Kyocera FS 1350DN User Manual

							8-6Option
CompactFlash (CF) Card
The printer is equipped with a slot for a CF card with the maximum size 
of 256MB. A CF card is useful for storing fonts, macros, and overlays.
1Turn off the printer and disconnect the power cord and printer cable.
2Open the rear cover.
3Remove the screws and the optional interface slot cover.
4Insert the CF Card.
5Secure the optional interface slot cover with the screws removed in 
step 3.
6Connect the power cord and printer cable and turn on the printer. 
USB Flash Memory
See your dealer for purchasing information of this optional device that 
are best suited for use with this printer.
CAUTION  Before inserting a CF card in the printer, make 
sure that the printer is switched off.
Downloaded From ManualsPrinter.com Manuals 
						

							Computer Interface9-1
9 Computer Interface
This chapter contains explanations on the following topics:
General Information 9-2
USB Interface 9-2
Network Interface 9-3
Downloaded From ManualsPrinter.com Manuals 
						

							9-2Computer Interface
General Information
This chapter explains the connector specifications of USB and network 
interfaces.
USB Interface
This printer supports the Hi-Speed USB. USB (Universal Serial Bus) 
interface specifications are as follows.
Specifications
Basic specification
Complies with the Universal Serial Bus Specification Revision 2.0.
Connectors
Printer: B-type receptacle (female) with upstream port
Cable: B-type plug (male)
Cable
Use a shielded cable that complies with USB 2.0 (Hi-Speed USB) and 
not longer than 5 meters (16 feet).
Transfer Mode
High speed (480 Mbps maximum)
Full-Speed (12 Mbps maximum)
Power Control
Self-power device
Interface Signals
USB Connector Pin Assignment
PinSignalDescription
1 Vbus Power supply (+5 V)
2 D- Data transmission 
3 D+ Data transmission 
4 GND Signal ground
Shell — Shield
Downloaded From ManualsPrinter.com Manuals 
						

							Computer Interface9-3
Network Interface
Features
Automatic IP address resolution
This feature is compatible with the DHCP/DHCPv6 protocol and allows 
the printer to automatically receive IP addresses from the 
DHCP/DHCPv6 server. 
Management using Web browsers
HTTP pages are incorporated in to the interface, so that a web browser 
can be used to monitor and change a range of settings. The settings can 
be password-protected.
Support for a range of protocols
The SMTP, POP3, SSL, SNMP, IPv6 and NetBIOS over TCP/IP 
protocols are supported for easier printer management and more robust 
security.
Support for IEEE 802.1x
The interface supports EAP-TLS and PEAP authentication.
Supports IPv6
Supports IPv6, which is based on IPv4 with improvements, such as 
increased manageable address space, additional security functions and 
priority based data transmission.
Supports IPSec
Supports IPSec, the security protocol that authenticates and encrypts in 
the network layer (IP layer).
Specifications
Connector
10 Base-T/100 Base-TX
Operating Systems
Windows 2000/XP/Vista/Server2003, MacOS 10.x
Network protocols
•IPv6: HTTP, LPD, FTP, IPP, RawPort, ICMPv6, LLTD, SNTP, 
DHCPv6, SMTP, POP3, DNS, SNMPv1/v2c/v3, WSD
•IPv4: HTTP, HTTPS, LPD, FTP, IPP, RawPort, ICMP, DHCP, SMTP, 
POP3, SNTP, DNS, WINS, NetBIOS over TCP/IP, SNMPv1/v2c/v3, 
Apple Bonjour Compatible, IPPS, LLTD, WSD
•Etc.: IPX/SPX, NetWare (NDS/Bindery), AppleTalk, NetBEUI
Security Protocols
SSL/TLS (HTTPS, IPPS), SNMPv3, EAP-TLS, PEAP, AH, ESP
Operation Environment
10 to 35 °C (50 to 95 °F), 20-80% RH (condensation-free)
Downloaded From ManualsPrinter.com Manuals 
						

							9-4Computer Interface
EMI Countermeasures
VCCI Class B, FCC Class B (U.S.), CE (Europe)
IMPORTANTWhen IPv6 functions are used, the devices used on the 
network (routers, PCs, etc) must support IPv6.
Downloaded From ManualsPrinter.com Manuals 
						

							Appendix10-1
10Appendix
This section lists the following information of this printer.
Specifications 10-2
Environmental Standard Requirements 10-4
Downloaded From ManualsPrinter.com Manuals 
						

							10-2Appendix
Specifications
NoteThese specifications are subject to change without notice.
ItemDescription
Type Desktop
Printing Method Electrophotography, laser scan
Paper Weight Cassette 60 to 120 g/m² (Duplex: 60 to 105 g/m²)
MP Tray 60 to 220 g/m²
Paper Type Cassette Plain, Preprinted, Bond, Recycled, Rough, Letterhead, Color (Colour), 
Prepunched, High Quality, Custom 1 to 8 
MP Tray Plain, Transparency, Preprinted, Labels, Bond, Recycled, Rough, Vellum, 
Letterhead, Color (Colour), Prepunched, Envelope, Cardstock, Thick paper, 
High Quality, Custom 1 to 8
Paper Size Cassette A4, JIS B5, A5, Folio, Legal, Letter, Oficio II, Statement, Executive, A6, B6, ISO 
B5, Envelope C5, 16K, Custom (105 × 148 to 216 × 356mm (4-1/8 × 5-13/16 to 
8-1/2 × 14 inches)
Paper Feeder A4, JIS B5, A5, Folio, Legal, Letter, Oficio II, Executive, B6, ISO B5, Envelope 
C5, 16K, Custom (148 × 210 to 216 × 356mm (5-13/16 × 8-5/16 to 8-1/2 × 14 
inches)
MP Tray A4, JIS B5, A5, Folio, Legal, Letter, Oficio II, Statement, Executive, A6, B6, ISO 
B5, Envelope C5, Envelope #10, Envelope #9, Envelope #6-3/4, Envelope 
Monarch, Envelope DL, Hagaki, Ofuku Hagaki, 16K, Yokei 2, Yokei 4, Custom 
(70 × 148 to 216 × 356mm (2-13/16 × 5-13/16 to 8-1/2 × 14 inches)
Magnification ratio 25 to 400 %, 1 % increments
Printing Speed Simplex A4/Letter: 30 ppm/32 ppm
A5: 17 ppm
Duplex A4/Letter: 17 ppm
First Print Time (A4, feed from 
Cassette)6 seconds or less
Warm-up Time 
(22°C/71.6°F, 
60 %RH)Power on 20 seconds or less (120 V AC), 19 seconds or less (220 to 240 V AC)
Sleep 15 seconds or less (120 V AC), 14 seconds or less (220 to 240 V AC)
Paper Capacity Cassette (1 to 3) 250 sheets (80 g/m², 11 × 8 1/2/A4 or smaller)
MP Tray 50 sheets (80 g/m², 11 × 8 1/2/A4 or smaller)
Output Tray 
CapacitySimplex 250 sheets (80 g/m²)
Duplex 200 sheets (80 g/m²)
Continuous printing 1 to 999 sheets
Resolution Fine 1200 mode, Fast 1200 mode, 600 dpi, 300 dpi
Operating 
EnvironmentTemperature 10 to 32.5°C/50 to 90.5°F
Humidity 15 to 80 %
Altitude 2,500 m/8,202 ft maximum
Brightness 1,500 lux maximum
Controller PowerPC 440F5/500 MHz
Downloaded From ManualsPrinter.com Manuals 
						

							Appendix10-3
Supported OS Windows 2000 Service Pack 2 or later, Windows Server 2003, Windows XP, 
Windows Vista, Mac OS X 10.x
Interface Hi-Speed USB: 1
Network: 1 (10BASE-T/100BASE-TX)
KUIO-W slot: 1
PDL PRESCRIBE
Emulation PCL 6, KPDL, KPDL (AUTO), Line Printer, IBM Proprinter, DIABLO 630, 
EPSON LQ-850
Memory
Standard128 MB
Maximum1152 MB
Dimension (W × D × H) 375 × 393 × 267 mm
14 3/4 × 15 1/2 × 10 1/2
Weight (without toner container) 12 kg/26.5 lb
Power Requirements 120 V AC, 60 Hz, 7.5 A/220 to 240 V AC, 50/60 Hz, 3.9 A
Power 
Consumption
Maximum910 W (U.S.A./Canada), 967 W (European countries)
During printing532 W (U.S.A./Canada), 484 W (European countries)
During standby11 W (U.S.A./Canada), 12 W (European countries) when EcoFuser is On.
67 W (U.S.A./Canada), 75 W (European countries) when EcoFuser is Off.
Sleep mode6.9 W (U.S.A./Canada), 7.1 W (European countries)
Power off 0 W
Options Expanded memory, Paper Feeder (250-sheet × 2)
ItemDescription
Downloaded From ManualsPrinter.com Manuals 
						

							10-4Appendix
Environmental Standard Requirements
This machine conforms to the following environmental standard 
requirements.
•Time for switching to Sleep mode (default): 15 minutes
•Duplex Printing: Standard Equipment
•Durable paper for feeding: Paper made of 100 % recycled paper
NoteContact your dealer or service representative for 
recommended paper types.
Downloaded From ManualsPrinter.com Manuals 
						

							Glossary-1
Glossar y
Additional memory
An additional memory (optional) is used for increasing the memory 
capacity of this machine. For DIMM that can be used in this machine, 
contact your service technician.
AppleTalk
AppleTalk offers file sharing and printer sharing and it also enables you 
to utilize application software that is on another computer on the same 
AppleTalk network.
Default Gateway
This indicates the device, such as a computer or router, that serves as 
the entrance/exit (gateway) for accessing computers outside of the 
network that you are on. When no specific gateway is designated for a 
destination IP address, data is sent to the host that is designated as the 
Default Gateway.
DHCP (Dynamic Host Configuration Protocol)
This is a protocol that automatically resolves the IP address, Subnet 
Mask and Gateway address on a TCP/IP network. Use of DHCP 
minimizes the load of network administration, especially on network 
environments with a large number of client computers where it is not 
specifically necessary to assign a separate IP address to each client, 
including printers.
dpi (dots per inch)
This indicates the number of dots printed per inch (25.4 mm) as a unit for 
expressing resolution.
EcoPrint
This is a printing mode that reduces toner consumption. Pages printed in 
the EcoPrint mode are lighter than pages printed in the normal mode.
Emulation
This refers to emulation of other manufacturers printers. The printer 
emulates operation of the following printers: PCL 6, KPDL, KPDL 
(AUTO), Line Printer, IBM Proprinter, DIABLO 630 and EPSON LQ-850.
Form Feed Timeout
While data is being sent to a printer, some pauses may occur. At this 
time, the printer waits for the next data without making a page break. 
Form feed timeout is a function to wait only a preset amount of time 
before it executes an automatic page break. After the waiting period 
begins, once the designated amount of time is exceeded, the printer will 
automatically process the currently received data and print it out. If the 
machine has received no print data for the last page, the printer ends 
processing of that job without outputting paper.
Downloaded From ManualsPrinter.com Manuals