Land Rover Defender 1999 2002my Workshop Supplement Body Repair 2nd Edition Rover Manual

47PROPELLER SHAFTS
2
OVERHAUL PROPELLOR SHAFT - REAR
Service repair no - 47.15.12
Remove
1.Remove rear propeller shaft.See Repair.
2.Thoroughly examine universal joint for signs of
damage or wear.
3.Clean universal joint bearing cups and circlips.
CAUTION: To ensure correct assembly
and reduce possibility of imbalance,
before removing propeller shaft joint mark
position of spider pin relative to journal yoke ears.
4.Remove circlips.
5.Remove grease nipple.
6.Tap yokes to eject bearing cups.
7.Remove...

57 - STEERING
CONTENTS
Page
REPAIR
STEERING COLUMN - UPPER - Td5 1................................................................. 

STEERING
1
REPAIR STEERING COLUMN - UPPER - Td5
Service repair no - 57.40.01
Remove
1.Ensure road wheels and steering wheel are set
in the straight ahead position.
2.Loosen 2 clips securing air inlet pipe between
turbo and inlet air filter.
3.Remove air inlet pipe.
4.Mark relationship between the upper steering
column and the lower steering column universal
joint.
5.Remove bolt securing upper column to lower
column universal joint.
6.Remove steering colum nacelle.See this
Section.
7.Remove instrument...

57STEERING
2
REPAIR 15.Remove brake servo.See BRAKES, Repair.
16.Release ABS modulator multiplug from side of
brake pedal box.
17.Release mat from underside of fascia to gain
access to brake pedal box mounting bolts.
18.Remove 6 bolts securing brake pedal box to
bulkhead.
19.Disconnect 2 brake pedal switch Lucars.
20.Carefully remove brake pedal box assembly and
collect gasket.
21.Remove bolt securing column upper tie bar to
column.
22.Remove 2 bolts securing upper column to lower
mounting bracket....

STEERING
3
REPAIR Refit
NOTE: The steering column is a
non-servicable component and can only
be serviced as a complete assembly.
29.Fit mounting bracket to column and manouvre
assembly into position.
NOTE: Ensure marks on upper and lower
columns are aligned.
30.Loosely fit bolts securing mounting bracket to
bulkhead.
31.Fit upper clamp and rubber packing to column.
32.Loosely fit bolts securing upper clamp to
mounting bracket.
33.Loosely fit bolts securing 2 halves of upper
clamp.
34.Loosely fit bolts...

57STEERING
4
REPAIR 

60 - FRONT SUSPENSION
CONTENTS
Page
DESCRIPTION AND OPERATION
FRONT SUSPENSION - FROM 02MY 1................................................................
REPAIR
PANHARD ROD - FROM 02MY 1...........................................................................
BEARINGS - FRONT HUB 1................................................................................... 

FRONT SUSPENSION
1
DESCRIPTION AND OPERATION FRONT SUSPENSION - FROM 02MY
1.Bolts
2.Bushes
3.Panhard rod
Changes have been incorporated to improve the durability of the suspension. The current Panhard rods are
forged. New Panhard rods are introduced which are fabricated from tubular steel and are handed.
The rods are fitted with larger bushes which use M16 bolts in place of the M14 bolts. The torque for the new bolts
is raised to 230 Nm (170 lbf.ft).
The Panhard rod support brackets are now fabricated...