Land Rover Defender 90 Workshop 2nd Edition Nas Rover Manual

86ELECTRICAL
16
REPAIR IMMOBILIZATION (ALARM) ECU
Service repair no - 86.77.01
Remove
1.Disconnect battery negative lead.
2.Remove steering wheel. If necessary, use puller
LRT-57-014.
3.Remove instrument panel.
See INSTRUMENTS,
Repair, Instrument panel
4.Remove 2 screws securing immobilization ECU
to fascia cowl.
5.Release ECU and disconnect both multi-plugs.
6.Remove ECU.
NOTE: A new ECU must be initialised
using TestBook.Refit
7.Reconnect multi-plugs and secure ECU to fascia
cowl.
8.Fit instrument...

INSTRUMENTS
1
REPAIR INSTRUMENT PANEL
Service repair no - 88.20.02
Remove
1.Disconnect battery negative lead.
2.Remove 4 screws securing instrument panel to
fascia cowl.
3.Pull instrument panel away from fascia sufficent
to reach behind speedometer.
4.Disconnect instrument harness multi-plug.
5.Disconnect 2 multi-plugs from warning light
connectors.
6.Withdraw panel, complete with instruments.
Refit
7.Offer up instrument panel and connect
multi-plugs.
8.Secure instrument panel to fascia...

88INSTRUMENTS
2
REPAIR TACHOMETER
Service repair no - 88.30.21
Remove
1.Remove instrument panel.
See Instrument
panel
2.Release illumination bulb holder and wiring
connectors from tachometer.
- = BLACK
+ = WHITE
2 = RED
3.Unscrew retaining ring and remove tachometer.
4.Remove O ring from tachometer.Refit
5.Fit O ring to tachometer and position
tachometer into instrument panel.
6.Fit retaining ring, align tachometer and tighten.
7.Fit instrument panel.
See Instrument panel
FUEL AND TEMPERATURE GAUGES...

INSTRUMENTS
3
REPAIR CLOCK
Service repair no - 88.15.07
Remove
1.Remove 2 screws and withdraw switch panel
from centre dash panel.
2.Release illumination bulb holder and disconnect
electrical leads from clock.
3.Press in spring retainers and remove clock from
panel.
Refit
4.Fit clock into dash panel.
5.Fit electrical leadsbulb and bulb holder.
6.Secure switch panel to centre dash panel.WARNING LIGHT PANEL
Service repair no - 88.20.18
Remove
1.Remove 2 screws and withdraw warning light
panel.
2.Disconect...

88INSTRUMENTS
4
REPAIR PRINTED CIRCUIT - WARNING LIGHT PANEL
Service repair no - 88.20.20
Remove
1.Remove warning light panel.
See Warning
light panel
2.Remove 13 illumination bulb holders from light
panel.
3.Release printed circuit from locating pins and
remove from panel seatings.
Refit
4.Fit new printed circuit over panel seatings and
position on locating pins.
5.Fit illumination bulbs to secure circuit.
6.Fit warning light panel.
See Warning light
panel