Inter-Tel Axxess System Manual Issue 4 Addendum

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
##Page 1 of 73Document Part No. 550.8015
ADDENDUM TO ISSUE 4 OF THE
INTER-TEL AXXESS SYSTEM MANUAL
For Software Part Numbers: 827.8658, 827.8659, 827.8660, 827.8661, and 827.8662
This addendum describes feature, programming, and hardware changes that apply when theAXXESS System is
installed with the version 4.3 software part numbers listed above. It also includes changes and corrections to Issue 4
of theAXXESS Installation and Field...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 2 of 73 ·
New T1 Card (T1C) Revision Level Changes (see
page 37)
·
T1 Gain Control (TGC) Daughter Card (see page
37)
·
DKSC-16 Extended Loop Length Modification
(see page 38)
·
New Voice Processing Card (VPC) Models (see
page 38)
·
CPU020/PCM Card Software Installation Infor-
mation (see page 38)
·
New FCC Part 68 PBX Rating (see page 38)
·
New Fax Card Models (see page 38)
·
New PC Motherboard (see page 41)
·
Config.sys File Change (see page...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 3 of 73
16-Circuit Single-Line Card (SLC-16) and
Lamp Options Card (LOC-16)
16-Port Single-Line Card (SLC-16)
The SLC-16 can support up to 16 on-premises AC-ring-
ing single-line devices. Like the 8-circuit SLC, it does
not support off-premises stations and does not have
DID capability.
An SLC-16 cannot be installed in a card slot that is pro-
grammed for an SLC. The ports must be specifically
programmed for an SLC-16. However, if port program-...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 4 of 73
FIGURE 1. SLC-16 BLOCK CABLE TERMINATIONS
GY
RBK 1.1 1.1
1.2
BL/W RING W/BL TIP
TIP
RING
W/BL
BL/W
W/O
O/W
W/G
G/W
Y/G
G/Y
Y/BR
SINGLE-
LINE
CARD
AMPHENOL-
TYPE
CONNECTORSLC-16
MODULAR
JACK
ASSEMBLY
TO SINGLE-
LINE SET OR
PLAYBACK
DEVICE
66M1-50-TYPE
BLOCK
(PART OF MDF)
TIP
RING
1.3 TIP
RING
GND (BLACK)
–48V EXT ((RED)1.3 1.2
NOTE:For simplicity, this figure shows single-line sets and playback devices being installed using one-
pair cable...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 5 of 73
FIGURE 2. SLC-16 CABLE TERMINATIONS ON THE SLC-16 STATION BLOCK
AMPHENOL
NO.CABLE
PAIRSLC-16
26W–BLTIP
1BL–WRING
27W–OTIP
2O–WRING
28W–GTIP
3G–WRING
29W–BRTIP
4BR–WRING
30W–STIP
5S–WRING
31R–BLTIP
6BL–RRING
32R–OTIP
7O–RRING
33R–GTIP
8G–RRING
34R–BRTIP
9BR–RRING
35R–STIP
10S–RRING
36BK–BLTIP
11BL–BKRING
37BK–OTIP
12O–BKRING
38BK–GTIP
13G–BKRING
39BK–BRTIP
14BR–BKRING
40BK–STIP
15S–BKRING
41Y–BLTIP
16BL–YRING
42Y–ONOT USED
17O–YNOT USED...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 6 of 73
Loop/Ground Start Card (LGC) and
LGC Daughter Card (LGC-D)
Modification
Under certain conditions, previous versions of the LGC
(part no. 550.2309) and the LGC-D (part no. 550.2310)
were not able to always properly detect the“ground
start” signal provided by the central office (CO). A
modification to the LGC and LGC-D has been imple-
mented to correct this problem.
More specifically, the previous versions of the LGC
and LGC-D did not...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 7 of 73
Call Routing to Public Network
This feature changes the AXXESS system in the fol-
lowing ways:
·
Call Routing Tables can be programmed to route
outside calls to outgoing trunks, using Automatic
Route Selection (ARS) or a trunk group. However,
Primary Rate trunks can be used only through
ARS; individual B-channel trunks or trunk groups
containing B-channel trunks will not function
properly with this feature.
·
The system provides a means...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 8 of 73
NOW YOU CAN CHOOSE ARS,
TRUNKS, OR TRUNK GROUPS
NOW YOU CAN CHOOSE ARS,
TRUNKS, OR TRUNK GROUPS 

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 9 of 73 SMDR and Message Print Changes ToSupport
Call Routing To The Public Network
Several changes have been made to the Station Mes-
sage Detail Recording (SMDR) feature to support Call
Routing to the Public Network.
You can choose which trunks to include in the SMDR
report. This is done through the SMDR Programming
screen (shown below), just as it was for including sta-tions. A new Trunks command button has been added
that displays a selection...

ADDENDUM TO ISSUE 4 OF THE AXXESS MANUAL OCTOBER 1997
Page 10 of 73
Station Password
A station password has been added to the system. This
password is used for the new Remote Programming
feature.
The station password can be up to 8 digits in length.
The default password is the extension number of the
station. The password can be changed by entering the
Program Station Password feature code at the station or
when using the new Remote Programming feature (de-
scribed in detail on page 12). It can also be...