Land Rover Defender Workshop 1993 Rover Manual

ELECTRICAL EQUIPMENT 
REAR LAMPS REVERSE LIGHT SWITCH 
1. The rear  lamp  cluster  on  the  left  side Remove and refit 
comprises  a  rear/stop lamp  an amber flasher 
lamp  and  a  white reverse  lamp.  The 
reverse  light  switch  is  located at the  rear  of the 
On  the  right  side the  lamp  cluster  comprises  gear  change  housing  and  is accessible  from 
only  rear/stop  lamp  and  flasher.  underneath  the  vehicle. 
Loctite thread  locking  fluid 
rubber  using a flat  screwdriver  to gain...

ELECTRICAL EQUIPMENT 
WARNING LAMPS INSTRUMENT ILLUMINATION 
Renew the bulbs  Renew bulbs 
1. Disconnect  the  battery. 1 Disconnect  the battery. 
2. Remove two screws  and  withdraw  the warning 2. Remove  the  four screws  retaining  the 
light  module  from  the front of the  instrument  instrument  panel. 
panel. 
3. Ease  forward  the  panel to gain  access to the 
3. Pull off the plug  connector to give  access  to  bulbs. 
warning  light  bulbs, 
If necessary, disconnect  the  drive cable  from...

ELECTRICAL EQUIPMENT 
WIPER MOTOR - OVERHAUL 
INSPECTION AND 
TEST 
DISMANTLE 
14. 
Check  the  brushes  for excessive wear,  if they 
1. Remove  the wiper  motor  and drive  from  the  are worn  to 4,8  mm  in length, fit a new  brush 
vehicle.  gear assembly. 
2. Remove  the wiper  motor  gearbox  cover. 15. Using  a  push type  gauge,  check that  the 
3.  Remove 
the  circlip  and  plain washer  securing  brush  spring  pressure 
IS 140 to 200 g when 
the connecting  rod.  the  bottom 
of the  brush...

ELECTRICAL EQUIPMENT 
ASSEMBLE 
Use Ragosine  Listate  Grease  to  lubricate  the  gear 
wheel  teeth,  armature  shaft  worm gear, Connecting 
rod  and  pin, cable  rack  and wheelbox  gear  wheels. 
Use  Shell  Turbo 
41 oil sparingly  to lubricate  the 
bearing  bushes,  armature  shaft  bearing  journals, 
gear  wheel  shaft and  wheelbox  spindles.  Thoroughly 
soak  the felt washer 
in the  yoke  bearing  with  oil. 
20.  Fit  the  armature to  gearbox using KEY  TO  WIPER MOTOR  COMPONENTS...

ELECTRICAL EQUIPMENT 
RENEW WIPER MOTOR AND DRIVE RACK 
Removing  wiper motor 
1. Disconnect  the battery. 
2. Remove  the wiper  arms. 
3. Remove  the single  screw  and remove  the 
fascia  side panel. 
4. Remove  the five  screws  and withdraw  the 
instrument  panel as far  as possible  without 
straining  the wires  and cables. 
8. Release  the fascia  panel left-hand support 
bracket. 
9. Remove  fascia lower panel  finisher. 
10. Remove  fascia lower panel. 
5. Remove  the single  screw  securing...

ELECTRICAL EQUIPMENT 
11. 
12. Remove earth lead. 
13.  Lift rubber  sleeve  from wiper  motor  and 
Remove 
slacken  wiper motor  to drive  tube nut. 
14.  Remove  the wiper  motor  retaining  strap 
1. Pull the wiper  arm away  from the windscreen. 
screws  and remove  strap together  with  2. Using  a small  screwdriver,  hold back  the 
mounting  pad and earth  tag.  spring clip which  retains  the arm  to the 
15.  Pull 
the wiper  motor  and drive  rack clear  of 
the  drive  tubes. 
Disconnect...

ELECTRICAL EQUIPMENT 
RENEW WINDSCREEN  WIPER WHEELBOXES 
Remove 
7.  Remove  demister  vent top duct. 
6. Remove  right-hand vent demister  vent fixing 
and  pivot  vent and hose  aside. 
8. Release  the steering  column upper and lower 
9. Slacken  the left and  right-hand  wheelbox  nuts 
1. Disconnect  the battery.  support rods. 
2.  Carry
-out the  instructions  to remove  the wiper 
motor  and drive  rack for air conditioned  and remove  drive tubes  from wheelboxes. 
vehicles,  that is:  10....

ELECTRICAL EQUIPMENT 
13. Fit the  wheelboxes to the bulkhead  and ELECTRICAL SYSTEMS 
loosely secure with the nut and  washer. 
14. Loosely  fit the  drive  tubes  to the  wheelboxes  The electrical  systems on the  vehicle  are made up of 
15. Feed  the drive  rack through  the tubes  until  separate  harnesses  of which  the Engine  Harness, 
fully  seated  in both  wheelboxes.  Chassis 
Harness  and Main  Harness  Assembly  are 
16. Loosely secure drive tube nut to wiper motor. the  main  components....

ELECTRICAL EQUIPMENT 
ENGINE HARNESS 
This harness  connects  various electrical  items fined 
to the engine  and associated  systems with the  This harness  connects  air conditioning  fans and 
vehicle  electrics  via the  main  cable  assembly. 
On associated  switches to the  electrical  system through 
Defender  110 
the air conditioning  fans harness is a Connection  onto the main  harness  assembly 
attached 
to the  engine  harness. 
The items  making  up the  harness  and the cable 
The  items...

ELECTRICAL EQUIPMENT 
CHASSIS  HARNESS Vehicle speed sensor 
Colours:  green/yellow 
This  harness  connects  the rear  lights  and fuel tank 
electrics  with the main  harness:  various individual  Centre differential  locked switch connection 
items  are also  connected  to the  chassis  harness  Colours: black/purple. slate/red 
Including  the hi-mount  stop lamp  cable 
Vehicle speed sensor  MFI connection 
The  items  making  up the  harness  and the cable 
Colour: yellow 
colours  are: 
Reverse...