InFocus Projector IN5132 User Manual

11 7
• When the inside of the projector becomes overheated, the projector  
will automatically shut down (for safety purposes) and the indicator lamps may 
also be turned off. In this case, disconnect the power cord, and wait at least 45 
minutes. After the projector has cooled down sufficiently, verify the lamp and 
lamp cover are securely attached, and then turn the power on again.
NOTE
For the SECURITY indicator, see SECURITY INDICATOR in the SECURITY 
menu (93). 
For the SHUTTER indicator, see the...

11 8
Troubleshooting
Problems that can be easily mistaken for machine defects
Before assuming that the projector needs repair, review the following 
troubleshooting tips:
SituationTroubleshooting tipsReference page
Power does not come on.
The electrical power cord is unplugged.
Connect the power cord correctly.16
The main power source was interrupted (for example   
a power outage (blackout), etc.).
Disconnect the power plug from the power outlet, and 
allow the projector to cool down at least 10...

11 9
Troubleshooting
Problems that can be easily mistaken for machine defects (continued)
SituationTroubleshooting tipsReference page
No sounds or pictures are outputted. (continued)
The projector does not recognize the USB storage 
device inserted into USB TYPE A ports. 
Select REMOVE USB and then remove the USB storage 
device. Insert it back into the port again.  
Before removing the USB storage device, be sure to use 
the REMOVE USB function on the Thumbnail screen, 
which appears when the USB TYPE A...

120
SituationTroubleshooting tipsReference page
The remote control does not work.
The batteries in the remote control are almost dead.
Replace the batteries.17
The ID numbers set in the projector and the remote 
control are different.
Press the ID button with the same ID number as the 
projector, then perform the desired operation. The ID 
number associated with the projector will display for 
3 seconds when any of the ID buttons on the remote 
control are pressed.
17
Video screendisplay freezes.
The...

121
SituationTroubleshooting tipsReference page
Some kind of image degradation such as flickering or stripes appear on screen. 
When the projector is operating in Eco mode, 
flickering may appear on screen.
Set ECO MODE to NORMAL, and set AUTO ECO 
MODE to OFF, in the SETUP menu.
55
The OVER SCAN ratio is too big.
Adjust OVER SCAN smaller in the IMAGE menu.48
Excessive VIDEO NR.
Change the VIDEO NR setting in the INPUT menu.50
The FRAME LOCK function cannot work with the 
current input signal.
Set FRAME...

122
• Although bright or dark spots may appear on the screen, this is a 
unique characteristic of liquid crystal displays, and it does not constitute or 
imply a machine defect.
NOTE
SituationTroubleshooting tipsReference 
page
NETWORK BRIDGE function does not work
The NETWORK BRIDGE function is turned off.
Set COMMUNICATION TYPE to NETWORK BRIDGE in 
the OPTION - SERVICE - COMMUNICATION menu.72
Schedule function does not work
The SAVING function is working.
Set STANDBY MODE to NORMAL in the SETUP...

123
Specifications
Specifications
See Specifications in the User’s Manual (concise).
End User License Agreement for the Projector Software
• The projector software contains several independent software modules and 
there are copyright or/and third party copyrights for each of these software 
modules.
• Be sure to read the “End User License Agreement for the Projector Software”.