InFocus Projector IN5132 User Manual

9
ENGLISH
Tur ning on the power
1. WRWKH
projector and the outlet.
2. Make sure that the POWER
 indicator is 
steady orange. Then remove the lens 
cover.
3. Press the STANDBY/ON
 button on 
the projector or the ON
 button on the 
remote control.
The projection lamp will light up and the 
POWER
 indicator will begin blinking green. 
When the power is completely on, the 
indicator will stop blinking and become 
steady green.
WARNING
  
y$VWURQJOLJKWLVHPLWWHGZKHQWKHSURMHFWRU

10
Adjusting the projector’s elevator
When the projector is placed on a slightly uneven surface, 
use the elevator feet to place the projector horizontally. 
Using the feet can also tilt the projector in order to project 
at a suitable angle (up to 9 degrees) to the screen.
This projector has 2 elevator feet and 2 elevator buttons. 
An elevator foot is adjustable when you push the elevator 
button which is on the same side.
1. 
Holding the projector, push the elevator buttons to 
loosen the elevator...

11
ENGLISH
Displaying the picture
1. Activate your signal source. Turn the signal 
source on, and send the signal to the projector.
2. Press the INPUT
 button on the projector.  
Each time you press the button, the projector 
switches its input port in turn. 
You can also use the remote control to select 
an input signal. Press any of the buttons from 
COMPUTER 1
 / 2
, LAN
, USB TYPE A
 / B
, 
HDMI 1
 / 2
, COMPONENT
, S-VIDEO
 or 
VIDEO
 to select the input signal from each 
port.
3. Use the VOL + / -...

12
Tur ning off  the power
1. Press the STANDBY/ON
 button on the 
projector or the STANDBY
 button on 
the remote control. 
7KHPHVVDJH

13
ENGLISH
Replacing the lamp
$ODPSKDVD

14
 HIGH VOLTAGE HIGH TEMPERATURE HIGH PRESSURE
WARNING
  
yThe projector uses a high-pressure mercury glass lamp. The 
lamp may burn out or rupture with a loud bang if the lamp is jolted or scratched, 
handled while hot, or worn over time. Note that each lamp has a different 
lifetime, and some may rupture or burn out soon after you start using them. In 
DVVWRÀ\LQWRWKHODPS
SDUWLFOHVRI
glass to escape from the projector’s vent holes.

yAbout disposal of a lamp: This product contains a mercury...

15
ENGLISH
Please check and cleDQWKHDLU

16
NOTE  ODFHG
WKHDLU¿OWHUWRHQVXUHSURSHUDLU¿OWHUPHVVDJHV

17
ENGLISH
Item6SHFL¿FDWLRQ
Product name Liquid crystal projector
Liquid Crystal 
Panel
IN5132, IN5142:  
786,432 pixels (1024 horizontal x 768 vertical)
IN5134, IN5134a, IN5144, IN5144a:  
1,024,000 pixels (1280 horizontal x 800 vertical)
IN5135, IN5145:  
2,304,000 pixels (1920 horizontal x 1200 vertical)
LampIN5132, IN5134, IN5134a, IN5135: 245W UHP
IN5142, IN5144, IN5144a, IN5145: 330W UHP
Speaker8 W x2
Power supply, 
Rated current
IN5132, IN5134, IN5134a, IN5135: 
AC100-120 V: 3.8 A, AC220-240 V:...

18
Item6SHFL¿FDWLRQ
Ports
COMPUTER IN1  ..........................  D-sub 15 pin mini jack x1
COMPUTER IN2 (H, V, G/Y, B/Cb/Pb, R/Cr/Pr)  ...  BNC jack x5
HDMI 1  ...................................................  HDMI connector x1
HDMI 2  ...................................................  HDMI connector x1
MONITOR OUT  ............................. D-sub 15 pin mini jack x1
COMPONENT (Y, Cb/Pb, Cr/Pr)  .......................  RCA jack x3
S-VIDEO  .............................................  Mini...