Land Rover Defender 300tdi Workshop 3rd Edition Rover Manual

86ELECTRICAL
6
REPAIR IMMOBILISATION SPIDER
Service repair no - 86.77.03
Remove
1.Remove LH front seat cushion.
2.Release retaining clip and remove battery
access cover.
3.Slacken battery lead clamp bolts.
4.Turn starter switch on.
5.Turn starter switch off and remove key.
6.Disconnect battery leads.
NOTE: Operation 6 needs to be carried out
within 15 seconds to avoid activating
battery backed-up alarm sounder, if fitted.
7.Remove battery clamp and J bolts.
8.Remove 4 nuts securing immobilisation spider...

ELECTRICAL
7
REPAIR BONNET SWITCH
Service repair no - 86.55.89
Remove
1.Disconnect bonnet switch harness multi-plug.
2.Release harness retaining clip from switch
mounting bracket.
3.Press in retaining clips and remove switch from
mounting bracket.
Refit
4.Insert harness multi-plug and bonnet switch into
mounting bracket. Push switch firmly down to
secure in position.
5.Connect harness multi-plug.
6.Fit harness retaining clip in mounting bracket.ULTRASONIC SENSOR
Service repair no - 86.77.32
Remove...

86ELECTRICAL
8
REPAIR ALARM SOUNDER
Service repair no - 86.55.87
Remove
1.Remove LH front seat cushion.
2.Release retaining clip and remove battery
access cover.
3.Slacken battery negative lead clamp bolt.
4.Turn starter switch on.
5.Turn starter switch off and remove key.
6.Disconnect battery negative lead.
NOTE: Operation 6 needs to be carried out
within 15 seconds to avoid activating
battery backed-up alarm sounder, if fitted.
NOTE: If an alarm sounder without battery
back-up is fitted, it is not...

ELECTRICAL
9
REPAIR ALARM SOUNDER RELAY
Service repair no - 86.77.09
Remove
1.Remove screw and lift off LH door check strap
cover.
2.Remove 3 screws and lower wiper motor cover
from fascia bulkhead, (on RH drive models first
remove grab handle).
3.Slide relay multi-plug from retaining bracket and
remove relay.
Refit
4.Secure multi-plug to mounting bracket and fit
new relay.
5.Position wiper motor cover and secure with 3
screws.
6.On RH drive models fit grab handle.
7.Fit door check strap and secure with...

86ELECTRICAL
10
REPAIR Refit
12.Fit alarm indicator light into fascia panel and
reconnect plug lead.
13.Reconnect speedometer cable and fit instrument
panel to fascia cowl.
14.Fit steering wheel
See STEERING, Repair,
Steering wheel.
15.Reconnect battery negative lead.
16.Fit battery access cover.
17.Fit LH seat cushion.ALARM SYSTEM FUSE
Service repair no - 86.77.04
Remove
1.Remove LH front seat cushion.
2.Release retaining clip and remove battery
access cover.
3.Slacken battery negative lead clamp bolt....

ELECTRICAL
11
REPAIR REV: 05/99 Refit
12.Fit new fuse.
13.Position instrument panel to fascia cowl area
and reconnect immobiliser warning light leads,
gearbox oil temperature lead, heated rear screen
leads, alarm LED plug lead, main harness
multi-plugs and speedometer cable,
14.Secure instrument panel to fascia cowl with 4
screws
See INSTRUMENTS, Repair,
Instrument panel.
15.Fit steering wheelSee STEERING, Repair,
Steering wheel.
16.Reconnect battery negative lead.
17.Fit battery access cover.
18.Fit LH...

86ELECTRICAL
12
REPAIR AUXILIARY DRIVE BELT
Service repair no - 86.10.03
NOTE: If cast lines on tensioner arm and
tensioner spring case are aligned, a new
drive belt must be fitted.
Remove
1.Disconnect battery.
2.Remove fan cowl
See COOLING SYSTEM,
Repair, Fan cowl.
3.Apply ring spanner to tensioner pulley retaining
bolt.
4.Turn spanner to release pulley tension from belt.
5.Detach belt from pulley.
6.Release tensioner.
7.Complete removal of belt. Mark direction on belt
if refitting.
Refit
8.Using ring...

ELECTRICAL
13
REPAIR HEADLAMP
Service repair no - 86.40.02
Remove
1.Remove screws retaining side and direction
indicator lamps.
2.Withdraw lamp units and disconnect plugs.
3.Remove 2 screws and withdraw headlamp
finisher.
4.Remove 2 headlamp retaining screws.
5.Rotate headlamp clockwise, disengage from
body, and lift out headlamp.
6.Disconnect multi-plug to release headlamp. On
vehicles fitted with headlamp levelling unit, also
release unit harness plug
See Headlamp
levelling unit.
7.Remove rubber...

86ELECTRICAL
14
REPAIR SIDE, TAIL AND DIRECTION INDICATOR LAMPS
Service repair no - 86.40.34 - Front side lamp
Service repair no - 86.40.45 - Tail lamp
Service repair no - 86.40.42 - Front direction
indicator lamp
Service repair no - 86.40.43 - Rear direction
indicator lamp
Remove
1.Remove 2 screws and withdraw lamp unit.
2.Hold bulb holder and twist lens to release.
3.Push and twist bulb to remove from holder.
Refit
4.Fit new bulb, if necessary.
5.Fit bulb holder to lamp lens.
6.Secure lamp to...

ELECTRICAL
15
REPAIR REAR NUMBER PLATE LAMP - BULB RENEWAL
Service repair no - 86.40.85
Remove
1.Remove single screw securing lamp cover and
lens to bulb holder.
2.Remove bulb/s from holder.
Refit
3.Fit new bulb/s.
4.Fit lamp lens and cover.REAR NUMBER PLATE LAMP
Service repair no - 86.40.86
Remove
1.Remove single screw and remove lamp cover
and lens.
2.Uncsrew 2 fixings and remove metal cover to
gain access to lamp fixings and harness leads
inside vehicle.
3.Disconnect lamp leads from harness.
4.Remove...