close the
cover and then push the four side catches
away from the fuse box until they can be
heard to’snap’into position. 
						

							Fuses
159 ENGINE COMPARTMENT FUSE BOX
Fuse number Rating (AMPS) Circuit protected
23 10A Airbag SRS
24 5A ABS
25 20A Front wiper system, headlight washers
26 20A Engine management system (EMS)
27 10A Air conditioning compressor
28 30A Ignition coils
29 10A Air suspension
30 30A Heated front screen
31 30A Air-conditioning
32 30A Heated front screen
33 5A Diagnostics, battery back-up sounder
34 30A Heater blower
35 10A Air conditioning, air suspension
36 30A Air-conditioning
37 30A Engine management system (EMS)
38 30A ABS
39 20A Fuel pump
40 40A Starter motor, air suspension
41 20A Horn
42 10A Heating & ventilation, key inhibit
43 30A Heater blower
44 30A Engine management system (EMS)
Spare fuses 5A, 10A, 20A, 30A, 40A
Maxi 1 60A *
Maxi 2 50A Spare
Maxi 3 40A ABS pump
Maxi 4 60A *
Maxi 5 60A *
* Failure of one of these fuses will result in the
message centre displaying various messages
simultaneously. Do not attempt to replace the
fuse; contact a qualified dealer.
WARNING
Fit only replacement fuses of the same
rating and type. Always rectify the cause of
a failure before replacing a fuse. Seek
qualified assistance if necessary. 
						

							Bulb replacement
160 REPLACEMENT BULBS Watts
Headlight units
Front sidelight 5
Front direction indicator 21
Inboard main beam headlight 55
Dip/main headlight 60/55
Front fog lights 55
Rear clusters:
direction indicator 21
tail light 5
stop light 21
Tailgate clusters:
rear fog guard light 21
reversing light 21
High mounted stop light 5
Side repeater lights 5
Puddle lights 3
Number plate lights 5
Loadspace light 10
Front courtesy & reading lights:
courtesy light 10
map reading light 5
Rear courtesy & reading lights:
courtesy light 5
map reading light 4
Rear footwell courtesy lights 5
Vanity mirror lights 1.2
Glovebox light 5
NOTE:All bulbs must be rated at 12 volts.IMPORTANT INFORMATION
Before replacing a bulb, always switch off
the starter switch and appropriate lighting
switch to prevent any possibility of
causing a short circuit. Only use new
bulbs of the same type and with the same
specification.
Halogen bulbs
Halogen bulbs are used for dipped/main,
supplementary main beam and front fog
lights. Take care NOT to touch this type of
bulb with your fingers; always use a cloth
to handle them. If necessary, clean the
bulb with methylated spirits to remove
fingerprints. 
						

							Bulb replacement
161
Front sidelights
Detach the plug from the rear of the bulb,
twist the bulb holder (arrowed) to release,
then pull to remove bulb.Front direction indicators
For right hand indicator: remove the battery
cover.
For both indicators: press the plastic lever
(arrowed in top picture) to release the light
unit from the front of the vehicle. Hold the
light unit and rotate the bulb holder (see lower
picture), then pull bulb holder to remove.
Press and twist bulb to remove.
Refitting the lens is a reversal of this
procedure. However, ensure the light unit is
correctly located into the front wing and
ensure that the plastic lever is securely
engaged before driving. 
						

							Bulb replacement
162
Dipped and main beam
To gain access to the right hand headlight,
first remove the battery cover.
Detach the multi-plug and remove the rubber
cover (the rubber cover has four tabs which
will assist removal and refitting). Unhook the
spring clip and withdraw the bulb.Replace the bulb (the larger of the three tabs
uppermost) and spring clip. Fit the rubber
cover, ensuring that the three connectors pass
through the slots in the cover, then refit the
multi-plug.
Inboard main beam
Detach the plastic cover from rear of unit,
then unhook the spring clip and withdraw the
bulb and connector. Pull bulb to remove. 
						

							Bulb replacement
163
Front fog lights
Twist the plastic cap at rear of the light unit to
release, then squeeze the spring clip and
withdraw the bulb holder. Disconnect the bulb
holder electrical lead connector and then
remove.
Replace the bulb and bulb holder as one
assembly.
Stop, direction indicator & tail lights
NOTE:If your vehicle is fitted with a CD
autochanger, to access the left hand cluster, it
will be necessary to remove the rear trim
panel by releasing the four fasteners.
Press the latch to remove the access panel,
then squeeze the two clips (one on each side
of the light unit) and withdraw the unit
through the access aperture. Press and twist
the appropriate bulb to remove.
Top - direction indicator
Centre - tail light
Bottom - stop light. 
						

							Bulb replacement
164
Reversing & fog guard lights
Open the tailgate and raise the plastic hinge
cover on the lower tailgate to expose the three
fasteners. Turn the fasteners a quarter turn to
release and then remove the tailgate trim
panel.To release either light unit, squeeze the two
levers (one on each side), then press and
twist the appropriate bulb to remove.
Top - reversing light
Bottom - fog light.
Side repeater lights
(if fitted)
Push the lens firmly to the right (arrowed) and
withdraw light unit from the wing. Twist the
bulb holder to release and pull out bulb.
Puddle lights
(if fitted)
Using a plastic implement, prise the light unit
from the door, pulling out as far as the
electrical leads will permit, then prise the lens
from the light unit. Pull the bulb from holder.
Fit lens to the light unit before refitting. 
						

							Bulb replacement
165
Number plate lights
Open the upper tailgate, remove the screws
and withdraw the light unit. Twist bulb holders
to remove and pull out the bulbs.
Loadspace light
Push lamp assembly to one side and prise
from the upper tailgate. Press and twist the
bulb to release.Front courtesy & reading lights
Courtesy light bulb: prise the centre lens from
the light unit, then pull the bulb out from the
clips.
Reading light bulbs: prise the courtesy light
unit from the headlining, then pull the bulbs to
remove. 
						

							Bulb replacement
166
Rear courtesy & reading lights
Rear passenger courtesy light bulb: prise the
lens from the courtesy light unit, then pull the
bulb to remove.
Rear passenger reading light bulb: prise the
lens from the courtesy light unit (as above).
Unscrew both retaining screws and withdraw
light unit from the roof. The bulb can be
reached from the rear of the unit.
Rear footwell light
Prise the combined lens and holder assembly
from the rear of the centre console and
remove bulb from clips.
Replace the bulb then refit assembly to the
centre console.
High mounted stop light
(if fitted)
Unclip the light cover from the inside of the
upper tailgate. Twist to release the bulb
holders, and pull to remove the bulbs. 
						

							Bulb replacement
167
Vanity mirror illumination
Using a small, flat bladed screwdriver (at
extreme top, left and right corners - just below
the hinge), prise the lens and mirror panel
from the light unit.’Spring’the bulbs free
from their connectors to remove.
Replace the bulbs then refit the lens and
mirror panel to the sun visor.
Glovebox illumination
Prise the complete assembly from the
underside of the top edge of the glovebox and
remove the bulb from its holder.
Replace the bulb then refit assembly to the
glovebox.
NOTE:Glovebox illumination is available only
when the side lights are on.