Land Rover Defender 1999 2002my Workshop Supplement Body Repair 2nd Edition Rover Manual

17EMISSION CONTROL
4
REPAIR 

18 - ENGINE MANAGEMENT SYSTEM
CONTENTS
Page
DESCRIPTION AND OPERATION
COMPONENT LOCATION 2...................................................................................
DESCRIPTION 5.....................................................................................................
ENGINE CONTROL MODULE (ECM) 6.................................................................
SENSOR - MASS AIR FLOW (MAF) 7....................................................................
SENSOR - AMBIENT AIR...

ENGINE MANAGEMENT SYSTEM
1
DESCRIPTION AND OPERATION This page is intentionally left blank 

18ENGINE MANAGEMENT SYSTEM
2
DESCRIPTION AND OPERATION COMPONENT LOCATION 

ENGINE MANAGEMENT SYSTEM
3
DESCRIPTION AND OPERATION 1.Mass Air Flow (MAF) sensor.
2.Engine Coolant Temperature (ECT) sensor.
3.Glow plugs.
4.Manifold Absolute Pressure (MAP) / Inlet Air Temperature (IAT) sensor.
5.Fuel pump relay.
6.Engine Control Module (ECM).
7.Air Conditioning (A/C) and cooling fan relay.
8.Fuel Temperature (FT) sensor.
9.Crankshaft Speed and Position (CKP) sensor.
10.Electronic Unit Injectors (EUI).
11.Ambient Air Pressure (AAP) sensor. 

18ENGINE MANAGEMENT SYSTEM
4
DESCRIPTION AND OPERATION Passenger Compartment
1.Brake pedal switch.
2.Clutch pedal switch.
3.Accelerator pedal switch.
4.Diagnostic connector. 

ENGINE MANAGEMENT SYSTEM
5
DESCRIPTION AND OPERATION DESCRIPTION
General
An engine control module (ECM) controls the five cylinder direct injection diesel engine, and works on the drive by
wire principal. This means there is no throttle cable, the ECM controls the drivers needs via a signal from the
Throttle Position (TP) sensor on the throttle pedal.
The ECM is a full authoritative diesel specific microprocessor that also incorporates features for air conditioning. In
addition, the ECM supplies output...

18ENGINE MANAGEMENT SYSTEM
6
DESCRIPTION AND OPERATION ENGINE CONTROL MODULE (ECM)
The ECM is made from aluminium alloy and is located under the RH front seat. The ECM has an interface of 72
pins via two connectors providing both input information and output control. The ECM receives information from
the sensors to inform it of the current state of the engine. The ECM then refers this information to stored values in
its memory and makes any changes to the operation of the engine necessary via the...

ENGINE MANAGEMENT SYSTEM
7
DESCRIPTION AND OPERATION SENSOR - MASS AIR FLOW (MAF)
The MAF sensor is located in the intake system between the air filter housing and the turbocharger. The ECM
uses the information generated by the MAF sensor to control exhaust gas recirculation (EGR).
The MAF sensor works on the hot film principal. The MAF sensor has 2 sensing elements contained within a film.
One element is controlled at ambient temperature e.g. 25°C (77°F) while the other is heated to 200°C (360°F)
above...